Storage, Luggage Compartment and Roof Transport System 193
Storage
An unsecured or incorrectly positioned load can slip out of place or endanger the vehicle occupants as a result of braking, direction changes or in accidents.fDo not transport items of luggage or objects unsecured in the passenger compartment.fDo not transport any heavy objects in open oddments trays.fAlways keep the covers of the oddments trays closed while driving.fDo not exceed the maximum gross weight and the axle load.This information can be found under “Technical data” in this Owner’s Manual:Please see the chapter “WEIGHTS” on page 288.fAdapt the tire pressure to the load.If you change the tire pressure, you must also update the setting for Tire Pressure Monitoring. Information on tire pressures for partially and fully loaded vehicles can be found under “Technical data” in this Owner’s Manual:Please see the chapter “TIRE PRESSURE FOR COLD TIRES (68 °F/ 20 °C)” on page 287.
Storage options
There are various storage options available, depending on the vehicle equipment:– Drinks holder/cupholder,– in the doors,– in the door sill next to the passenger’s seat,– in the center console, front and rear,– storage net in the passenger’s footwell,
Heavy and bulky objects can damage the storage net.fDo not place any heavy and bulky objects in the storage net.
– behind the rear seat backrests (only with the convertible top closed on the Cabriolet; when opening the convertible top there should not be any objects in the area behind the rear seats – risk of damage),– oddments tray between the seats,– glove box with pen holder,– clothes hooks on back of front seat backrests (depending on vehicle equipment) and on the B-pillars,– enlarged storage space by folding the rear seat backrests forward.
Glove box
An open glove box may cause injury during an accident.fKeep the glove box closed while driving.
On the inside of the glove box lid, there is a clip for holding a pen.
Opening
fPull the latch handle ( arrow) and open the lid.
Locking
fAlways lock the latch handle with the emergency key to secure the contents from unauthorized access.
Unsecured or incorrectly positioned objects or loads
WARNINGh
NOTICE
Open Glove Compartment
WARNINGh
14_991_Turbo_21.book Seite 193 Mittwoch, 9. April 2014 2:19 14
194 Storage, Luggage Compartment and Roof Transport System
Oddments tray in the armrest between the front seats
Opening
fPress the button ( arrow) on the passenger’s side of the armrest.The lid pops up automatically.
Drinks Holder/Cupholder
You can place drinks in the cupholder.
Hot drinks can cause scalding, if spilled, causing potential loss of vehicle control.fOnly use containers that fit.fNever put overfull containers in the cupholder.fDo not use hot drinks.
Risk of damage due to drinks being spilt.fOnly use containers that fit.fNever put overfull containers in the cupholder.
Opening the cupholder
There are two folding cupholders behind the panel above the glove box.
Information
fKeep the cupholders closed while driving.
1. Press the cupholder panel. The panel opens.
Hot Drink SpillsWARNINGh
NOTICE
14_991_Turbo_21.book Seite 194 Mittwoch, 9. April 2014 2:19 14
Storage, Luggage Compartment and Roof Transport System 195
2.Press the symbol for the left or right cupholder.The cupholder folds out.3. Close the panel in the middle so that the cupholder does not move while driving.
The cupholders can be pulled out in order to fit larger containers.
Pulling cupholder out
1. Pull out the holder (arrow). 2. Insert a cup/container. 3. Carefully slide the holder inwards to adjust it to the size of the cup/container.
Folding cupholder in
1. Push cupholder drawer in. 2. Open the panel in the middle. 3. Fold the cupholder in and engage it. 4. Close the panel in the middle.
Ashtray
fNever use ashtray for waste paper disposal, as it could pose a fire hazard.
Opening
1. Press briefly on the ashtray lid. The lid opens automatically.
Emptying
2. To unlock, press ashtray insert forwards at the top right until it is felt to disengage.3. Pull the ashtray insert upwards to remove it.fAfter emptying the ashtray insert, replace it and push it downwards until it is felt to engage.
Ashtray Fire RiskWARNINGh
14_991_Turbo_21.book Seite 195 Mittwoch, 9. April 2014 2:19 14
196 Storage, Luggage Compartment and Roof Transport System
Cigarette Lighter
The tip of the cigarette lighter becomes very hot in use.fDo not leave children in the vehicle unattended.fNever touch the heating element or sides of the lighter.fOnly hold the heated lighter by the knob.
Using the cigarette lighter
The cigarette lighter is ready for use regardless of ignition lock position.fFor information on using charging adapters in the cigarette lighter:Please see the chapter “USING CHARGING ADAPTER FOR 12 VOLT SOCKET/CIGARETTE LIGHTER” on page 197. 1. Press briefly on the ashtray lid. 2. Press the lighter into the receptacle. When the element is red hot, the lighter will jump back to its initial position.
Sockets in the glove box and passenger footwell
Sockets
Electrical accessories can be connected to the 12 V sockets. Depending on the vehicle equipment, these sockets are located in the glove box, the passenger footwell and in the oddments tray in the center console.fFor information on using charging adapters in 12 volt sockets:Please see the chapter “USING CHARGING ADAPTER FOR 12 VOLT SOCKET/CIGARETTE LIGHTER” on page 197.
Information
The maximum electrical load of a socket is 20 A, but only if no other loads are switched on. Do not exceed 10 A per socket if several loads are operating simultaneously.
