2016 Alfa Romeo 4C inflation pressure

unknown origin;
if a tyre is changed, also change the
inflation valve.
WARNING
131)The road holding qualities of the car
also depend on the correct inflation
pressure of the tyres.
132)If tyre pressure is too low, the tyre
may overheat and be severely damaged as
a result.
133)Do not switch tyres from the left to
the right side and vice versa, in order to
prevent inversion of the rotation direction.
134)Do not repaint alloy wheel rims at
temperatures higher than 150°C. The
mechanical characteristics of the wheels
might be compromised.
135)The car is always equipped with front
and rear wheels of different dimensions. It
is not therefore possible to move the
wheels from the front to the back and vice
versa.
It is advisable to replace the blade
about once a year.
136)
A few simple precautions can reduce
the possibility of damage to the blade:
if the temperature falls below zero,
make sure that ice has not frozen the
rubber to the glass. Use an antifreeze
product to release it if required;
remove any snow from the glass;
do not operate the windscreen wiper
on dry glass.
IMPORTANT Do not lift the arm of the
windscreen wiper when it is in its initial
rest position. Refer to the following
instructions to lift the windscreen wiper
blade correctly.
Lifting blade
If it is necessary to lift the blade from
the windscreen (e.g. in the event of
snow or if the blade needs
replacement) proceed as follows:
turn ring nut A fig. 132 to(wiper
off);
turn the ignition key to MAR-ON and
then to STOP;
after turning the ignition key to
STOP, within 2 minutes move the right
stalk upwards, into unstable
("anti-panic") position, for at least half a
second. The windscreen wiper then
executes part of a stroke; at each
command, approximately 1/3 of a
normal wiper stroke is triggered.
the previous operation can be
repeated up to 3 times, in order to
move the blade to the most suitable
position;
lift the blade from the windscreen
and proceed with the required
operation;
lower the blade, bringing it into
contact with the windscreen;
bring the blade to the initial rest
position, turning the ignition key to
MAR-ON.
29)
132A0L0021
140
SERVICING AND MAINTENANCE

COLD TYRE INFLATION PRESSURE (bar)
Tyres provided Inflation pressure (bar)
Front tyres205/45 R17 88Y XL 1.8
205/40 R18 86Y XL 1.8
Rear tyres235/40 R18 95Y XL 2.0
235/35 R19 91Y XL 2.0
When the tires are warm, the inflation pressure should be + 0.3 bar in relation to the recommended figure. However, recheck
that the value is correct with the tyre cold.
With snow tyres, add +0.2 bar to the pressure value prescribed for standard tyres.
If it is necessary to raise the vehicle, refer to the "Raising the vehicle" paragraph in the "In an emergency" chapter.
158
TECHNICAL SPECIFICATIONS

inflation pressures..........158
reading the tyre code........155
snow tyres...............157
tyres provided............157
Tyres - maintenance...........139
Using the transmission.........96
Warning lights and messages.....67
Weights..................161Wheel rims
reading the rim code........155
Wheels and tyres
changing a wheel..........109
Fix&Go automatic (kit).......106
tyre inflation pressure........158
Wheel repair.............106Wheels and tyres..........139
Window cleaning.............29
Windows (cleaning)...........142
Windscreen washer nozzles......141
Windscreen wiper
blades.................140
replacing blades...........141
INDEX
MOPAR
TECHNICAL SERVICES - SERVICE ENGINEERING
FCA Italy S.p.A. - Largo Senatore G. Agnelli, 3 - 10040 Volvera - Torino (Italia)
Print No. 530.05. 53 - 1 Edition - /2015
All rights reserved. Reproduction, even partial, without written authorisation
from FCA Italy S.p.A. is prohibited12 0