2014 VOLVO XC90 Owner´s Manual

09 Maintenance and servicing
Replacing bulbs09
}}
* Option/accessory, for more information, see Introduction.231
G027083
Location of the bulbs in the headlight housing
G027082
Low/high beam (models with Active Bending Lights)*, Low beam (models withHalogen headlights)
High beam 1
(models with Halogen head-
lights)
Turn signal
Parking light
Side marker light
Replacing the low beam bulb (halogen headlights)
G027088
1. Remove the plastic cover over the bulb by turning it counterclockwise.
2. Pull the connector from the lamp housing.
3. Loosen the bulb's retaining spring by first moving it to the right and then moving it out of the way.
4. Pull out the bulb from the holder.
5. Insert the new bulb (without touching the glass) in the holder.
1This bulb has no function on models with the optional Active Bending Lights.

09 Maintenance and servicing
Replacing bulbs 09
232
6. Move the retaining spring up and push itslightly to the left until it seats properly.
7. Press the bulb holder into place on the headlight housing.
8. Reinstall the plastic cap. The letters "HAUT " on the cap must be upward.
Replacing the high beam bulb (halogen headlights)
G027085
1. Remove the rubber cover by pulling it off.
2. Pull the connector from the lamp housing.
3. Loosen the bulb's retaining spring by first
moving it to the right and then moving it out of the way. 4. Pull out the bulb from the holder.
5. Insert the new bulb (without touching the
glass) in the holder.
6. Move the retaining spring up and push it slightly to the left until it seats properly.
7. Press the bulb holder into place on the headlight housing.
8. Press the rubber cover into place.
Replacing parking light/side marker light bulbs
G028409
1. Turn the lamp holder approximately 1/4 turn counterclockwise and pull it out of the headlight housing. 2. Pull the bulb straight out.
3. Align the guide lugs on the side of the
base of the new bulb in the grooves in the holder and press it into place.
4. Press the lamp holder into the place in the headlight housing and turn it approxi-mately 1/4 turn clockwise.
Replacing the turn signal bulb
G027089
1. Turn the lamp holder approximately 1/4turn counterclockwise and pull it out of the headlight housing.
2. Press in the bulb slightly and pull it out of the holder.

09 Maintenance and servicing
Replacing bulbs09
233
3. Align the guide lugs on the side of the
base of the new bulb in the grooves in the holder. Press it in and turn it slightlyclockwise.
4. Press the lamp holder into the place in the headlight housing and turn it approxi-mately 1/4 turn clockwise.
Location of taillight bulbs
Turn signal
Backup light
NOTE
If the message indicating a burned out bulb remains in the information displayafter a bulb has been replaced, consult atrained and qualified Volvo service techni-cian.

09 Maintenance and servicing
Replacing bulbs 09
234
Replacing bulbs in the taillight cluster
1. Switch off all lights and turn ignition keyto position 0.
2. Fold down the lower section of the tail- gate, and fold up the rear section of the cargo area floor. If the vehicle is equippedwith the optional grocery bag holder,detach the holder's bands.
3. Remove the corner panel.
4. Open the cover in the side panel by pull- ing the tab upward and toward you.
5. Loosen the bolts. 6. Pull the entire tail light housing straight
out.
7. Disconnect the wiring.
8. Place the tail light housing on a soft cloth to help avoid scratching the lens.
9. Turn the lamp holder counterclockwise and pull out.
10. Turn the bulb to be replaced counter- clockwise and remove it.
11. Insert a new bulb.
12. Place the lamp holder in the groove and turn clockwise. 13. Press wiring back into place.
14. Align the tail light housing with the holes
for the retaining bolts and press it into place.
15. Tighten the retaining bolts.
16. Reinsert the side and corner panels.

09 Maintenance and servicing
Replacing bulbs09
}}
235
Rear fog light
1. Switch off the ignition.
2. Carefully insert a small screwdriver (seeillustration above).
3. Pry out the lamp housing.
4. Turn the bulb holder counterclockwise and remove it.
5. Turn the bulb counterclockwise and remove it.
6. Insert a new bulb and press the lamp housing back into place.
License plate lights
1. Turn off the lights and switch off the igni-tion.
2. Loosen the retaining screws with a screwdriver.
3. Loosen the bulb housing and pull it out carefully.
4. Pull out the defective bulb and insert a new one.
5. Reinsert the bulb housing and screw it into place.
Front footwell lighting
G027079
The front footwell lights are located under the dashboard on the driver's and passenger'ssides. To replace a bulb:
1. Carefully insert a screwdriver and pry out the lens.
2. Replace the defective bulb.
3. Reinstall the lens.

09 Maintenance and servicing
Replacing bulbs 09
236
Cargo compartment light
1. Carefully insert a screwdriver and pry outthe lens. 2. Pry out the bulb and replace it.
3. Press the lens back into place.
Vanity mirror lights
Removing the lens1. Insert a flat screwdriver under the lens
and carefully exert upward pressure to release the retaining lugs.
2. Snap out the lens.
3. Use needle nose pliers to pull the bulb straight to the side. Replace the bulb. Do not exert too much pressure on the bulbwith the pliers to help avoid damaging it.
Reinserting the lens1. Put the lens back into position.
2. Press it into place.
Bulb specifications
Lighting functionWattageBulb
Low beam (halogen)55H11 LL
High beam (halogen)55H7 LL
Front turn signals21H21W LL

09 Maintenance and servicing
Replacing bulbs09
237
Lighting functionWattageBulb
Front parking lights, front side marker lights, rear courtesy lighting5W5W LL
Turn signals in door mirrors5WY5W LL
Rear fog light21H21W LL
Backup lights21P21W LL
Rear turn signals21PY21W SV
Vanity mirror lighting2W2x4.6d type T5
License plate lighting5C5W LL
Glove compartment5SV8.5 (length 43 mm)
Cargo area lighting10SV8.5 (length 43 mm)
Front footwell lighting5SV8.5 (length 38 mm)
NOTE
Please consult a Volvo retailer’s Parts department for the most up-to-date speci-fications.

09 Maintenance and servicing
Fuses 09
238* Option/accessory, for more information, see Introduction.
Replacing fuses
G032337
Relays/fuse box in the engine compart- ment
Fuse box in the passenger compartment, behind the plastic cover
Fuse box in the passenger compartment, on the edge of the dashboard
Fuse box in the cargo compartment
Fuse box in the cargo compartment 1
.
Additional fuses in cargo compartment (XC90 Executive*) If an electrical component fails to function, itis possible that a fuse has blown. The fuse boxes are located in four different places, see the illustration above. A label on the inside of each cover indicates the amperage and the electrical componentsthat are connected to each fuse. The easiest way to see if a fuse is blown is to remove it. Pull the fuse straight out. If a fuseis difficult to remove, you will find a specialfuse removal tool (and several extra fuses) in the passenger compartment fuse box on thedriver's end of dashboard. From the side,examine the curved metal wire (see the illus-tration) to see if it is broken. If so, put in anew fuse of the
same color and amperage
(written on the fuse). Spare fuses are storedin the fuse box in the engine compartmentand the passenger compartment. If fusesburn out repeatedly, have the electrical sys-tem inspected by a trained and qualifiedVolvo service technician.
1 Certain markets only.