Page 128 of 288
Downloaded from www.Manualslib.com manuals search engine 2 3 ( 5 $ 7 , 1 * < 2 8 5 9 ( + , & / (
0 6 (
+ R Z W K H $ % 6 : R U N VA computer continuously monitors wheel
speed. The computer compares the
changes in wheel speed when braking. If
the wheels slow suddenly, indicating a
skidding situation, the computer will
change braking pressure several times
each second to prevent the wheels from
locking. When you start your vehicle or
when you accelerate after a hard stop, you
may hear a momentary motor or clicking
noise as the system resets or checks
itself." This is absolutely normal and indi-
cates that ABS is functioning properly"
: $ 5 1 , 1 *
Page 136 of 288
Downloaded from www.Manualslib.com manuals search engine ' 5 , 9 , 1 * 7 , 3 6
0 6 (
2) Don’t use hand-braking unless una-
voidable. It causes the vehicle to skid
and a rearend collision occur. It is espe-
cially dangerous when the tyres are
worn, for they allow a larger skid.
72F-08-012
Use foot brake in three stages
1.Warn the vehicle behind you
2.Gradually apply the brake.
3.Bring the vehicle to a halt.
3) When driving on a downhill, try not to
apply the brake but use the engine
brake effectively. Overuse of the foot
brake may result in total brake failure.
4) Avoid reckless high speed driving and
try to drive at a safe speed suitable for
the road conditions while maintaining a
constant speed.
72F-08-015
5) The higher the speed, the narrower the
driver’s visual range becomes. In such
a state, it is difficult to anticipate any
hazard and the driver feels much
fatigued.
6) Never do sharp handling during high
speed driving. You will lose your control
over your vehicle.
7) When overtaking or changing the lane
while driving at a high speed, keep an
ample vehicle-to-vehicle distance. / R Q J G L V W D Q F H G U L Y L Q J
1) Be sure to perform safety checks before
starting a trip.
2) Take rest at certain intervals to prevent
an accident which may occur when you
are sleepy or tired.
72F-08-020
1 L J K W W L P H G U L Y L Q J
1) Drive more slowly at night than in the
daytime, for the visual range is
restricted at night.
2) Don’t overtake other vehicles at night.
Darkness bothers your sense of speed
and hinders your judgment on the vehi-
cle-to-vehicle distance.
3) Don’t use the high headlight beam
unless its use is inevitable. Its dazzle
may blitz the driver of the oncoming
vehicle, thus causing an accident.
4) Always keep the window glasses clean.
Don’t operate the windshield wiper
Page 209 of 288
Downloaded from www.Manualslib.com manuals search engine
2 7 + ( 5 & 2 1 7 5 2 / 6 $ 1 ' ( 4 8 , 3 0 ( 1 7
0 6 (
% D W W H U \ , Q V W D O O D W L R QInstall a lithium battery (CR2025) with the poles facing the correct direction.
% D W W H U \ U H S O D F H P H Q W W L P L Q J
• When battery power is depleted, the button may not be operable. If the remote controller
does not operate, replace the battery and check the operation.
& D X W L R Q R Q E D W W H U \
• Be sure to follow the instructions to prevent battery leakage, over-heating, ignition or
explosion.
If battery leakage has occurred, wipe the
container first then install a new battery. If
the battery solution contacts the skin, wash
off with water completely.
& D X W L R Q R Q 5 H P R W H & R Q W U R O O H U• Do not leave the remote controller in an
area exposed to direct sunlight, such as
on the dashboard or steering wheel. The
remote controller may deform because of
the heat, (Be especially careful of the
dashboard exposed to direct sunlight in
the summer, as it will become extremely
hot).
: $ 5 1 , 1 *
Page 217 of 288
Downloaded from www.Manualslib.com manuals search engine
2 7 + ( 5 & 2 1 7 5 2 / 6 $ 1 ' ( 4 8 , 3 0 ( 1 7
0 6 (
7 U R X E O H V K R R W L Q JWhen encountered a problem, check and follow the instructions as described below.
If the described suggestions do not solve the problem, it is recommended to take the unit to your D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S
3 U R E O H P
3 R V V L E O H F D X V H
3 R V V L E O H V R O X W L R Q
& R P P R Q
Unable to operate The security function is on.When “SECURITY” is displayed, enter
the ID.
When “HELP” is displayed, contact your
D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S
Unable to turn on the power (no sound).
(No sound is produced)Fuse is blown.Contact your D X W K R U L V H G 0 D U X W L
6 X ] X N L Z R U N V K R S
5 D G L R
Much noiseIt may not be exactly tuned in to the sta-
tion.Tune it in exactly to the station.
Unable to receive by auto tuningThere may be no station emitting signals
powerful enough.Pick up a station by manual tuning.
& '
Sound skips or noise producedThe disc is dirty. Wipe the disc with a soft cloth.
The disc has a major scratch or is
warped.Replace the disc with the one with no
scratch and also not warped.
Page 218 of 288
Downloaded from www.Manualslib.com manuals search engine 2 7 + ( 5 & 2 1 7 5 2 / 6 $ 1 ' ( 4 8 , 3 0 ( 1 7
0 6 (
0 3 : 0 $ $ $ &
No playbackThe disc contains unsupported formatted
data.Check the file format.
Sound skips or noise producedSound skipping may occur when playing
VBR (Variable Bit Rate) files.It is not recommended to play VBR files.
