2016 Citroen C4 PICASSO lamps

265
C4-Picasso-II_en_Chap07_info-pratiques_ed01-2016
Exiting economy mode
These functions are reactivated automatically
next  time   the   vehicle   is   driven.
In order to restore the use of these functions
immediately,
  start   the   engine   and   let   it   run:
-

f
or less than ten minutes, to use the
equipment
  for   approximately   five   minutes,
-

f
or more than ten minutes, to use the
equipment
  for   up   to   approximately  
t

hirty minutes.
Let
  the   engine   run   for   the   duration   specified   to  
e

nsure   that   the   battery   charge   is   sufficient.
Do not repeatedly and continuously restart the
engine
  in   order   to   charge   the   battery.
A
  flat   battery   prevents   the   engine   from   starting.
For more information on the 12 V batter y , refer
to
  the   corresponding   section.
Load reduction mode
System which manages the use of certain functions   according   to   the   level   of   charge  
r

emaining   in   the   battery.
When
  the   vehicle   is   being   driven,   the   load  
r

eduction function temporarily deactivates
certain
  functions,   such   as   the   air   conditioning,  
t

he   heated   rear   screen...
The deactivated functions are reactivated
automatically
  as   soon   as   conditions   permit.
Energy economy mode
Switching to economy
mode
A message appears in the instrument panel s
creen   indicating   that   the   vehicle   has   switched  
t

o economy mode and the active functions are
put
  on   standby.
If
  a   telephone   call   is   being   made   at   this   time,   it  
w

ill be maintained for around 10 minutes with
the Bluetooth hands-free system of your audio
system. System   which   manages   the   duration   of   use   of   certain   functions   to   conserve   a   sufficient   level   of  
c

harge   in   the   battery.
After   the   engine   has   stopped,   you   can   still   use   functions   such   as   the   audio   and   telematics  
s

ystem, windscreen   wipers,   dipped   beam   headlamps, courtesy   lamps,   etc.   for   a   maximum  
c

ombined   duration   of   about   forty   minutes.
7
Practical information

283
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Warning triangle
This safety device should be used in addition to
the  hazard   warning   lamps.
Its
  presence   in   the   vehicle   is   mandatory.
A
  location   for   stowing   the   warning   triangle   is  
p

rovided   in   the   tailgate   interior   trim.
Placing the triangle in the road
F Place  the   triangle   behind   the   vehicle,   as  r
equired   by   the   legislation   in   force   in   your  
c

o unt r y.Before
  leaving   your   vehicle   to   set   up  
a

nd   install   the   triangle,   switch   on   the  
h

azard   warning   lamps   and   put   on   your  
h

igh   visibility   vest.
Refer to the instructions provided by the
supplier   on   folding   and   unfolding   the  
t

riangle.
8
In the event of a breakdown

301
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Changing a bulb
For H7 type bulbs with lugs... take care to observe their correct installation
so
  as   to   ensure   the   best   lighting  
p

erformance.
Risk of electrocution
Xenon bulbs (D5S-25W) must be
replaced by a CITROËN dealer or a
qualified
 w
orkshop.
Front lamps
Model with xenon headlamps
1. Directional dipped beam headlamps (D5S-25W).
2.
 M

ain   beam   headlamps   (H7-55W).
3.
 D

aytime   running   lamps   /   sidelamps
 (

6   light   emitting   diodes   -   LEDs).
4.
D

irection indicators
 (

6   light   emittng   diodes   -   LEDs).
5.
 F

ront   foglamps   (H11-55W).
Model with halogen headlamps
1. Dipped  beam   headlamps   (H7-55W).
2. M ain   beam   headlamps   (H7-55W).
3.
 D

aytime
 r
unning
 lam
ps/sidelamps
 (

4   light   emitting   diodes   -   LEDs).
4.
 D

irection   indicators   (PW Y24W).
5.
 F

oglamps
 (
H11-55W). In
  some   weather   conditions   (e.g.   low  
t

emperature or humidity), the presence
of   misting   on   the   internal   sur face   of   the  
g

lass   of   the   headlamps   and   rear   lamps  
i

s   normal;   it   disappears   after   the   lamps  
h

ave   been   on   for   a   few   minutes.
Light- emitting diodes - LEDs
For replacement, contact a CITROËN dealer or
qualified w
orkshop.
8
In the event of a breakdown

302
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Directional dipped beam
headlamps (xenon model)Main beam headlamps (xenon model)
F Remove the protective plastic cover by pulling   the   tab.
F
 
