2016 Citroen BERLINGO MULTISPACE ESP

72
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
Good practice
For maximum cooling or heating of the passenger  compartment,   it   is   possible  
to exceed the value 15 by turning until
LO

  is   displayed   or   the   value   27   by  
turning

  until   HI   is   displayed.
o

n entering the vehicle, the inside
temperature
  may   be   much   colder  
(or
  warmer)   than   is   comfortable.  
There
 
is no advantage in changing the value
displayed

  in   order   to   quickly   reach   the  
level

  of   comfort   required.  
The
  system  
will

  use   its   maximum   performance   to  
reach

  the   comfort   value   set.
DIGITAL AIR CONDITIONING
Automatic operation
AUTO comfort programme
This
  is   the   normal   air   conditioning  
system

  operating   mode. Driver or passenger side comfort
value
The value indicated in the screen
corresponds
  to   a   level   of   comfort   and  
not

  a   temperature   in   degrees   Celsius  
or

  Fahrenheit.
Turn this control to the left
or to the right to decrease or
increase   the   value.  
A 
setting  
around the value 21 provides
optimum

  comfort.   However,  
depending

  on   your   requirements,   a  
setting

  between   18   and   24   is   usual.
d

o not cover the sunshine sensor
located
  on   the   dashboard.
Press this button, the AUTO
symbol
  is   displayed.
The
  system   controls   the  
distribution,

  the   flow   and   the  
intake

  of   air   to   guarantee  
comfort

  and   a   sufficient   circulation  
of

  air   in   the   passenger   compartment  
according

  to   the   comfort   value   set.   No  
further

  action   on   your   part   is   required.Air
  flow   will   increase   gradually   when  
the

engine is cold, to prevent excessive
distribution   of   cold   air.
For   your   comfort,   the   settings   are  
stored when the ignition is switched of

f
and   are   reinstated   the   next   time   the  
vehicle

  is   started.
The   automatic   function   will   no   longer  
be

  maintained   if   you   change   a   setting  
manually

  (AUTO   is   cleared).
SEPARATE SETTINGS FOR DRIVER AND
PASSENGER
Ventilation

74
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
Recommended settings for air conditioning
If I require... Air distribution TemperatureAir flowAir recirculation A/C
Heating -
Cooling
Demisting
Defrosting
With
  automatic   digital   air   conditioning,   operation   in   AUTO   mode   is   recommended,  
irrespective

  of   the   requirement.
Remember
  to   switch   it   off   when   the   ambient   air   suits   your   requirements.
Ventilation

108
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
Storage flaps
Raise the corresponding flap.next to the boot sill, the recess is
intended to receive the roller tube
containing
  the   load   space   cover.
Seat belts
Ensure that the centre seat belt has
reeled in correctly to its carrier in the
roof.
Prevent
  the   row   3   seat   belt   buckles  
from

  knocking   by   raising   them   as   close  
as possible to the anchorages in the
roof.
The

  seat   belt   buckle   attachment   rings  
on

  each   side   of   the   boot   must   not   be  
used

  to   retain   loads.
Practical information

111
Berlingo-2-VP_en_Chap04_Ergonomie_ed01-2016
Adjusting electric door mirrors
- Move the control to the right or to
the left to select the corresponding
mirror.
-

Move the control in all four
directions

  to   adjust.
-

Return the control to the central
position.
MIRRORS
Heated mirrors
Adjusting manual door mirrors
Forced folding
If the mirror casing has come out of its initial location, with the vehicle
stationary  reposition   the   mirror   casing  
manually

  or   use   the   electric   folding  
control.Press the heated rear screen
button.
Move the lever in all four directions to
adjust.
When

 
the
 
vehicle
 
is
 
parked,
 
the
 
door
 
mirrors

 
can
 
be
 
folded
 
back
 
manually.
The
 
mirrors
 
are
 
not
 
equipped
 
with
 
automatic

 
heating.
Electric folding / unfolding
The mirrors can be folded or unfolded electrically
  from   the   inside,   with   the  
vehicle

  parked   and   the   ignition   on:
-

Place the control in the central
position.
-

 
T
urn   the   control   downwards. The
  mirrors   that   have   electric   folding/
unfolding   can   be   heated.
EaSE oF USE and CoMFoRT
4
Mirrors and windows

11 6
Berlingo-2-VP_en_Chap05_Securite_ed01-2016
Activation / DeactivationMalfunction
In the event of a malfunction, the LED in
  the   button   comes   on,   accompanied  
by

  an   audible   signal   and   a   message   in  
the

  screen.
Contact
  a   CITROËN   dealer   or   qualified  
workshop.
Good practice
In bad weather or in winter, ensure that
the  sensors   are   not   covered   with   mud,  
ice

  or   snow.
The
  system   will   be   deactivated  
automatically

  if   a   trailer   is   being   towed  
or

  if   a   bicycle   carrier   is   fitted   (vehicle  
fitted

  with   a   towbar   or   bicycle   carrier  
recommended

  by   CITROËN).
You can activate or deactivate
the
 
system
 
by
 
pressing
 
this
 
button.
The activation or deactivation
of

 
the
 
system
 
is
 
stored
 
when
 
the

 
vehicle
 
stops.
Engage forward gear
In addition to the rear parking sensors, the   front   parking   sensors   are   triggered  
when an obstacle is detected in
front of the vehicle and the speed
of

