2015 SUZUKI NEXA ignition
[x] Cancel search: ignitionPage 92 of 288
Downloaded from www.Manualslib.com manuals search engine % ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
+ H D G O L J K W / H Y H O L Q J 6 Z L W F K
80JM040
Level the headlight beam according to the
load condition of your vehicle by turning this
switch. The chart below shows the appropri-
ate switch position for different vehicle-load
conditions.
7 X U Q 6 L J Q D O & R Q W U R O / H Y H U
65D611
7 X U Q 6 L J Q D O 2 S H U D W L R QWith the ignition switch in the “ON” position
or the ignition mode ON, move the lever up
or down to activate the right or left turn sig-
nals.
1 R U P D O W X U Q V L J Q D O
60MK013
Move the lever all the way upward or
downward to signal. When the turn is com-
pleted, the signal will cancel and the lever
will return to its normal position.
/ D Q H F K D Q J H V L J Q D O
60MK014
Move the lever part-way in the direction to
turn and hold it there.
Vehicle Load
Condition
Switch PositionD13A
EngineD16AA
Engine
Driver only 0 0Driver +
1 passenger
(in front seat)
00
Driver +
4 passengers,
no cargo
11
Driver +
4 passengers,
cargo added
22
Driver +
full cargo
33
: $ 5 1 , 1 *
7 R D Y R L G S R V V L E O H L Q M X U \ G R Q R W R S H U
D W H F R Q W U R O V E \ U H D F K L Q J W K U R X J K W K H
V W H H U L Q J Z K H H O
( ; $ 0 3 / ( ( ; $ 0 3 / (
Page 94 of 288
Downloaded from www.Manualslib.com manuals search engine % ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
: L S H U D Q G : D V K H U 2 S H U D W L R QWhen the ignition switch is in the “ON” posi-
tion or the ignition mode is ON, you can use
the wiper/washer lever or switch (if
equipped). : L Q G V K L H O G : L S H U V
64MS063
To turn the windshield wipers on, move the
lever down to one of the three operating
positions. In the “INT” position, the wipers
operate intermittently. The “INT” position is
very convenient for driving in mist or light
rain. In the “LO” position, the wipers operate
at a steady low speed. In the “HI” position,
the wipers operate at a steady high speed.
To turn off the wipers, move the lever back
to the “OFF” position.
Move the lever up and hold it to the “MIST”
position, the windshield wipers will turn on
continuously at low speed.
64MS064
If the lever is equipped with the “INT TIME”
control, turn the control forward or rear-
ward to adjust the intermittent wiper opera-
tion to the desired interval.
: L Q G V K L H O G : L S H U V Z L W K 5 D L Q 6 H Q V
L Q J ) X Q F W L R Q L I H T X L S S H G
64MS065
Press the engine switch to change the igni-
tion mode to ON. To turn the rain-sensing
wipers on, move the lever down to one of
the three operating positions. In the “AUTO”
position (if provided), the wipers automati-
cally operate when the wiper system senses
rain or snow. In the “LO” position, the wipers
operate at a steady low speed. In the “HI”
position, the wipers operate at a steady high
speed. To turn off the wipers, move the lever
back to the “OFF” position.Move the lever up and hold it to the “MIST”
position; the wipers will operate continu-
ously at low speed for as long as you hold
the lever in the “MIST” position.
( ; $ 0 3 / (
( ; $ 0 3 / (
MIST
HI OFF
LO AUTO
( ; $ 0 3 / (
Page 98 of 288
Downloaded from www.Manualslib.com manuals search engine % ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
+ R U Q
68LM240
Press the horn button of the steering wheel
to sound the horn. The horn will sound with
the ignition switch in any position or any
ignition mode.
+ H D W H G 5 H D U : L Q G R Z 6 Z L W F K L I
H T X L S S H G 7 \ S H
64MS167
7 \ S H
64MS168
When the rear window is misted, push this
switch (1) to clear the mist from the win-
dow.An indicator light will be lit when the defog-
ger is on. The defogger will work only
when the engine is running. To turn off the
defogger, push the switch (1) again.
NOTE:
• The defogger will work only when the
engine is running.
• The defogger will automatically turn off
after the defogger remains on for 15 min-
utes to prevent discharging of the bat-
tery.
REAR
12
3
04A/C
( ; $ 0 3 / (
(1)
( ; $ 0 3 / ( ( ; $ 0 3 / (
NOTICE
7 K H K H D W H G U H D U Z L Q G R Z X V H V D O D U J H
D P R X Q W R I H O H F W U L F L W \ % H V X U H W R W X U Q
R I I D I W H U W K H Z L Q G R Z D Q G P L U U R U V K D Y H
E H F R P H F O H D U
(1)
Page 101 of 288
Downloaded from www.Manualslib.com manuals search engine
2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
4) Make sure the hood is fully closed and
latched.
5) Check the headlights, turn signal lights,
brake lights and horn for proper opera-
tion.
6) Adjust the seat and head restraint.
7) Check the brake pedal and the parking
brake lever.
8) Adjust the mirrors.
9) Make sure that you and all passengers
have properly fastened the seat belts.
10)Make sure that all warning lights come
on as the ignition switch is turned to the
“ON” position or the engine switch is
pressed to change the ignition mode to
ON.
11)Check all gauges.
12)Make sure that the BRAKE SYSTEM
WARNING light turns off when the park-
ing brake is released.
