M N
0:: loo ,...., \!) 1.1'1
N 1.1'1 ,....,
Single-trip memory (Trip computer 1)
The s ingle-t rip memory s to res the trip informa
tion from the time the ignition is tu rned on until
it is turned off. If the trip is continued
within 2
hours
from the time the ignition was turned off,
the new data w ill be included in the calculat ion of
the current trip information. If the trip is inter
rupted for
more than 2 hours the memory is re
set automat ically.
Total-trip memory (Trip computer 2)
Unlike the sing le-trip memory, the tota l-trip
memory is not reset automatically. Th is permits
you to evaluate your driving data for the entire pe riod between manual resets.
Operation
The trip computer is controlled by two switches
on the windshield wiper lever.
F ig. 11 Wind shield w iper lever: controls for the trip com
puter
Operating
.. To d isp lay the trip computer memory leve ls,
press the
I RESE T I button @¢ fig. 11 repeated
ly until the des ired memory level is shown in
the d isplay .
.. To display trip information w ith in a memory
level , press the top or bottom part of the func
t ion select io n switch @.
The trip computer will not operate unless the ig
nition is on. When you turn on the ignition, the
function that was in use when you last turned the
i gn ition off will be d isp layed.
In addition to information about the trip comput
er (tr ip computer 1 and 2), information about
other systems can also be shown in the display.
Driver information system
To switch the display between the different infor
mation, tap the
! RESET I button @briefly.
Resetting values to zero
"Select a value in the desired trip computer .
" Press and hold the
I RESET I button @for at
least one second. A ll values in the selected trip
computer are reset to zero .
With some vehi cle equ ipment levels, the values
for the single trip or total trip memory can also
be reset in the Infotainment system
¢page 25.
@ Tips
All stored values w ill be lost if the vehicle bat
tery is disconnected.
Basic Settings for the trip computer
The radio or MMI* operating unit is used for set
ting the trip computer's basic settings.
"Select: Function button !CAR !> Instrument
cluster> On-board computer
1 or On-board
computer
2 .
The values in the single-tr ip or the total-trip
memo ry can all be reset to zero at the same time
un der
Reset in the menu.
In add ition, you can determine what information
from the trip computer should be shown in the
i nst rumen t cl uste r display.
If one of the pieces of
drive r information is tu rned
Off , that driver infor
mation will not be shown in the display. The in
formation will continue to be calculated by the
trip computer and can be turned back
On at any
t ime.
(D Tips
This function is not available on all vehicles.
25
