05 Locks and alarm
Alarm
05
* Option/accessory, for more information, see Introduction.133
The alarm is automatically armed whenever you lock your vehicle. When armed, the alarm continuously moni- tors a number of points on the vehicle. Thefollowing conditions will set off the alarm: •
The hood is forced open.
• The tailgate is forced open.
• A door is forced open.
• The ignition switch is tampered with.
• If there is movement in the passenger compartment (if the vehicle is equippedwith the optional movement sensor).
• The vehicle is lifted or towed (if the vehi-cle is equipped with the optional inclina-tion sensor).
• The battery is disconnected (while thealarm is armed).
• The siren is disconnected when the alarmis disarmed.
Arming the alarm1. Press the
LOCK button on the remote
key.
2. Lock the vehicle using the key blade in the driver's door or press the central lock button on the driver's door with the dooropen.
One long flash of the turn signals will confirmthat the alarm is armed.
Movement sensor*In addition to triggering the alarm if there ismovement in the passenger compartment,currents of air may also affect the movementsensor. This means that locking the vehiclewith the windows or the moonroof open, orusing an accessory portable passenger com-partment heater, could trigger the alarm. To help avoid this, close the windows and moonroof before locking the vehicle. If a pas-senger compartment heater is used when thevehicle is locked, direct airflow from the heat-er's vent(s) so that it isn't directed upward inthe passenger compartment.
Disarming the alarmPress the UNLOCK button on the remote key
or unlock the doors with the key blade.
Turning off (stopping) the alarmIf the alarm is sounding, it can be stopped bypressing the UNLOCK button on the remote
key or by unlocking the driver's door with thekey blade.
Visual alarm signalThe visual alarm signal is given by flashing allturn signals and turning on the interior lightingfor approximately 5 minutes.
Audible alarm signalAn audible alarm signal is given by a batterypowered siren. One alarm cycle lasts for25 seconds.
"Panic" buttonIn an emergency situation, this feature can beused to attract attention. Activate the "panic" button by pressing the red button on the remote key ( see page 127for illustration) for at least 3 seconds or bypressing this button twice within 3 seconds.The turn signals will flash, and the vehicle'shorn will sound. The function can be turned off by pressing any of the buttons on the remote key or willstop automatically after 25 seconds. When abutton is pressed, there is a 5 second delaybefore the panic alarm is deactivated.
NOTE
This button will NOT unlock the vehicle.
LED alarm status signalsThe status of the alarm system is indicated by the red LED at the top of the dash: • LED off – the alarm is not armed
• LED flashes once per second – the alarm is armed