Once a week, or each time you fill your fuel
tank, perform the following under-hood
checks:
1) Engine oil level
2) Coolant level
3) Brake fluid level
4) Battery electrolyte level
5) Windshield washer fluid level
6) Hood latch operation
Pull the hood release handle inside the
vehicle. Make sure that you cannot
open the hood all the way without
releasing the secondary latch. Be sure
to close the hood securely after check-
ing for proper latch operation. See theitem “All latches, hinges and locks” of
Page 102 of 288
Downloaded from www.Manualslib.com manuals search engine 2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
making it appear that the oil level has not
changed.
You should also be aware that the diluting
ingredients evaporate out when the vehicle
is subsequently driven at high speeds,
such as on an expressway, making it
appear that oil is excessively consumed
after high-speed driving.
, J Q L W L R Q 6 Z L W F K
9 H K L F O H Z L W K R X W . H \ O H V V
3 X V K 6 W D U W 6 \ V W H P
65D61152KM052
The ignition switch has the following four
positions:
/ 2 & .
This is the normal parking position. It is the
only position in which the key can be
removed.
60G033
: $ 5 1 , 1 *
7 R D Y R L G S R V V L E O H L Q M X U \ G R Q R W R S H U
D W H F R Q W U R O V E \ U H D F K L Q J W K U R X J K W K H
V W H H U L Q J Z K H H O
( ; $ 0 3 / (
Turn to “LOCK Push
( ; $ 0 3 / (
Page 103 of 288
Downloaded from www.Manualslib.com manuals search engine
2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
You must push in the key to turn it to the
“LOCK” position. It locks the ignition, and
prevents normal use of the steering wheel
after the key is removed.
To release the steering lock, insert the key
and turn it clockwise to one of the other
positions. If you have trouble turning the
key to unlock the steering, try turning the
steering wheel slightly to the right or left
while turning the key.
$ & &
Accessories such as the radio can oper-
ate, but the engine is off.
2 1
This is the normal operating position. All
electrical systems are on.
6 7 $ 5 7
This is the position for starting the engine
using the starter motor. The key should be
released from this position as soon as the
engine starts.
, J Q L W L R Q N H \ U H P L Q G H U L I H T X L S S H G
A buzzer sounds intermittently to remind
you to remove the ignition key if it is in the
ignition switch when the driver’s door is
opened.
81A297S
: $ 5 1 , 1 *
Page 104 of 288
Downloaded from www.Manualslib.com manuals search engine 2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
( Q J L Q H 6 Z L W F K
9 H K L F O H Z L W K . H \ O H V V 3 X V K
6 W D U W 6 \ V W H P
61MM0B001
/ 2 & . 2 ) )
Once this mode is selected by pressing the
engine switch, opening or closing of any
door (including the tailgate) will result in
automatic locking or steering.
$ & &
Press the engine switch to select this igni-
tion mode to use such electric equipment
as the audio system, outside rearview mir-
rors and accessory socket with the engine
off. When this position is selected, the
information display in the instrument clus-
ter shows the following message: “ACC”
IGNITION SWITCH POSITION. Refer to
“Information Display” in the ³ % ( ) 2 5 (
' 5 , 9 , 1 * ´ section for details.
2 1
Page 105 of 288
Downloaded from www.Manualslib.com manuals search engine
2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
NOTE:
In the presence of strong radio signals or
noise, you may not be able to change the
ignition mode to ACC or ON or to start the
engine using the engine switch. In this
case, the information display on the instru-
ment cluster will show the following mes-
sage: KEY FOB NOT DETECTED. 8 Q U H O H D V H G 6 W H H U L Q J / R F N : D U Q L Q JIf the steering lock remains engaged when
you press the engine switch to change the
ignition mode to “ON”, the information dis-
play in the instrument cluster shows the
message: “TRN. STEERING WHEEL TO
RELEASE LOCK”. Refer to “Information
Display” in the ³ % ( ) 2 5 ( ' 5 , 9 , 1 * ´ sec-
tion for details.
NOTE:
The steering lock may not be released if
some load is acting on the steering wheel.
If this happens, turn the steering wheel to
the right or left to relieve it from the load
before you press the engine switch again
to change to the desired ignition mode.
. H \ O H V V 3 X V K 6 W D U W 6 \ V W H P
L I H T X L S S H G Provided the keyless push start system
remote controller is within the “interior
workable area” (refer to the related expla-
nation in this section), you can use the
engine switch for starting the engine and
selecting an ignition mode (ACC or ON). In
addition, the following functions can be
used:
• Keyless entry function. Refer to “Keyless
Push Start System Remote Controller” in
the “BEFORE DRIVING” section for
details.
• Locking and unlocking doors (including
the tailgate) using a request switch.
Refer to “Keyless Push Start System
Remote Controller” in the “BEFORE
DRIVING” section for details.
• Immobilizer (anti-theft) function. Refer to
“Immobilizer System” in the “BEFORE
DRIVING” section for details. ( Q J L Q H 6 Z L W F K , O O X P L Q D W L R QThe engine switch is illuminated (lit) in the
following situations:
• When the engine is off and the driver’s
door is open or for 15 seconds after the
drivers door is closed.
• When the engine is off and the position
lights are on. The illumination will go out
when the position lights are turned off.
• When the engine is on and the position
lights and/or the headlights are on. Theillumination will go out when the head-
lights are turned off.
82K253
NOTE:
To save the battery, the illumination will be
automatically turned off when both of the
following conditions are simultaneously
met:
• The headlights and position lights are
turned off.
• A period of 15 minutes has elapsed after
opening the driver’s door. 6 H O H F W L R Q R I , J Q L W L R Q 0 R G H VPress the engine switch to select the
“ACC” or “ON” mode as follows when you
use an electric accessory or check the
operation of instruments without running
the engine.
1) Bring the keyless push start system
remote controller with you and sit in the
driver’s seat.