2015 Citroen C4 warning

398
C4-2_en_Chap14_index-alpha_ed01-2015
C4-2_en_Chap14_index-alpha_ed01-2015
Vehicle configuration ................................37,   39
Ventilation .............................. ...................79-80
Warning
 lam

ps
 .......................................... 16

-28
Warning
  lamp,   SCR   emissions  
control
  system  
............................................. 24
W

ash-wipe, rear
 ...............................
............132
Weights
 ...............

..................................277,   281
Welcome
  lighting........................................... 124Window controls
 ............................................
75
W
iper control
stalk
 .............................................1
28,   129,   132
Wiper, rear .................................................... 132
Wipers
 ..............................................2
7,   128 -132
V
W
Under floor storage .......................................
11 6
Under-inflation ( detection) ........................... 19
0
Unlocking
 ..............................

................... 53,   59
Unlocking
  from  
the inside
 ..............................

.......................65
Update
  risk   areas  
......................................... 3

21
Updating
  the   date  
............................... 3
8,   43,   48
Updating
  the   time  
......................... 3
4,   38,   43,   48
UREA
 ...............

.................................... 221, 222
USB
 ........

...................................... 103,   306,   371Xenon
 hea

dlamps
 ...............................
.........242
X
U
alphabetical index

09-14
C4-2_en_Chap15_couv-fin_ed01-2015
C4-2_en_Chap15_couv-fin_ed01-2015
Reproduction or translation of all or part of this document is  prohibited   without   written   authorisation   from  Automobiles  
CITROËN. Automobiles
  CITROËN   declares,   by   application   of   the  
provisions

  of   the   European   regulation   (Directive   2000/53)  
relating

  to   End   of   Life   Vehicles,   that   it   achieves   the  
objectives

  set   by   this   regulation   and   that   recycled   materials  
are

  used   in   the   manufacture   of   the   products   that   it   sells.
Labels   are   fitted   in   various   areas   of   your   vehicle.  
They
 
carry

  safety   warnings   as   well   as   vehicle   identification  
information.

  Do   not   remove   them:   they   form   an   integral  

part
  of   your   vehicle.
We draw your attention to the following points:
For
  any   work   on   your   vehicle,   use   a   qualified   workshop  
that

  has   the   technical   information,   competence   and  
equipment

  required,   which   a   CITROËN   dealer   is   able   to  
provide.
Printed in the EU
Anglais
-
 
The

 
fitting
 
of
 
electrical
 
equipment
 
or
 
accessories
 
not
 
listed

 
by
 
CITROËN may
 
cause
 
faults
 
and
 
failures
 
with

 
the
 
electrical
 
system
 
of
 
your
 
vehicle.
 
Contact
 
a

 
CITROËN
 
dealer
 
for
 
information
 
on
 
the
 
range
 
of
 
recommended

 
accessories.
-
 
Any

 
modification
 
or
 
adaptation
 
not
 
intended
 
or
 
authorised

 
by
 
Automobiles

 
CITROËN
 
or
 
carried
 
out
 
without

 
meeting
 
the
 
technical
 
requirements
 
defined
 
by
 
the

 
manufacturer
 
would
 
lead
 
to
 
the
 
suspension
 
of
 
the
 
new

 
vehicle
 
warranty.

Driving
6
C4-2-add_en_Chap09_conduite_ed01-2015
Stop & Start
Operation
Going into engine STOP mode
The "ECO" warning lamp comes on in the instrument panel and the engine goes into standby automatically:
- with a manual gearbox , at speeds below 12 mph (20 km/h), or vehicle stationary with PureTech 130 petrol and BlueHDi 115 and 120 Diesel versions, when you put the gear lever into neutral and release the clutch pedal, - with an electronic gearbox , at a speed below 5 mph (8 km/h), when you press the brake pedal or place the gear lever in position N . - with an automatic gearbox, vehicle stationary, when you press the brake pedal or place the gear lever in position N .
If your vehicle is fitted with the system, a time counter calculates the sum of the periods in STOP
Special cases: STOP mode unavailable
STOP mode is not invoked when: - the vehicle is on a steep slope (up or down), - the driver's door is open, - the driver's seat belt is not fastened, - the vehicle has not exceeded 6 mph (10 km/h) since the last engine start (using the key or the "START/STOP" button), - the electric parking brake is applied or being applied, - the engine is needed to maintain a comfortable temperature in the passenger compartment, - demisting is active, - some special conditions (battery charge, engine temperature, braking assistance, ambient temperature...) where the engine is needed to assure control of a system.
In this case, the "ECO" warning lamp flashes for a few seconds, then goes of f. This operation is perfectly normal.
The Stop & Start system puts the engine temporarily into standby - STOP mode - during stops in the traffic (red lights, traffic jams, or other...). The engine restarts automatically - START mode - as soon as you want to move off. The restart takes place instantly, quickly and silently. Per fect for urban use, the Stop & Start system reduces fuel consumption and exhaust emissions as well as the noise level when stationary.
STOP mode does not affect the functionality of the vehicle, such as braking, power steering, for example. Never refuel with the engine in STOP mode; you must switch off the ignition
with the key or the "START/STOP" button.
With an electronic gearbox, for your comfort during parking manoeuvres, STOP mode is not available for a few seconds after coming out of reverse g e a r.
mode during a journey. It resets itself to zero every time the ignition is switched on with the key or the "START/STOP" button.

