Page 133 of 292

131
RCZ_en_Chap06_conduite_ed01-2015
EXCEEdING THE PROGRAMMEd SPEEd
Pressing the accelerator pedal to exceed the
programmed speed will not have any effect unless you
press the pedal firmly past the point of resistance.
The speed limiter is deactivated temporarily and the
programmed
speed, which is still displayed, flashes.
Returning to the programmed speed, by means of intentional or
unintentional deceleration of the vehicle, automatically cancels the
flashing
of the programmed speed.
EXITING THE SPEE d LIMITER MO d E
F Turn dial 1 to the "0" position: the speed limiter mode is deselected.
It disappears from the display.
OPERATING F AULT
In the event of a speed limiter malfunction, the speed is cleared
resulting
in flashing of the dashes.
Have
it checked by a PEUGEOT
dealer or a qualified workshop.
On a steep descent or in the event of sharp acceleration,
the speed limiter will not be able to prevent the vehicle from
exceeding the programmed speed.
To avoid any risk of jamming of the pedals:
-
ensure that the mat is positioned correctly
,
- do
not fit one mat on top of another.
6/
DRIVING
Page 135 of 292
133
RCZ_en_Chap06_conduite_ed01-2015
dISPLAYS IN THE INSTRUMENT PANEL
The programmed information is grouped together in the instrument
panel screen.
5.
Cruise control of
f / resume indication.
6.
Cruise control mode selection indication.
7.
Programmed speed setting.
PROGRAMMING
F Turn dial 1 to the "CRUISE" position: the cruise control mode is selected but is not switched on
(OFF / Pause).
F
Set the programmed speed by accelerating to
the
required speed, then press button
2
or 3
(e.g.:
70 mph (110 km/h)).
You can then change the programmed speed using
buttons 2 and 3:
-
by + or - 1 mph (km/h) = short press,
-
by + or - 5 mph (km/h) = long press,
-
in steps of + or - 5 mph (km/h) = maintained press.
F
Switch of
f the cruise control by pressing button 4:
the
display confirms that it has been switched off
(OFF / Pause).
F
Switch the cruise control back on by pressing
button
4 again.
6/
DRIVING
Page 136 of 292

134
RCZ_en_Chap06_conduite_ed01-2015
EXCEEdING THE PROGRAMMEd SPEEd
Intentional or unintentional exceeding of the
programmed speed results in flashing of this speed in
the screen.
Return to the programmed speed, by means of
intentional or unintentional deceleration of the vehicle, automatically \
cancels
the flashing of the speed.
EXITING CRUISE CONTROL MO d E
F Turn dial 1 to the "0" position: the cruise control mode is
deselected. It disappears from the display.
OPERATING F AULT
In the event of a cruise control malfunction, the speed is cleared
resulting
in flashing of the dashes.
Have
it checked by a PEUGEOT
dealer or a qualified workshop.
When the cruise control is switched on, be careful if you maintain
the pressure on one of the programmed speed changing buttons:
this may result in a very rapid change in the speed of your vehicle.
Do
not use the cruise control on slippery roads or in heavy traffic.
On a steep descent, the cruise control will not be able to prevent
the vehicle from exceeding the programmed speed.
To avoid any risk of jamming of the pedals:
-
ensure that the mat is positioned correctly
,
- never
fit one mat on top of another.
Page 138 of 292

136
RCZ_en_Chap06_conduite_ed01-2015
deactivation / Activation of the front and rear parking sensors
V
isual assistance
FRONT PARKING
SENSORS
In addition to the rear parking sensors, the front parking sensors are
triggered when an obstacle is detected in front and the speed of the
vehicle is still below 6 mph (10 km/h).
The front parking sensors are interrupted if the vehicle stops for more \
than three seconds in forward gear, if no further obstacles are detected
or when the speed of the vehicle exceeds 6 mph (10 km/h).
This supplements the audible signal by displaying bars in the
multifunction screen which move progressively nearer to the vehicle.
When the obstacle is near, the "Danger" symbol is displayed in
the
screen. The function is deactivated by pressing this button. The indicator lamp
in the button comes on.
Pressing this button again reactivates the function. The indicator lamp in
the button goes off. The sound emitted by the speaker (front or rear) indicates whether the\
obstacle is in front or behind.
Page 139 of 292

