2014 YAMAHA VIKING ECU

8-8
8
9
10
11
12
13
14
To install 1. Insert the projections on the hood into the slots in the front grill, and then place the
hood in the original position.
2. Turn the hood locks 1/4 turn counter- clockwise, and then push the tab on each
hood lock down so that it is pointing rear-
ward. Make sure that the hood is secure-
ly installed.
NOTICEDo not drive the vehicle with the hood
open, unlatched, or removed.
1XP7B_EE.book Page 8 Tuesday, February 4, 2014 3:40 PM

8-25
1
2
3
4
5
6
78
9
10
11
12
13
14
5B410016Cleaning the air filter elementThe air filter element should be cleaned every
20–40 hours. It should be cleaned and lubri-
cated more often if the vehicle is operated in
extremely dusty areas. Each time air filter ele-
ment maintenance is performed, check the air
inlet to the air filter case for obstructions.
Check the air filter element rubber joint to the
throttle body and manifold fittings for an air-
tight seal. Tighten all fittings securely to avoid
the possibility of unfiltered air entering the en-
gine.NOTICENever operate the engine with the air filter
element removed. This will allow unfiltered
air to enter, causing rapid engine wear and
possible engine damage. Additionally, op-
eration without the air filter element will af-
fect the fuel injection system with
subsequent poor performance and possi-
ble engine overheating.
1. Remove the center passenger seat cush-
ion. (See page 4-18 for seat cushion re-
moval and installation procedures.)
2. Remove the air filter case cover by un- hooking the holders.1. Air filter case cover holder ( × 5)
2. Air filter case cover
2
1 1
1XP7B_EE.book Page 25 Tuesday, February 4, 2014 3:40 PM

8-51
1
2
3
4
5
6
78
9
10
11
12
13
14
4. Unhook the headlight bulb holder.1. Headlight bulb holder
5. Wait for the headlight bulb to cool beforetouching or removing it. Remove the
burnt-out bulb by pulling it out.
6. Place a new headlight bulb into position, and then secure it with the bulb holder.
NOTICE: Do not touch the glass part
of the headlight bulb to keep it free
from oil, otherwise the transparency
of the glass, the luminosity of the
bulb, and the bulb life will be adverse-
ly affected. Thoroughly clean off any
dirt and fingerprints on the headlight
bulb using a cloth moistened with al-
cohol or thinner.
1
1XP7B_EE.book Page 51 Tuesday, February 4, 2014 3:40 PM