  the   vehicle   remains   below   6   mph  
(10 km/h).The

  tone   from   the   speaker   (front  
or rear) allows an obstacle to be
identified

  as   either   in   front   of   or  
behind

  the   vehicle.
Stop the assistance
Change to neutral. The   parking   sensor   system  
cannot,

  in   any   circumstances,  
take

  the   place   of   the   vigilance   and  
responsibility

  of   the   driver.
Parking sensors

 117
Berlingo-2-VP_en_Chap05_Securite_ed01-2016
REVERSING CAMERA
The reversing camera is activated automatically  when   reverse   gear   is  
engaged.
The

  image   is   displayed   in   the   touch  
screen

  tablet.
The
  reversing   camera   function   may   be  
completed

  with   parking   sensors.
The
  reversing   camera   cannot   in  
any

  circumstances   be   a   substitute  
for vigilance on the part of the
driver

. High pressure jet washing
When washing your vehicle, do
not
 
direct
 
the
 
lance
 
within
 
30
 
cm
 
of
 
the

  camera   lens.
The
  superimposed   representation   of  
guide

  lines   helps   with   the   manoeuvre.
They
  are   represented   by   lines   marked  
"on the ground" and do not allow the
position

  of   the   vehicle   to   be   determined  
relative

  to   tall   obstacles   (for   example:  
other

  vehicles,   ...).
Some
  deformation   of   the   image   is  
normal.The blue lines represent the general
direction of the vehicle (the dif

ference
corresponds to the width of your
vehicle
  without   the   mirrors).
The red lines represent a distance of
about
  30   cm   beyond   the   edge   of   your  
vehicle's

  rear   bumper.
The green lines represent distances of
about
  1   and   2   metres   beyond   the   edge  
of

  your   vehicle's   rear   bumper.
The turquoise blue curves represent
the
  maximum   turning   circle.
o

pening the tailgate causes the
display
  to   disappear.
Clean
  the   reversing   camera   regularly  
using

  a   soft,   dry   cloth.
Parking sensors
SaFETY
5

122
Berlingo-2-VP_en_Chap05_Securite_ed01-2016
ACTIVE CITY BRAKE
Active City Brake is a driving assistance
  system   that   aims   to   avoid  
a frontal collision or reduce the speed
of

  an   impact   if   the   driver   does   not  
react

  sufficiently   (inadequate   brake  
application).
This

  system   is   designed   to  
improve

  driving   safety.
It
  remains   the   driver's   responsibility   to  
continuously

  monitor   the   state   of   the  
traffic

  and   to   assess   the   distances   and  
relative

  speeds   of   other   vehicle.
Active
  City   Brake   can   in   no  
circumstances

  replace   the   need   for  
vigilance

  on   the   part   of   the   driver. Never
  look   at   the   laser   sensor  
through

  an   optical   instrument  
(magnifying

  glass,   microscope...)  
at a distance of less than
10 centimetres:

  risk   of   eye   injury.Principle
Using a laser sensor located at the top
of  the   windscreen,   this   system   detects  
a

  vehicle   running   in   the   same   direction  
or

  stationary   ahead   of   your   vehicle.
When
  necessary,   the   vehicle's   braking  
system

  is   operated   automatically  
to avoid a collision with the vehicle
ahead.Automatic

  braking   occurs   later  
than if done by the driver

, so as
to intervene only when there is a
high
  risk   of   collision.
Conditions for activation
Active City Brake only operates if the following  conditions   are   met:
●
 
ignition
  on,
●
 
the
  vehicle   is   in   a   forward   gear,
●
 
speed
  is   between   about   3   and  
18 mph

  (5   and   30   km/h),
●
 
the
  braking   assistance   systems  
(ABS,

  EBFD,   emergency   braking  
assistance) are not faulty

,
●
 
the
  trajectory   control   systems  
(

a SR, d SC) are not deactivated or
faulty,
●
 
the
  vehicle   is   not   in   a   tight   corner,
●
 
the
  system   has   not   been   triggered  
during

  the   previous   10   seconds.
driving safely

124
Berlingo-2-VP_en_Chap05_Securite_ed01-2016
Deactivation
The system is deactivated in the vehicle  configuration   menu,   accessible  
with

  the   ignition   on.
Its
  state   is   memorised   when   the  
ignition

  is   switched   off.
When
  the   system   is   deactivated,  
a

  message   is   displayed   every  
time

  the   ignition   is   switched   on,  
to
  warn   you. With the monochrome screen C
F

Press the
MENU button for access
to
  the   main   menu.
F

Select "
Personalisation-
Configuration".
F

Select "
Define vehicle
parameters".
F

Select "
Driving assistance".
F

Select "
Automatic emergency
braking: OFF" or "Automatic
emergency braking: ON".
F

Press the "
7" or "8" button to
check
  or   uncheck   the   box   and  
activate

  or   deactivate   the   system  
respectively

.
F

Press the "
5" or "6" button, then
the OK button to select the "OK"
box
  and   confirm   or   the   Back button
to
  cancel.With the touch screen tablet
F
Press the " MENU"   button.
F Select the " Driving"   menu.
F

In the secondary page, select
"

Vehicle settings".
F

Select the "
Driving assistance"
tab.
F
 
Check
  or   uncheck   the   "Auto
emergency braking" box to
activate
  or   deactivate   the   system.
F
 
Confirm.
driving safely