Page 122 of 728
79
1-2. Charging
1
Before driving
PRIUS PHV_OM_OM47A11U_(U)
■The names of each part of the charging cable
*:The shape of the plug differs in accordance with the voltage and the
target region.
Charging connector
Latch release button
CCID (Charging Circuit Inter-
rupting Device)
Plug*
Power indicator
Error warning indicator
Te s t   b u t t o n
Reset button 
         
        
        
     
        
        Page 123 of 728

80
1-2. Charging
PRIUS PHV_OM_OM47A11U_(U)
Safety functions
The  CCID  (Charging  Circuit  Interrupting  Device)  has  the  following
safety features.
■Electrical leakage detection function
If  an  electrical  leakage  is  detected  during  charging,  the  power
source  will  be  automatically  interrupted,  thus  preventing  fires  or
electrical shocks caused by electrical leakage.
If  the  power  source  is  interrupted,  the  error  warning  indicator  will  illumi-
nate.
If the power source is interrupted:  oP.   1 0 7
■Electrical leakage test function
The  electrical  leakage  detection  function  can  be  tested  prior  to
charging to confirm that it is operating correctly.
When the test button is pressed while the plug is connected to an exter-
nal power source, the error warning indicator should illuminate. 
( oP.   1 0 8 )
■Conditions for supplying current to the vehicle
The  CCID  (Charging  Circuit  Interrupting  Device)  is  designed  to
prevent electrical current from being supplied to the charging con-
nector  when  it  is  not  connected  to the vehicle, even if the plug is
inserted into the outlet.
■Charging cable
The charging cable may become hard in low temperatures. 
         
        
        
     
        
        Page 126 of 728

83
1-2. Charging
1
Before driving
PRIUS PHV_OM_OM47A11U_(U)
■The charging environment
For safe charging, the following charging equipment and settings are recom-
mended.
●Weatherproof outlet
When charging outdoors, connect the plug to a weatherproof outlet, and
ensure that the plug remains waterproof while the plug is connected.
●Dedicated circuit
• To reduce the risk of fire, connect only to an at least 15A branch circuit
with an over-current protection in accordance with the National Electric
Code, ANSI/NFPA 70.
•To reduce the risk of electric shock when working with the plug, con-
nect  to  a  outlet  with  a  Ground-Fault  Circuit-Interrupter  (GFCI)  or  that
has an Earth Leakage Circuit Breaker installed.
CAUTION
■Warnings for electrical faults
Make sure to observe the following precautions when charging the vehicle.
Failure  to  use  a  power  source  that  fulfills  the  requirements,  or  failure  to
observe  regulations  while  charging  could  lead  to  an  accident,  possibly
resulting in death or serious injury. 
         
        
        
     
        
        Page 130 of 728
87
1-2. Charging
1
Before driving
PRIUS PHV_OM_OM47A11U_(U)
Press  the  test  button  on  the
CCID  (Charging  Circuit  Inter-
rupting  Device)  to  check  that
the  electrical  leakage  detec-
tion  function  operates  prop-
erly.
If  the  error  warning  indicator
illuminates  when  the  test  but-
ton  is  pressed,  the  function  is
operating correctly.
After  the  test  has  been  com-
pleted,  press  the  reset  button
to  turn  off  the  error  warning
indicator.  Charging  cannot  be
carried  out  while  the  error
warning  indicator  is  illumi-
nated.
If  the  error  warning  indicator
does  not  come  on  even  if  the
test  button  is  pressed,  it  is
likely  that  the  function  is  not
operating  correctly.  Stop
charging immediately and con-
tact your Toyota dealer.
STEP 3  
         
        
        
     
        
        Page 132 of 728
89
1-2. Charging
1
Before driving
PRIUS PHV_OM_OM47A11U_(U)
Confirm that the charging indi-
cator is illuminated. (When the
charging  timer  function  is  in
use,  the  light  will  turn  off  sev-
eral  seconds  after  illuminat-
ing.)
Charging  will  not  start  if  the
charging indicator does not illu-
minate when the charging con-
nector is inserted. ( oP.   1 0 4 )
The amount of time until charg-
ing  is  completed  can  be
checked on the energy monitor
by turning the “POWER” switch
to ON mode. ( oP.   9 4 )
The  error  warning  indicator  of
the  CCID  (Charging  Circuit
Interrupting  Device)  has  illumi-
nated during charging: 
 oP.   1 0 7
The charging  indicator will turn
off  when  charging  is  com-
pleted.
STEP7 
         
