Page 24 of 420

22
You can modify the appearance of the instrument panel, by choosing:
-
a
colour scheme,
-
a
display mode.
Choosing the language
This depends on the setting in the touch screen tablet.
Certain
languages are not available for the type 2
i
nstrument panel; English is selected by default.Each
mode corresponds to the type of
i
nformation displayed in the configurable area.
Personalisation of the
type
2 instrument panel
Choice of display mode
- "DIALS": permanent display of the t
rip computer, rev counter and coolant
t
emperature
i
ndicator.
Display zones
Whatever the display mode or colour scheme chosen, the instrument panel contains
-
a
fixed display zone A
w
ith:
●
t
he speedometer,
●
t
he warning lamps,
●
t
he fuel gauge,
●
t
he various repeated information and
a
lert
m
essages.
-
a
configurable display zone B.
Most
of the warning lamps do not have a fixed
p
osition.
The
warning and indicator lamps in the right
h
and column are displayed from top to bottom
i
n order of importance.
For
certain functions that have indicator lamps
f
or both on and off, there is just one dedicated
lo
cation.
Choosing a colour scheme
It depends on the colour scheme chosen for the touch screen tablet. To modify it with the
v
ehicle
s
tationary:
F
s
elect the " Configuration "
menu of the
t
ouch screen tablet,
F
p
ress the " Color schemes " button,
F
c
hoose a colour scheme,
F
c
onfirm.
T
he system restarts to take account of the
m
odifications to the touch screen tablet
a
nd the instrument panel.
Monitoring
Page 25 of 420
23
- "MEDIA": display of information related to t
he media being played or the radio.-
" NAVIGATION": display of information r
elated to the navigation in progress (map
an
d
in
structions).-
" PHOTOS": display of the photo selected i
n the "Media" menu of the touch screen
t
ablet.
1
M
Page 26 of 420
24
- "DRIVING": used for the display of the i
nter-vehicle time and information related
to
the active cruise control.
T
he recommended speed is displayed in
t
he central part.
T
he driver remains responsible for
o
bserving the driving regulations. To
modify the display mode of the instrument pan
el:
F
t
urn the wheel on the left of the steering
w
heel to display and run through the
d
ifferent modes in the right hand part of the
in
strument
pan
el,F
o nce the selected display mode appears in
t
he central window, it is applied after a few
m
oments.
Monitoring
Page 32 of 420

30
Deactivation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has been switched off intentionally.
T his is may be accompanied by an audible signal and the display of a message.
Warning / indicator lamp StateCause Action / Observations
Passenger's
airbag system fixed.
The
control switch, located at the
r
ight hand end of the dashboard is
s
et to the OFF
p
osition.
The
passenger's front airbag is
d
eactivated.Set the control to the "ON"
position to activate the
passenger's
front airbag.
In
this case, do not fit a child seat in the rear ward-
facing
position.
Dynamic
stability control
(DSC/ASR) fixed.
The
button, located on the centre
c
onsole, is pressed. Its indicator lamp
i
s on.
The
DSC/ASR is deactivated.
DSC:
dynamic stability control.
ASR:
anti-slip regulation.Press
the button to activate the DSC/ASR. Its
i
ndicator lamp goes off.
The
DSC/ASR system is activated automatically when
t
he vehicle is started.
If
deactivated, the system is reactivated automatically
f
rom around 30 mph (50 km/h).
Stop & Star t fixed. The Stop & Start
has been
deactivated. Reactivate the function via the "
Driving assistance"
menu.
Monitoring
Page 34 of 420