P
ush   the   connector.
F
 
R
emove   the   bulb   and   change   it.
For reassembly, carry out these operations in
reverse
 o

rder.
D5S
 
xenon
 
bulbs
 
must
 
be
 
changed
 
b

y a CITROËN dealer or a qualified
workshop,
 
as
 
there
 
is
 
a
 
risk
 
of
 
el

ectrocution.
In the event of failure of one
of the D5S bulbs, it is recommended
that the bulb on the other side be
changed
 
at
 
the
 
same
 
time.
The headlamps have polycarbonate
lenses
 
with
 
a
 
protective
 
coating:
F

d

o not clean them using a dr y
or abrasive cloth, nor with a
detergent or solvent product,
F
 
u

se
 
a
 
sponge
 
and
 
soapy
 
water
 
or
 
a
 
p

H neutral product,
F
 
w

hen
 
using
 
a
 
high
 
pressure
 
washer
 
o

n
 
persistent
 
marks,
 
do
 
not
 
keep
 
t

he lance directed towards the
lamps
 
or
 
their
 
edges
 
for
 
too
 
long,
 
s

o
 
as
 
not
 
to
 
damage
 
their
 
protective
 
c

oating
 a

nd
 sea

ls.
Changing
 
a
 
bulb
 
should
 
only
 
be
 
done
 
a

fter the headlamp has been switched
off
 
for
 
several
 
minutes
 
(risk
 
of
 
serious
 
b

urns).
F

D

o not touch the bulb directly with
your
 
fingers,
 
use
 
a
 
lint-free
 
cloth.
It is imperative to use only anti-
ultraviolet (UV) type bulbs to avoid
damaging
 t

he
 h

eadlamp.
Always replace a failed bulb with a
new bulb with the same type and
specification.
In the event of a breakdown

303
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Dipped beam headlamps
(halogen model)
F Remove the protective plastic cover by pulling   the   tab.
F
 
P
ush   the   connector.
F
 
R
emove   the   bulb   and   change   it.
For reassembly, carry out these operations in
reverse
 o

rder.
Main beam headlamps
(halogen model)
F Turn the protective plastic cover to remove   it.
F
 
D
isconnect   the   connector.
F
 
R
elease   the   clips.
F
 
R
emove   the   bulb   and   change   it.
For reassembly, carry out these operations in
reverse
 o

rder.
8
In the event of a breakdown

304
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
The direction indicator bulb is located below
the  front   lamp.
F

T
urn the bulb holder a quarter turn anti-
clockwise.
F
 
R
emove   the   bulb   holder.
F
 
C
hange   the   failed   bulb.
For reassembly, carry out these operations in
reverse
 o

rder.
Direction indicators Front foglamps
F Unclip  the   finisher   by   pulling   at   the   top.
F  R emove   the   two   screws   to   remove   the   unit.
F
 
T
urn   the   bulb   holder   a   quarter   turn.
F
 
R
emove   the   bulb   holder.
F
 
C
hange   the   failed   bulb.
For reassembly, carry out these operations in
reverse
  order,   pressing   on   the   finisher   to   refit   it.
Faster
 
flashing
 
of
 
a
 
direction
 
indicator
 
w

arning
 
lamp
 
(left
 
or
 
right)
 
indicates
 
a
 
f

ailed
 
bulb
 
on
 
that
 
side.
Direction indicators (light
emitting diodes - LED)
For the replacement of this type of lamp,
contact a CITROËN dealer or a qualified
workshop.
In the event of a breakdown

305
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
You should contact a CITROËN dealer or a
qualified  workshop   for   the   replacement   of   the  
l

ight-emitting   diode   -   LED.
Door mirror spotlamps
Integrated direction indicator
side repeaters
You should contact a CITROËN dealer or a
qualified  workshop   for   the   replacement   of   these  
b

ulbs. 1.
D

irection indicators (PY21W amber)
.
2.
 S
idelamps   /   foglamps   (P21/5W)
.
Rear lamps
Light-emitting diodes -
LEDs
For replacement, contact a CITROËN
dealer
  or   qualified   workshop.
3.
 B

rake
 
lamps
 
/
 
sidelamps
 
(light-emitting
 d
iodes
 
-
 
LEDs).
4. R
eversing
 
lamps
 
(W16W).
5.
 D

irection
 
indicators
 
(PY21W).
Model with LED lamps
3. Sidelamps ( 5W5).
4. B rake   lamps   (P21/ W).
5.
 D

irection   indicators   (W Y16W).
6.
 R

eversing   lamps   (W16W).
Model with conventional bulb lamps
8
In the event of a breakdown

306
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Lamps on the tailgate
Contact a CITROËN dealer or a
qualified  workshop   for   the   replacement  
o

f   reversing   lamp   and   direction   indicator  
b

ulbs.
Identify
 
the
 
failed
 
bulb.
F
 
O

pen
 
the
 
boot.
F
 
R

emove
 
the
 
access
 
cover.
F
 
R

emove
 
the
 
three
 
lamp
 
fixing
 
screws
 
A
.
F
 
D

isconnect
 
the
 
lamp
 
connector.
F

C

arefully remove the lamp from the outside
by
 
pressing
 
the
 
retaining
 
clip
 
B
.
F

T

urn the bulb holder a quarter of a turn
anti-clockwise   and   pull   the   bulb   out.
F
 
C

hange   the   bulb.
For reassembly, carry out these operations in
reverse
 o
rder.
Model with LED lamps
Model with conventional bulb lamps
In the event of a breakdown