Cigarette Lighter BurnsWARNINGh
14_991_Turbo_21.book Seite 196 Mittwoch, 9. April 2014 2:19 14
Storage, Luggage Compartment and Roof Transport System 197
Socket in the oddments tray between the front seats
Information
The sockets and thus the connected electrical accessories function even if the ignition is switched off or the ignition key is removed.
If the engine is not running and the accessories are switched on, the vehicle battery will be discharged. The power supply is interrupted after 30 minutes to protect the vehicle battery. If the load is to be switched on again, the ignition must be switched on once.
A - Suitable charging adapter B - Unsuitable charging adapter
Using charging adapter for 12 volt socket/cigarette lighter
Risk of damage to the electrical system.fOnly use a suitable charging adapter ( A) that meets the following requirements:The distance 1 between the ground connection and the upper edge of the charging adapter must be less than approx. 0.63 in. (16 mm).
Unsuitable charging adapters ( B) with a larger distance 1 than 0.63 in. (16 mm) between the ground connection and the upper edge can destroy the sockets.
Luggage Compartment
fPlease see the chapter “OPENING AND CLOSING THE LUGGAGE COMPARTMENT LID AND ENGINE COVER” on page 24.
NOTICE
14_991_Turbo_21.book Seite 197 Mittwoch, 9. April 2014 2:19 14
198 Storage, Luggage Compartment and Roof Transport System
Tire sealant
The tire sealant is located in plastic box A.fGrasp plastic box A at the handle recess and remove.fTo insert the plastic box, first insert the tab at the rear.Engage the box at the front.
C - Towing lug D - Tool kit E - Crank for emergency operation of sliding roof F - Adapter for security wheel bolts G - Plastic wedge for emergency operation of PDK selector lever
Tools
The tools are located in plastic box B.fGrasp plastic box B at the handle recess and remove.fTo insert the plastic box, first insert the tab at the rear.Engage the box at the front.
Tire filling compressor
Removing the tire filling compressor
1. Lift plastic cover A at the handle recesses (arrows) until the clips are heard to disengage and pull forwards slightly.2. Lift the plastic cover at front.
14_991_Turbo_21.book Seite 198 Mittwoch, 9. April 2014 2:19 14
Storage, Luggage Compartment and Roof Transport System 199
3.Unclip retaining strap B on the underside of the plastic cover and attach to the luggage compartment lid.
4. Open the cover of the storage compartment for the tire filling compressor.5. Remove the tire filling compressor from the storage compartment.
Stowing the tire filling compressor
1. The tire filling compressor is wedge-shaped. Insert the tire filling compressor in the storage compartment so that the narrower side faces forwards ( illustration). 2. Close the cover of the storage compartment for the tire filling compressor.
3. Detach retaining strap B and clip onto the plastic cover.4. Insert plastic cover A with the guides at the rear edge and lay it on the yellow holder. Lower the plastic cover at the front.5. Ensure that the centering pins on the underside of the cover engage in the guide.Press the cover downwards at the handle recesses until the clips are heard to engage.
14_991_Turbo_21.book Seite 199 Mittwoch, 9. April 2014 2:19 14
200 Storage, Luggage Compartment and Roof Transport System
Roof Transport System
A roof transport system can be fitted on the vehicle for transporting various sports and hobby equipment.
Various objects can be transported safely and securely using the roof transport system and additional attachments, e.g. ski rack, bicycle rack, surfboard rack, roof box or snowboard holder.fOnly use roof transport systems that have been tested and approved by Porsche. It is not possible to fit commercially available roof rack systems.
fInstall individual load-carrying devices, such as ski rack or roof box as centrally as possible with respect to the supports.fDo not exceed the permissible roof load, permissible gross weight and permissible axle loads.Details of these weights and loads can be found under “Technical data” in this Owner’s Manual:Please see the chapter “WEIGHTS” on page 288.fDistribute load evenly, with heavy items as low as possible. Items of luggage must not project beyond the side of the load area.fFix and secure every item to the basic carrier with a rope or lashing strap (do not use elastic rubber tensioners).fBefore every trip, and at regular intervals during long trips, check that the Roof Transport System and load are secure. Re-tighten if necessary and secure further by locking. Tighten all fastening screws again.
When the Roof Transport System is loaded, the maximum speeds depends on the nature, size and weight of the load being carried.fDriving, braking and steering behavior change due to the higher center of gravity and the greater wind resistance. You should adapt your driving style accordingly.Nevertheless, Porsche recommends that you do not exceed the posted speed limit.fNever drive faster than 80 mph (130 km/h) when the Roof Transport System is fitted and loaded.fWith the basic carrier fitted and no load, do not exceed a maximum speed of 110 mph (180 km/h).
Washing the vehicle in a car wash or failure to observe the overall vehicle height or the maximum permitted gross weight can damage the vehicle or roof transport system.fRemove the complete roof transport system before washing the vehicle in a car wash.fCheck the overall vehicle height with the roof transport system fitted before driving into multi-storey car parks, garages, underground garages and tunnels.fDo not exceed the permissible roof load, permissible gross weight and permissible axle loads.Details of these weights and loads can be found under “Technical data” in this Owner’s Manual:Please see the chapter “WEIGHTS” on page 288.
A - Front carrier (long) B - Rear carrier (short) C - Cover trims D - Torque wrench E - Key
Fitting the roof transport system
When fitting the roof transport system for the first time, the front and rear carrier must be adjusted according to the width of the vehicle.
Roof Load InstabilityWARNINGh
NOTICE
14_991_Turbo_21.book Seite 200 Mittwoch, 9. April 2014 2:19 14