8 6 %
Playback does not start when the USB
device is connected.There is no supported format file to play
on this unit.Check the file format.
The current consumption of the USB
device exceeds 1.0 A.Use an USB device with a current con-
sumption lower than 1.0 A.
% O X H W R R W K
Š
Pairing failedThe distance between this unit and the
Bluetooth
® ready device is too far, or a
metallic object may be located between
the Bluetooth® ready device and this unit.Change the location of the Bluetooth
®
ready device.
The Bluetooth
® function of the Blue-
tooth
® ready device is off.Refer to the manual of the Bluetooth
®
ready device. (Some devices have the
power saving function that automatically
activates after a certain time.)
Unable to receive a call.Your current location may be out of ser-
vice area.Drive your vehicle to the service area of
the phone.
The voice quality of hands-free is low
(Distortion, noise etc.).Another wireless device may be located
near the unit.Switch off the wireless device or keep it
away from the unit.
3 U R E O H P
3 R V V L E O H F D X V H
3 R V V L E O H V R O X W L R Q
Page 219 of 288
Downloaded from www.Manualslib.com manuals search engine
2 7 + ( 5 & 2 1 7 5 2 / 6 $ 1 ' ( 4 8 , 3 0 ( 1 7
0 6 (
( U U R U ' L V S O D \ 0 H V V D J H V
' L V S O D \
3 R V V L E O H F D X V H
3 R V V L E O H V R O X W L R Q
& '
( 5 5 2 5 The disc cannot be read.Insert the disc with its label side up.
Check the disc if it is not warped or is free of flaws. When
ERROR 1 does not disappear even when a normal disc is
inserted, contact your D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S
( 5 5 2 5 The player developed an error of an
unidentified cause.When the CD is in the unit, press the CD eject button to
remove the disc.
When the disc cannot be ejected, contact your D X W K R U L V H G
0 D U X W L 6 X ] X N L Z R U N V K R S
8 6 % L 3 R G
Š ( 5 5 2 5 The USB device is disconnected. Check the connection of the USB device.
( 5 5 2 5 Impossible to communicate correctly with
the USB device.Unplug the USB device and plug it again.
Check the USB device.
( 5 5 2 5 Inoperable due to an unidentified cause.Unplug the USB device and plug it again.
When ERROR 3 does not disappear, contact
your D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S
( 5 5 2 5 The current consumption of the USB
device exceeds 1.0 A.Check the USB device.
Page 228 of 288
Downloaded from www.Manualslib.com manuals search engine 7-5INSPECTION AND MAINTENANCE
64MS0-74E
Interval: This interval should be judged by odometer reading
or months, whichever comes first.
FREE INSPECTION
PERIODIC MAINTENANCE AT COST
km (x1000)
1
5
10
20
30
40
50
60
70
80
months
1
6
12
24
36
48
60
72
84
96
ROAD TEST11-1.
Operation of Brakes, gear shifting and speedometer
I
I
I
I
I
I
I
I
I
I
11-2.
Body and chassis noise
I
I
I
I
I
I
I
I
I
I
AIR CONDITIONER
12-1.
Check belt tension
I
I
I
I
I
I
I
I
I
I
12-2. Tighten compressor mounting bolt – T T T T T T T T T
12-3.
All hose joint (Check, tighten)
I
I
I
I
I
I
I
I
I
I
12-4.Check fun ctioning of R E C I R C U L A T I N G flap I I I I I I I I I I
12-5.
Clean condenser with low pressure water
–
C
C
C
C
C
C
C
C
C
12-6.Check belt for frayed edges I I I I I I I I I I
12-7.
Check all mounting bolts
I
I
I
I
I
I
I
I
I
I
12-8. Air conditioner filter element I I I I R I I R I I
Page 230 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
2 L O / H Y H O & K H F N
84E012
(1) MIN
(2) MAX
(3) Engine oil dipstick
It is important to keep the engine oil at the
correct level for proper lubrication of your
vehicle’s engine. Check the oil level with
the vehicle on a level surface. The oil level
indication may be inaccurate if the vehicle
is on a slope. The oil level should be
checked either before starting the engine
or at least 5 minutes after stopping the
engine.
The handle of the engine oil dipstick is col-
ored yellow for easy identification.
Pull out the oil dipstick, wipe oil off with a
clean cloth, insert the dipstick all the way
into the engine, then remove it again. The
oil on the stick should be between the
upper and lower limits shown on the stick.
If the oil level indication is near the lowerlimit, add enough oil to raise the level to
the upper limit.
5 H I L O O L Q J
81A147
Remove the oil filler cap and pour oil slowly
through the filler hole to bring the oil level to
the upper limit on the dipstick. Be careful not
to overfill. Too much oil is almost as bad as
too little oil. After refilling, start the engine
and allow it to idle for about a minute. Stop
the engine, wait about 5 minutes and check
the oil level again.
(2) (1)(3)
NOTICE
) D L O X U H W R F K H F N W K H R L O O H Y H O U H J X O D U O \
F R X O G O H D G W R V H U L R X V H Q J L Q H W U R X E O H
G X H W R L Q V X I I L F L H Q W R L O
NOTICE
' R Q R W W R S X S W K H R L O R Y H U W K H
0 $ ; O L P L W 7 R R P X F K R L O F D X V H V
V H U L R X V H Q J L Q H W U R X E O H
Close Open
( ; $ 0 3 / (