        
        
     
        
        Page 138 of 728

95
1-2. Charging
1
Before driving
PRIUS PHV_OM_OM47A11U_(U)
■Charging messages
The  first  time  the  “POWER”
switch  is  turned  to  ON  mode
after  charging  is  completed,  a
message  detailing  the  results  of
the  charging  will  be  displayed.
Also,  if  an  operation  which  can-
not  be  carried  out  is  attempted
during  charging,  a  warning  mes-
sage will be displayed. 
( oP.   5 7 0 )
Comply  with  the  instructions  in
the  message  and  carry  out  any
necessary operations.
The  message  may  not  be  dis-
played  if  the  Remote  Air  Condi-
tioning  System  ( oP.   3 7 7 )   h a s
been used.
■Amount of time until charging is complete
Charging fully from when an EV driving range is not displayed (0 mile [0 km])
on  the  multi-information  display  ( oP.   5 8 )   w i l l   t a k e   a p p r o x i m a t e l y   2 . 5   h o u r s
(AC120 V).
The amount of time until charging is complete will change in accordance with
the  amount  of  charge  remaining  in  the  hybrid  battery  (traction  battery),  the
outside temperature, etc.
■During charging
●The  surface  of  the  CCID  (Charging  Circuit  Interrupting  Device)  may
become hot, but this does not indicate a malfunction.
●Depending  on  radio  wave  conditions,  interference  may  be  heard  on  the
radio. 
         
        
        
     
        
        Page 144 of 728

101
1-2. Charging
1
Before driving
PRIUS PHV_OM_OM47A11U_(U)
CAUTION
■Battery charger
The battery charger is located under the luggage compartment. Observe the
following precautions.
Failure  to  do  so  may  cause  death  or  serious  injury  from  burns  or  electric
shocks.
●Do not touch the battery charger during charging, as it becomes hot.
●Do not disassemble, repair or modify the battery charger. 
If repair is necessary, consult your Toyota dealer.
■If  the  error  warning  indicator  on  the  CCID  (Charging  Circuit  Interrupt-
ing Device) stays on during charging
Press  the  reset  button  on  the  CCID  (Charging  Circuit  Interrupting  Device)
( oP.   1 0 7 ) .   I f   t h e   e r r o r   w a r n i n g   i n d i c a t o r   d o e s   n o t   t u r n   o f f   e v e n   w h e n   t h e
reset button is pressed, an electrical leakage may be occurring in the path to
the power source, or there may be a problem with the charging cable or the
charging  system.  In  this  event,  stop  charging  immediately,  remove  the
charging  cable  and  contact  your  Toyota  dealer.  An  accident  may  occur  or
damage may be inflicted if charging continues.
■When the charging cable is connected to the vehicle
Do not operate the shift lever.
In  the  unlikely  event  that  the  charging  cable  has  been  damaged,  the  shift
position may change from P to another position and the vehicle could move,
possibly leading to an accident. 
         
        
        
     
        
        Page 148 of 728

105
1-2. Charging
1
Before driving
PRIUS PHV_OM_OM47A11U_(U)
SituationReasonCorrection procedure
The error warning indi-
cator on the CCID 
(Charging Circuit Inter-
rupting Device) comes 
on
•The electrical leakage 
detection function or 
the self-test function 
has operated and the 
power supply has been 
interrupted.
•The test button has 
been pressed.
Reset the CCID (Charg-
ing Circuit Interrupting 
Device). ( oP.   1 0 7 )
The charging indicator 
does not illuminate 
even though the charg-
ing connector is con-
nected
The latch release but-
ton is being pressed.
For safety purposes, 
charging will be inter-
rupted when the latch 
release button is 
pressed. ( oP.   9 6 )
When connecting the 
charging connector to 
the vehicle, insert it into 
the charging inlet with-
out pressing the latch 
release button.
The charging connec-
tor is not properly con-
nected to the charging 
inlet.
Check that the charg-
ing connector is firmly 
connected to the 
charging inlet.
If the charging indicator 
does not illuminate 
even though the charg-
ing connector is firmly 
connected, there may 
be a problem in the 
system. Stop charging 
immediately and con-
sult your Toyota dealer.
The hybrid battery 
(traction battery) is 
already fully charged.