137
RCZ_en_Chap06_conduite_ed01-2015
deactivation / Activation of the rear parking sensors
The function is deactivated or activated via the vehicle configuration menu.
The status of the function is stored when the ignition is switched off.
OPERATING FAULT
In the event of a malfunction of the system, when reverse gear
is engaged this warning lamp is displayed in the instrument
panel and/or a message appears in the screen, accompanied
by an audible signal (short beep).
Contact
a PEUGEOT
dealer or a qualified workshop.
In bad weather or in winter, ensure that the sensors are not
covered with mud, ice or snow. When reverse gear is engaged, an
audible signal (long beep) indicates that the sensors may be dirty.
Certain sound sources (motorcycle, lorry, pneumatic drill, etc.)
may trigger the audible signals of the parking sensor system.
The function will be deactivated automatically if a trailer is being
towed
or
a
bicycle
carrier
is
fitted
(vehicle
fitted
with
a
towbar
or
bicycle carrier recommended by PEUGEOT).
6/
DRIVING
Page 141 of 292

139
RCZ_en_Chap07_verifications_ed01-2015
FUEL TANK
Fuel tank capacity: approximately 55 litres.
LOW FUEL LEVEL
R
EFUELLING
When the fuel tank minimum level is reached this warning
lamp comes on on the instrument panel, accompanied by an
audible signal and an alert message. When it first comes on
there remains approximately 5 litres
of fuel in the tank.
Until
sufficient fuel is added, this warning lamp appears every time
the ignition is switched on, accompanied by an audible signal and a
message. When driving, this audible signal and display of the alert
message
are repeated with increasing frequency as the fuel level drops
towards
"0".
Refuel as soon as possible to avoid running out of fuel.
If you run out of fuel (Diesel), refer also to the "Running out of fue\
l
(Diesel)" section.
A
label
affixed to the inside of the flap reminds you of the type of fuel to
be used depending on your engine.
Additions of fuel must be of at least 5 litres, in order to be registere\
d by
the fuel gauge. T
o fill the tank in complete safety:
F the engine must be switched off,
F
press the rear part of the flap, then raise it to open it,
F
turn the cap to the left,
F
remove the cap and hook it onto the clip located on the inside of the
flap,
F
fill the tank, but do not continue after the 3rd cut-off of the
pump; this could cause malfunctions.
Opening
the filler cap may create a noise a caused by an inrush
of air
. This vacuum is entirely normal, resulting from the sealing of
the fuel system.
7/
CHECKS
Page 182 of 292
180
RCZ_en_Chap08_info-pratiques_ed01-2015
Fuse N° RatingFunctions
F13 5 AEngine fusebox, active bonnet.
F14 15 AMultifunction screen, seat belt and
passenger's front airbag warning lamps
display, instrument panel screen,
amplifier,
Bluetooth system, parking
sensors control unit, USB Box.
F15 30 ALocking and deadlocking.
F17 40 ARear screen and door mirrors demist/
defrost.
Fuse N° Rating Functions
G36 30 AHi-Fi
amplifier.
G37 30 APassenger's seat memory unit.
G38 30 ADriver's seat memory unit.
G39 5 ALighting memory unit.
G40 30 ADriver and passenger heated seats.
Box 2
Page 206 of 292

01
204
RCZ_en_Chap10b_RT6-2-8_ed01-2015
Select:
-
the next lower / higher radio
frequency
automatically.
-
the previous / next CD track, MP3
track or media.
-
the left / right of the screen when a
menu is displayed.
Move left / right in "
Move the map" mode.
Abandon the current
operation, up one level
in the menu.
Long press: return to
the permanent display.
Open the
"Configuration
" menu.
Long press: access
to the GPS coverage
and the navigation
demonstration mode.
Open the "Traffic
information" menu
and display the current
traffic
alerts. Select:
-
the previous/next line in a list or menu.
-
the previous / next media folder
.
-
step by step selection of the previous/
next
radio frequency.
-
the previous / next MP3 folder
.
Move up/down, in " Move the map" mode.
FIRST STEPS
Access to the
"Navigation - guidance "
menu and display the
recent destinations.
Short press without the
engine running: on / off.
Short press with the engine
running: audio source off /
restore.
MO
d
E button: Selection
of the type of permanent
display.
Long press: black
screen
(DARK).
Selection
and
confirmation
OK
knob:
Selection of an item on the screen or in a list or a menu,
then
confirmation
with
a
short
press.
Other than for menus and lists, a short press displays a
contextual menu depending on the current screen.
Rotation with map displayed: zoom the map scale in
and out.
Volume adjustment (each
source is independent,
including TA messages and
navigation instructions).