2015 Peugeot RCZ instrument panel

84
RCZ_en_Chap04_visibilite_ed01-2015
WINdSCREEN ANd HEA d LAMP WASH
F Pull the windscreen wiper stalk towards you. The windscreen wash
then the windscreen wipers operate for a fixed period.
The headlamp washers only operate when the dipped or main beam
headlamps are on, with the vehicle moving .
Screenwash/headlamp wash low
In the case of vehicles fitted with headlamp washers, when the minimum level of the reservoir is reached, this warning
lamp and/or the service warning lamp is displayed in the
instrument panel, accompanied by an audible signal and a
message in the screen.
Next

time
you stop, fill the screenwash / headlamp wash fluid reservoir.
The warning lamp is displayed when the ignition is switched on, or
every

time the stalk is operated, until the reservoir is filled.
To

reduce

the

consumption

of

the

fluid

by

the

headlamp

washers,

they operate only with every seventh use of the screenwash or
every 25 miles (40 km) during a given journey

.

90
RCZ_en_Chap05_securite_ed01-2015
TRAjECTORY CONTROL SYSTEMS
dYNAMIC STABILITY CONTROL ( d SC) AN d
ANTI

- SLIP

REGULATION (ASR)
The anti-slip regulation (also known as traction control) optimises
traction to prevent skidding of the wheels, by acting on the brakes of t\
he
driving wheels and on the engine.
The electronic stability control acts on the brake of one or more wheels\

and
on the engine to keep the vehicle on the trajectory required by the
driver

, within the limits of the laws of physics.
Activation
These systems are activated automatically each time the vehicle is
started.
These systems act on the operation of the engine and brakes as soon
as they detect a problem of grip or trajectory. This
is indicated by flashing of this warning lamp in the
instrument panel.
SNOW dRIVING ASSISTANCE
(I NTELLIGENT T RACTION C ONTROL )
Your vehicle has a system to help driving on snow: Intelligent Traction
Control.
This
automatic system continuously checks for situations of difficult
surface

adhesion that could make it difficult to move off or make
progress on deep fresh snow or compacted snow

.
In these situations, Intelligent Traction Control limits the amount of
wheel slip to provide the best traction and trajectory control.
In extremely severe conditions (deep snow, mud…), it can be useful to
temporarily deactivate the dynamic stability control and wheel anti-
slip systems to allow a degree of wheel spin and so recover grip.
It is recommended that the system be reactivated as soon as possible.
Snow tyres are strongly recommended on surfaces offering low levels
of adhesion.

92
RCZ_en_Chap05_securite_ed01-2015
ACTIVE BONNET
Operating fault
The active bonnet has been designed to maximise the safety of
pedestrians in the event of an impact with the front of the vehicle.The deployment of the active bonnet is accompanied by a slight
emission of harmless smoke and a noise, due to the activation
of the pyrotechnic cartridge integrated in the system. The airbag
warning lamp comes on.
After deployment, close the bonnet by pressing on the hinges.
Go
to the nearest PEUGEOT

dealer or a qualified workshop at a
maximum speed of 20 mph (30 km/h). This system can only operate once. If a second impact occurs
(during

the same or a subsequent accident), the active bonnet will
not operate.
After an accident or theft of the vehicle, have the system checked.
Do not handle the pyrotechnic systems, located under the bonnet
near the struts: risk of explosion.
All work on this system must be carried out only by the skilled
personnel

of a PEUGEOT

dealer or a qualified workshop.
If this warning lamp comes on on the instrument panel,
accompanied by an audible signal and a message in the
screen,
contact a PEUGEOT

dealer or a qualified workshop to
have the system checked.

The active bonnet may no longer
be deployed in the event of an impact.

101
RCZ_en_Chap05_securite_ed01-2015
Reactivation
When you remove the child seat, turn the switch to the "ON" position to
reactivate the airbag and so assure the safety of your front passenger i\
n
the event of an impact.
With the ignition on, this warning lamp comes on in the seat
belt and passenger's front airbag warning lamps display for
approximately one minute, if the passenger's front airbag is
activated.
Operating fault
If this warning lamp comes on in the instrument panel,
accompanied by an audible warning and a message in the
screen, contact a PEUGEOT

dealer or a qualified workshop
to have the system checked.

The airbags may no longer be
deployed in the event of a serious impact.
LATERAL AIRBAGS
System which protects the driver and front passenger in the event of a
violent side impact in order to limit the risks of injury to the pelvis,\
chest
and head*.
The lateral airbags are installed on the outer side of the seat:
-

one part in the front seat frame (chest-pelvis airbag),
-


one part in the front head restraint* (head airbag).
deployment
It is deployed unilaterally in the event of a violent impact applied to \
all or part of the side impact zone B, operating at right angles to the
longitudinal axis of the vehicle in a horizontal plane and from the
exterior of the vehicle towards the interior.
The lateral airbag comes between the front occupant of the vehicle and
the corresponding door trim panel.
* Except for the 1.6 THP 270 hp version.
5/
SAFETY

102
RCZ_en_Chap05_securite_ed01-2015
Impact detection zones
A. Front impact zone.
B.
Side impact zone. The airbag may not be deployed in an impact or minor accident on
the side of the vehicle.
The airbag is not deployed in a front or rear impact.
Operating fault
If this warning lamp comes on on the instrument panel,
accompanied by an audible signal and a message in the
screen,
contact a PEUGEOT

dealer or a qualified workshop
to have the system checked.