9
Driving7
C4-2-add_en_Chap09_conduite_ed01-2015
Going into engine START mode Special cases: START invoked automatically
The "ECO" warning lamp goes off and the engine starts automatically:
- with a manual gearbox , when you fully
depress the clutch pedal, - with an electronic gearbox : ● gear lever in position A or M , when you release the brake pedal, ● or gear lever in position N and the brake pedal released, when you place the gear lever in position A or M , ● or when you engage reverse gear. - with an automatic gearbox: ● gear lever in position D or M , when you release the brake pedal, ● or gear lever in position N and brake pedal released, when you place the gear lever in position D or M , ● or when you engage reverse gear.
For safety reasons or to ensure smooth operation, START mode is invoked automatically when: - you open the driver's door,
- you unfasten the driver's seat belt, - the speed of the vehicle exceeds 15 mph (25 km/h) with a manual gearbox (3 km/h (2 mph) with PureTech 130 petrol and BlueHDi Diesel 115 and 120 versions), 7 mph (11 km/h) with an electronic gearbox or 2 mph (3 km/h) with an automatic gearbox, - the electric parking brake is being applied, - some special conditions (battery charge, engine temperature, braking assistance, ambient temperature...) where the engine is needed to assure control of a system.
In this case the "ECO" warning lamp flashes for few seconds, then goes of f.
This operation is perfectly normal.
With a manual gearbox in STOP mode, if a gear is engaged without fully depressing the clutch pedal, a warning lamp comes on or an alert message is displayed asking you to depress the clutch pedal to restart the engine.

Driving
8
C4-2-add_en_Chap09_conduite_ed01-2015
Maintenance
In the event of a malfunction with the system, the "ECO OFF" switch warning lamp flashes, then comes on continuously. Have it checked by a CITROËN dealer or a qualified workshop.
Operating fault
This system requires a specific battery with a special specification and technology (reference numbers available from a CITROËN dealer or a qualified workshop). Fitting a battery not listed by CITROËN introduces the risk of malfunction of the system.
Before doing anything under the bonnet, deactivate the Stop & Start system to avoid any risk of injury resulting from automatic operation of START mode.
The Stop & Start system makes use of advanced technology. All work on this type of battery must be done only by a CITROËN dealer or a qualified
workshop.
In the event of a fault in STOP mode, the vehicle may stall. All of the instrument panel warning lamps come on. Depending on version, an alert message may also be displayed asking you to put the gear lever into position Nand put your foot on the brake pedal.
It is then necessary to switch off the ignition, then restart the engine using the key or the "START/STOP" button.
Reactivation
The system is reactivated automatically at every new start using the key or the "START/STOP" button.
Press the "ECO OFF" switch again. The system is active again; this is confirmed by the switch warning lamp going off and the display of a message.
Deactivation
At any time, press the "ECO OFF" switch to deactivate the system. This is confirmed by the switch warning lamp coming on accompanied by the display of a message.
If the system has been deactivated in STOP mode, the engine restarts immediately.

Audio and Telematics
38
C4-2-add_en_Chap13b_SMEGplus_ed01-2015
Hazard zone /
Danger zone
alert settings
Press on Navigation to display the primary page.
Press on the secondary page.
Select " Settings ".
Select " Alarm! ".
It is then possible to activate Risk Areas alerts then: - "Audible warning"
- "Alert only when navigating" - "Alert only for overspeed" - "Display speed limits" - Timing: the choice of timing allows the time before giving a Risk Area alert to be defined.
Select " Confirm ".
This series of alerts and displays is only available if Risk Areas have first been downloaded and installed on the system.
T r a f fi c
Traffic information
Display of messages
Press on Navigation to display the primary page.
Press on the secondary page.
Select " Traffic messages ".
Set the:
" On the route ",
" Around ",
" Near destination ", filters to fine-tune the list of messages.
Press again to remove the filter.

Audio and Telematics
76
C4-2-add_en_Chap13b_SMEGplus_ed01-2015
The following table groups together the answers to the most frequently asked questions concerning your audio system.
Frequently asked questions
Navigation
QUESTIONANSWERSOLUTION
The route calculation is not successful. The route settings may conflict with the current location (exclusion of toll roads on a toll motor way). Check the route settings in the "Navigation" menu.
The POIs do not appear. The POIs have not been selected. Select the POIs in the list of POIs.
The Hazard zone audible warning does not work. The audible warning is not active. Activate audible warnings in the "Navigation" menu.
The system does not suggest a detour around an incident on the route.
The guidance criteria do not take account of TMC messages. Select the "Traffic info" function in the list of route settings.
I receive a Accident-prone area alert which is not on my route.
Other than guidance, the system announces all Hazard zones positioned in a cone located in front of the vehicle. It may provide an alert for a Hazard zone located on nearby or parallel roads.
Zoom in on the map to view the exact position of the Accident-prone area. Select "On the route" to no longer receive alerts other than navigation instructions or to reduce the time for the announcement.