Assuring the purity of AdBlue
®
is particularly
important with respect to avoiding malfunc-
tions in the BlueTEC exhaust ga saftertreat-
ment system.
If AdBlue ®
is pumpe doutof the AdBlue ®
tank,
e.g .during repai rwork, do not us ethisf luid to
refil lthe tank. The purity of the fluid can no
longe rbeg uaranteed.
Capacities Model Total capacity
Al
lm odels 25.5 l
Engine oil
General notes Whe
nhandling engine oil, observe the impor-
tant safety note sonserviceproducts
(Y page 473).
The quality of the engine oi lisdecisive for the
functio nand servic elifeofane ngine.After
extensive tests ,Mercedes-Benz approves
engine oils tha tcorrespond to the current
technica lstandard.
Therefore ,onlyM ercedes-Benz approved
engine oils ma ybeusedinM ercedes-Benz
engines.
Further informatio nontestedand approved
engine oils can be obtained fro many
Mercedes-Benz Service Centre. Mercedes-
Benz recommends tha tyou have the oil
change carrie doutataq uali fied specialist
workshop .Mercedes-Benz approva lisindica-
ted on the oi lcontaine rbythe inscription "MB
Approval "and the corresponding designa-
tion, e.g .MBApproval 229.51.
Yo uc an cal lupano verview of approved
engine oils on the Internet at
http://bevo.mercedes-benz.co mbyenter-
ing the designation, e.g. 229.5.
The table shows which engin eoils have been
approved for your vehicle. Petrol engines:
in certain countries, differ-
ent engin eoils can be used, provided that the
maintenanc eintervals are reduced. For more
information ,please contact aqualified spe-
cialist workshop. Petrol engines MB Approval
All models
229.5
Diesel engines MB Approval
E3
50 CDI 228.51,
229.31 ,229.51 All other models
228.51,
229.31,
229.51 ,229.52 Use only SAE0
W-40orS AE 5W-40 engine oils
for AMG vehicles.
i If the engine oilsl isted in the table are not
available,y ou may add the following engine
oilsu ntil the next oil change:
R vehicles with apetrol engine: MB
Approva l229.1, 229.3 or ACEA A3
R vehicles with adiesel engine: MB
Approva l229.1, 229.3, 229.5 or ACEA
C3
This must only be added once and the
amount must not be greater than 1.0 l.
Ca pacities The following value
srefe rtoano ilchange,
including the oi lfilter. Model Replacement
amount E1
80 6.1 l
E2
00
E2 50 6.3 l478
Servic
eproducts and capacitiesTechnical data
Model Replacement
amount E5
00
E5 00 4MATIC
E3 00 BlueTEC
E3 50 CDI
E3 50 BlueTEC
E3 50 BlueTEC
4MATIC 8.0 l
AMG vehicles
8.5 l
All other models
6.5 l
Additives
!
Do not use any additives with the engine
oil.T his coul ddamage the engine.
Engine oil viscosity Viscosity describes the flow characteristics
of afluid. If an engine oil has ahigh viscosity
rating, it flow sslowly;t he lower the viscosity,
the faster it flows.
Engine oil selection is based on the respective outside temperatures and in accordance with
the SAE classification (viscosity) .The table
show syou which SAE classifications are to be
used. The low-temperature properties of
engine oilsc an be significantly impaired dur-
ing operation due to, for example, ageing or
soot and fuel accretion. It is therefore
strongly recommende dtoobserve regular oil
changes using an approved engine oil with the
appropriate SAE classification. Brake fluid
G
WARNING
The brake flui dcontinuously absorbs mois-
ture from the air. This results in the boiling
point of the brake flui dlowering. If the boiling
point of the brake flui distoo low,v apour
pockets may form when the brakes are sub-
jected to aheavy load. This would impair brak-
ing efficiency. There is arisk of an accident.
Have the brake flui drenewe datthe prescri-
bed intervals.
Comply with the important safety notes for
service products when handling brake fluid
(Y page4 73).
The brake flui dchange interval scan be found
in the Service Booklet.
Only use brake flui dapproved by Mercedes-
Benz according to MB Approva l331.0.
Information about approved brake flui dcan
be obtained at any qualified specialist work-
shop or on the Internet at
http://bevo.mercedes-benz.com.
i Have the brake flui
dregularl yreplaced at
aq ualified specialist worksho pand the
replacement confirmed in the Service
Booklet. Coolant
Important safety notes G
WARNING
If antifreeze comes into contact with hot com- ponents in the engine compartment, it may
ignite. There is arisk of fire and injury.
Let the engine cool downb efore you top up
the antifreeze. Make sure that antifreeze is
not spilled next to the filler neck. Thoroughly
clea nthe antifreeze from components before
starting the engine.
! Only add coolant that has been premixed
with the desired antifreeze protection. You
coul dotherwise damage the engine. Servic
eproducts and capacities
479Technical data Z
