2015 VOLKSWAGEN TRANSPORTER Climatic

[x] Cancel search: Climatic

Page 13 of 486

VOLKSWAGEN TRANSPORTER 2015  Owner´s Manual @ Controls for: 
-Climatic .................................................................... . 
-Climatronic ............................................•..................... 
® Stowage compart

Page 14 of 486

VOLKSWAGEN TRANSPORTER 2015  Owner´s Manual -Start/stop system &. ........................ . 282 
-Hazard warning lights d1.. . . . . . . . . . . . . .  . . . . . . . • • . . . . . . . . . . . 411 
-Windscreens made of heat-insulating glass

Page 69 of 486

VOLKSWAGEN TRANSPORTER 2015  Owner´s Manual A WARNING (Continued) 
• The steering wheel must always point to-wards the chest and not towards the face. This ensures that the driver front airbag pro-vides maximum protection in the event of an a

Page 250 of 486

VOLKSWAGEN TRANSPORTER 2015  Owner´s Manual A WARNING (Continued) 
• Never fit fuses that have a higher fuse pro-tection limit. Fuses must always be replaced by a new fuse with the same amp rating (same colour and markings) and size. 
• Nev

Page 322 of 486

VOLKSWAGEN TRANSPORTER 2015  Owner´s Manual Air conditioning system 
Heating, ventilating, cooling 
o:n Introduction 
This chapter contains information on the following subjects: 
Controls for Climatic . . . . . . . . . . . . . . . . . . . . 32

Page 323 of 486

VOLKSWAGEN TRANSPORTER 2015  Owner´s Manual m If the cooling system is switched off. the out-W side air that is drawn into the vehicle is not dehumidified. To prevent the windows misting over, Volkswagen Commercial Vehicles recommends that you

Page 324 of 486

VOLKSWAGEN TRANSPORTER 2015  Owner´s Manual Button, Additional information. Climatic *Fig. 254 and *Fig. 255. control 
CD Temperature . 
••••• Turn the regulator to set the temperature as required. 
@ Blower. Setting 0: blower and C

Page 328 of 486

VOLKSWAGEN TRANSPORTER 2015  Owner´s Manual Settings for optimal road visibility 
• Switch off air recirculation mode 330. 
• Set blower® to level 1 or 2. 
• Set the temperature selector G) to the required position. 
• Open and positio
Page:   1-8 9-16 next >