The airbags may no longer be
deployed in the event of a violent impact.

11 6
RCZ_en_Chap06_conduite_ed01-2015
IGNITION SWITCH
Ignition on position
It allows the use of the vehicle's electric equipment or portable devices to be charged.
Once the state of charge of the battery drops to the reserve level, the \
system switches to energy economy mode: the power supply is cut off
automatically to preserve the remaining battery charge.
In wintry conditions, the warning lamp can stay on for a longer
period. When the engine is hot, the warning lamp does not
come
on.
STARTING-SWITCHING OFF THE ENGINE
It has 3 positions:
-
position 1 (Stop): insert and removing the key,
-
position 2 (Ignition on) : steering column unlocked, ignition on,
Diesel preheating, engine running,
-
position 3 (Starting).
STARTING THE ENGINE
With the parking brake applied and the gearbox in neutral or
position
N or P:
F

depress the clutch pedal fully (manual gearbox),


or
F press
the brake pedal firmly (automatic gearbox),
F

insert the key into the ignition switch; the system recognises
the

code,
F

unlock the steering column by simultaneously turning the steering
and the key

.
F

With a petrol engine, operate the starter motor by turning the key to
position 3

without pressing the accelerator pedal, until the engine
starts. Once the engine is running, release the key.
F

With a Diesel engine, turn the key to position 2

, ignition on, to
operate the engine pre-heating system.
In certain cases, you may have to apply more force to the steering
(wheels on full lock, for example).
Avoid attaching heavy objects to the key, which would weigh down
on its blade in the ignition switch and could cause a malfunction. Switching off the engine leads to a loss of braking assistance. Wait until this warning lamp goes off in the instrument panel
then operate the starter motor by turning the key to position
3
without pressing the accelerator pedal, until the engine starts.
Once the engine is running, release the key.

120
RCZ_en_Chap06_conduite_ed01-2015
HILL START ASSIST
System which keeps your vehicle immobilised temporarily
(approximately 2 seconds) when starting on a gradient, the time it tak\
es
to move your foot from the brake pedal to the accelerator pedal.
OPERATION
This function is only active when:
-

the vehicle is completely stationary
, with your foot on the brake
pedal,
-

certain conditions of slope are met,
-


with the driver
’s door closed.
The hill start assist system cannot be deactivated.
Do not exit the vehicle while it is being held in the hill start assist \
phase.
OPERATING FAULT
On an ascending slope, with the vehicle stationary, the vehicle is
held for a brief moment when you release the brake pedal:
- provided
you are in first gear or neutral on a manual gearbox,
-

provided you are in position d
or M on an automatic gearbox. On a descending slope, with the vehicle stationary and reverse
gear engaged, the vehicle is held for a brief moment when you
release the brake pedal.
If you need to exit the vehicle with the engine running,
apply the parking brake and then check that the
corresponding warning lamp in the instrument panel is on.
If a malfunction of the system occurs, these warning lamps come on.
Have it checked by a PEUGEOT

dealer or a qualified workshop.

3
3
123
RCZ_en_Chap06_conduite_ed01-2015
dISPLAYS IN THE INSTRUMENT PANEL
When you move the gear selector in the gate to select a position, the
corresponding symbol is displayed in the instrument panel.
P. Park
R. Reverse
N. Neutral
d

1... d 6. Drive (Automatic driving)
S. Sport programme
T. Snow programme
M1... M6.


Manual (Sequential driving)
-. Invalid value during manual operation
MOVING OFF
F Apply the parking brake.
F
Select position P

or N.
F

Start the engine.
If this procedure

is not followed, there is an audible signal, accompanied
by a message in the screen.
F

With the engine running, press the brake pedal

.
F

Release the parking brake.
F


Select position R

, d or M,
F

Gradually release the brake pedal.
The vehicle then moves of

f.
If position N is engaged inadvertently while driving, allow the
engine to return to idle then engage position
d

to accelerate.
When the engine is running at idle, with the brakes released, if
position R,
d or M is selected, the vehicle moves even without the
accelerator being pressed.
When the engine is running, never leave children in the vehicle
without supervision.
When carrying out maintenance with the engine running, apply the
parking brake and select position P.
A message is displayed if you try to move the gear selector from
position
P without pressing the brake pedal.
6/
DRIVING