32
Warning / indicator lampStateCause Action / Observations
Service temporarily,
a
ccompanied by a
m
essage.One
or more minor faults for which
t
here is no specific warning lamp
h
ave been detected.Identify
the cause of the fault using the message
d
isplayed in the screen.
You
can deal with some problems yourself, such as a
d
oor open or the start of saturation of the particle filter
(
as soon as the traffic conditions allow, regenerate
t
he filter by driving at a speed of at least 40 mph
(
60 km/h), until the warning lamp goes off).
For
any other problems, such as a fault with the tyre
u
nder inflation detection system, contact a CITROËN
d
ealer or a qualified workshop.
fixed,
accompanied by
a
message.One
or more major faults for which
t
here is no specific warning lamp
h
ave been detected.Identify
the cause of the fault using the message
d
isplayed in the screen; you must then contact a
C
ITROËN dealer or a qualified workshop.
fixed,
associated
w
ith the flashing and
t
hen fixed display of
t
he service indicator
span
ner.The
servicing interval has been
e
xceeded.Only
on BlueHDi Diesel versions.
Your
vehicle must be serviced as soon as possible.
Monitoring
Page 42 of 420

40
Service indicator
System which informs the driver when the next service is due, in accordance with the
ma
nufacturer's
ser
vice
s
chedule.
The
point at which the service is due is
c
alculated from the last indicator zero reset,
a
ccording to the mileage covered and the time
e
lapsed since the last service.
For
BlueHDi Diesel versions, depending on the
c
ountry of sale, the degree of deterioration of
t
he engine oil may also be taken into account.
More than 1 800 miles (3 000 km)
remain before the next service is due
When the ignition is switched on, no service information appears in the screen.
Less than 600 miles (1 000 km)
remain before the next service is due
Example: 560 miles (900 km) remain before t
he next service is due.
For
5 seconds after the ignition is switched on,
t
he screen indicates:
Between 600 miles (1 000 km)
and 1 800 miles (3 000 km) remain
before the next service is due
For 5 seconds after the ignition is switched on, the spanner s ymbolising t he ser vice o perations c omes o
n. The distance recorder display line indicates the
d
istance remaining before the next service is due.
Example:
1 700 miles (2 800 km) remain before
t
he next service is due.
For
5 seconds after the ignition is switched on, the
s
creen indicates:
5
seconds after the ignition is switched on,
t
he spanner goes off ;
the distance recorder
r
esumes its normal operation. The screen then
i
ndicates the total and trip distances.5
seconds after the ignition is switched on,
t
he distance recorder resumes its normal
ope
ration.
T
he spanner remains on to
indicate
that a service must be carried out
s
oon.
Monitoring
Page 44 of 420
42
Service indicator zero resetFollowing this operation, if you wish to disconnect the battery, lock the vehicle
a
nd wait at least five minutes for the
z
ero reset to be registered.
After
each
service,
the
service
indicator
must
b
e
reset
to
zero.
If
you
have
carried
out
the
service
on
your
v
ehicle
y
ourself:
F
s
witch
off
the
ignition,
F
p
ress
and
hold
the
trip
distance
recorder
z
ero
reset
button,
F
s
witch
o
n
t
he
i
gnition;
t
he
d
istance
r
ecorder
d
isplay
begins
a
countdown,
F
w
hen
the
display
indicates
"=0" , release
the
button;
the
spanner
disappears.Retrieving the service
information
You can access the service information at any t ime.
F
P
ress the trip distance recorder zero reset
b
utton.
T
he service information is displayed for a
f
ew seconds, then disappears.
Monitoring
Page 45 of 420

43
Engine oil level indicator*
On versions fitted with an electric oil level indicator, the state of the engine oil level is
d
isplayed in the instrument panel for a few
s
econds, after the servicing information.
The
level read will only be correct if
t
he vehicle is on level ground and the
e
ngine has been off for more than
3
0 minutes.
Oil level correct
Oil level incorrect
This is indicated by the display of the message "Oil level incorrect" in the instrument panel
s
creen, accompanied by the service warning
l
amp and an audible signal.
If
the low oil level is confirmed by a check using
t
he dipstick, the level must be topped up to
a
void damage to the engine.
Refer
to the "Checking levels" section.
Oil level indicator fault
This is signalled by the display of the message "Oil level measurement invalid" in the instrument panel.
Contact
a CITROËN dealer or a qualified
w
orkshop.
In the event of a fault with the electric indicator, the oil level is no longer monitored.
If
the system is faulty, you must check the
e
ngine oil level using the manual dipstick
l
ocated under the bonnet.
Refer
to the "Checking levels" section.
* Depending on version.
1
Monitoring