2016 Citroen BERLINGO MULTISPACE roof

98
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
MODUTOP ROOF
The multifunction roof extends the overhead
  storage   unit.   It   consists   of  
the

  following   components:
Storage compartments
Storage compartments are provided on  each   side   of   the   roof.  The   maximum  
authorised

  load   is   6   kg.
The translucent base assists with
finding
  objects   stored   inside.
Do
  not   store   objects   which   could  
present

  a   risk   to   the   occupants.
Courtesy lamp
The operation of the courtesy lamp is identical  to   that   of   the   front   courtesy   lamp.
Refer to chapter 4 "Practical
information",
  "Courtesy   lamps"  
section.
Practical information

 99
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
From insideFrom outside
Rear box
This roof box can be accessed from the
  rear   seats   and   the   boot.
From
  the   rear   seats,   slide   the   flaps   to  
open.
Vents
a 3-position control allows you to
adjust   the   air   flow   through   the   vents.
The
  vents   are   also   fitted   with   a   scented  
air

  freshener.
From
 
the
 
boot,
 
place
 
your
 
thumb
 
on
 the recess then pull the handle to
open.
Open
 
carefully
 
to
 
prevent
 
objects
 
stored

 
in
 
this
 
interior
 
roof
 
box
 
from
 
fallin

g
 
out.
The
 
maximum
 
authorised
 
load
 
is
 
10
 
kg.
EASE OF USE and COMFORT
4
Practical information

100
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
SCENTED AIR FRESHENER
The scented air freshener diffuses
a fragrance in the passenger
compartment  from   the   roof   console  
vents.
Adjusting the flow
Turn the chromed button to adjust the diffusion:
-

to the left to decrease,
-

 
to
  the   right   to   increase.
To
  stop   the   diffusion,   turn   the   chromed  
button

  fully   to   the   left.
Removing the scented air
freshener
- Press the button down while turning
it a quarter of a turn to the left to
the  stop.
-
 
Remove
  the   scented   air   freshener  
from

  the   roof   console.
-
 
Replace
  the   cartridge.
Practical information

101
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
Replacing a cartridge
The scented air freshener refill consists of a cartridge B and its sealing case C.
-
 
Remove
  the   protective   film   D.
-

Place the head of the cartridge
B
on the button A of the scented air
freshener.
-
 
T
urn   it   a   quarter   of   a   turn   to   lock   it  
on

  the   button   and   remove   the   case.
-

Insert the scented air freshener in
its

  location.
You can change the cartridges at any
time
  and   store   cartridges   which   have  
already been started in their original
case.
The scented air freshener button

A is
independent
  of   the   cartridge.
The cartridges are supplied without the
button A.
Inserting the scented air
freshener
After fitting or changing the cartridge:
-  
Put
  the   scented   air   freshener   back  
in

  place   in   its   location.
-

T
urn it a quarter of a turn to the
right.
Good practice
as a safety precaution, only use the
cartridges   provided   for   this   purpose.  
Do

  not   dismantle   the   cartridges.
k

eep the cartridge sealing cases
which
  are   used   as   packaging   when   the  
cartridges

  are   not   in   use.
Never
  try   to   refill   the   cartridges   with  
fragrances other than those available
from

  CITROËN   dealers.
k

eep out of reach of children and
animals.
 
A
void   contact   with   the   skin  
and

  eyes.   If   swallowed,   consult   a  
doctor

  and   show   him   the   packaging   or  
product

  label.
The scented air freshener button A can
only
 
be
 
fixed
 
on
 
the
 
multifunction
 
roof
 
console

 
with
 
a
 
cartridge.
Therefore, always retain button A and
a
 
cartridge.
The
 
cartridges
 
are
 
available
 
from
 
CITROËN

 
dealers.
EaSE oF USE and CoMFoRT
4
Practical information

102
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
MODUTOP ROOF BARS
The maximum authorised weight on each
  roof   bar   is   35   kg. In
  all   cases,   the   load   must   rest   on  
the non-slip bands provided for this
purpose

  and   must   not   touch   the   roof   or  
the

  glazing   of   the   roof.
Recommendations for loading the
roof
This procedure requires the use of
a spanner supplied with the tools for
changing
  a   wheel.
These two longitudinal Modutop roof
bars   can   be   removed.
Chapter   9,   "Changing   a   wheel"  section.
-
 
Open
  the   protective   covers.
-
 
Slacken
  the   four   screws   using   the  
spanner

  and   remove   them.
-
 
T
urn   the   bars   90°   placing   the  
hollow

  parts   towards   the   front.
-
 
Refit
  the   the   4   screws   and   tighten  
them

  using   the   spanner.
-
 
Close
  the   protective   covers.
-

Use the strap passages
A only to
secure
  the   load   firmly.
Practical information

103
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
ExTERIOR ROOF BARS
If you install transverse bars on these bars, refer to the weight values\
indicated
by  the   manufacturer   but   do   not   exceed:   75   kg.
EaSE oF USE and CoMFoRT
4
Practical information

108
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
Storage flaps
Raise the corresponding flap.next to the boot sill, the recess is
intended to receive the roller tube
containing
  the   load   space   cover.
Seat belts
Ensure that the centre seat belt has
reeled in correctly to its carrier in the
roof.
Prevent
  the   row   3   seat   belt   buckles  
from

  knocking   by   raising   them   as   close  
as possible to the anchorages in the
roof.
The

  seat   belt   buckle   attachment   rings  
on

  each   side   of   the   boot   must   not   be  
used

  to   retain   loads.
Practical information

123
Berlingo-2-VP_en_Chap05_Securite_ed01-2016
Operation
When your vehicle is too close to or
approaches the vehicle ahead too
quickly  the   system   automatically  
applies

  the   brakes   to   avoid   a   collision.
You are then alerted by the display of a
message.
The
  brake   lamps   on   your   vehicle   come  
on

  to   warn   other   road   users.
The collision can be avoided
automatically
  if   the   difference   in  
speed between your vehicle and the
vehicle

  ahead   does   not   exceed   9   mph  
(15 km/h).
Above

  this   threshold,   the   system   will  
do what is possible to avoid or reduce
the accident by lowering the speed of
impact.
The

  automatic   braking   may   bring  
the

  vehicle   to   a   complete   stop   if   the  
situation

  requires   it.
In this case, the vehicle is held
stationary
  temporarily   (for   about  
1.5 seconds)

  to   allow   the   driver   to   take  
back

  control   by   pressing   the   brake  
pedal. The

  triggering   of   the   system   may  cause the engine to stall, unless
the driver depresses the clutch
pedal
  quickly   enough   during   automatic  
braking.
During

  automatic   braking,   the  
driver can always obtain a higher
rate of deceleration than that
controlled

  by   the   system,   by   pressing  
firmly

  on   the   brake   pedal.
After
  an   impact,   the   system   is  
automatically

  put   out   of   service:   it  
no

  longer   operates.
You
  must   go   to   a   CITROËN   dealer   or   a  
qualified

  workshop   to   have   the   system  
made

  operational   again.
Operating limits
The system only detects vehicles that are  stationary   or   moving   in   the   same  
direction

  as   your   vehicle.
It
  does   not   detect   small   vehicles  
(bicycles,

  motorcycles),  
pedestrians

  or   animals,   nor   non-
reflective
  stationary   objects.
The
  system   is   not   triggered   or   is  
interrupted

  if   the   driver:
-

accelerates strongly
-


or turns the steering wheel
suddenly

  (avoiding   manoeuvre).
In
  difficult   weather   conditions   (very  
heavy

  rain,   snow,   fog,   hail...),  
braking

  distances   increase,   which  
can

  reduce   the   ability   of   the   system   to  
avoid

  a   collision.
The
  driver   must   therefore   remain  
particularly

  vigilant.
Never
  leave   accumulations   of  
snow

  or   any   object   projecting  
above the bonnet or in front of
the

  roof:   this   might   fall   into   the   field   of  
vision of the sensor and generate a
detection.
driving safely
SaFETY
5