Page 30 of 368
28
Monitoring
Operation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has come into operation.
It may be accompanied by an audible signal and a message in the instrument panel screen.
Warning lamp
is on
Cause
Action / Observations
Left-hand
direction
indicator
flashing with audible
warning. The lighting stalk has been pressed
downwards. If this indicator lamp flashes abnormally quickly, this
could indicate that the bulb of one of the direction
indicators has blown. Change the bulb or contact a
PEUGEOT dealer or a qualified workshop.
Right-hand
direction
indicator
flashing with audible
warning. The lighting stalk has been pushed
upwards. If this indicator lamp flashes abnormally quickly, this
could indicate that the bulb of one of the direction
indicators has blown. Change the bulb or contact a
PEUGEOT dealer or a qualified workshop.
Sidelamps
or
dipped beam
headlamps
fixed. The sidelamps or dipped beam
headlamps are on.
Main beam
headlamps
fixed. The lighting stalk is pulled towards
you. Pull the stalk to return to dipped beam headlamps.
Front foglamps
fixed. The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off
the front foglamps.
Rear foglamp
fixed. The rear foglamp is switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamp.
Page 190 of 368
188
Practical information
Changing a bulb
For bulbs that have alignment lugs
(H1, H7...) ensure that they are
fitted correctly for the best lighting
performance. The headlamps have polycarbonate
lenses with a protective coating:
)
do not clean them using a dr y
or abrasive cloth, nor with a
detergent or solvent product,
)
use a sponge and soapy water,
)
when using a high pressure
washer on persistent marks, do not
keep the lance directed towards
the lamps or their edges for too
long, so as not to damage their
protective coating and seals.
)
Do not touch the bulb directly with
your fingers, use lint-free cloths.
Changing a bulb should only be done
after the headlamp has been switched
off for a few minutes (risk of serious
burns).
It is imperative to use only anti-
ultraviolet (UV) type bulbs in order not
to damage the headlamp.
Always replace a failed bulb with a
new bulb with the same type and
specification.
Risk of electrocution
Replacement of the xenon bulbs
(D1S-35W) must be carried out by
a PEUGEOT dealer or a qualified
workshop.
Front lamps
1.
Direction indicators
( W Y21W-21W ).
2.
Main beam headlamps (H1- 55W).
3.
Dipped beam headlamps (H11- 55W)
or
Xenon bulb (D1S-35W).
4.
Sidelamps (W5W- 5W).
5.
Daytime running lamps
(P13W-13W ).
6.
Daytime running lamps / sidelamps
(light emitting
diodes
-LEDs).
7.
Front foglamps
(H11-55W).
Page 192 of 368
190
Practical information
Changing sidelamp
bulbs (4)
)
Remove the protective plastic cover.
)
Turn the bulb holder to the left and pull it
out.
)
Remove the bulb and its base by pressing
on the lug at the bottom.
)
Change the bulb.
For reassembly, carry out these operations in
reverse order.
Changing main beam headlamp
bulbs (2)
)
Turn the bulb holder a quarter turn to the
left and pull it out.
)
Pull out the bulb and replace it.
To reassemble, carry out these operations in
reverse order.
Changing the daytime
running lamps / sidelamps
(light- emitting diodes - LEDs) (6)
For the replacement of this type of LED lamp,
contact a PEUGEOT dealer or a qualified
workshop.
Changing dipped headlamp
bulbs (3)
For the replacement of these bulbs, contact a
PEUGEOT dealer or a qualified workshop.
To replace these bulbs contact a PEUGEOT
dealer or a qualified workshop.
Changing front foglamp
bulbs (7) / daytime running
lamp bulbs (5)
Page 195 of 368
193
7
Practical information
Changing a foglamp
bulb (3)
Access is by passing a hand under the bumper.
)
Turn the bulb holder a quarter of a turn and
pull it out.
)
Disconnect the connector on the bulb
holder.
)
Pull the bulb out and change it.
To refit, carry out these operations in
reverse order.
You can also contact a PEUGEOT dealer or
a qualified workshop for the replacement of
this bulb.
Changing a reversing lamp bulb (4)
You can also contact a PEUGEOT dealer or
a qualified workshop for the replacement of
this bulb.
Access is by passing your hand under the
bumper.
)
Turn the bulb holder a quarter of a turn and
pull it out.
)
Disconnect the bulb holder.
)
Pull the bulb out and change it.
To reassemble, carry out these operations in
reverse order.
Changing number plate lamp
bulbs (2)
)
Push the lens to the left and then down.
)
Turn the bulb holder a quarter turn to the
left and pull it out.
)
Remove the bulb and change it.
To refit, carry out these operations in reverse
order and press on the lens to clip it in place.
Third brake lamp (light emitting
diodes - LEDs) (1)
Contact a PEUGEOT dealer or qualified
workshop for the replacement of this type
of lamp.
Page 344 of 368
342
Visual search
Exterior
Lighting c ontrols 13 3 -137
Headlamp beam adjustment 139
Welcome lighting 138
Changing bulbs 188 -191
- front lamps
- foglamps
- direction indicator repeaters
Wiper c ontrols 140 -143
Changing a wiper blade 203
Door mirrors 87- 88
Doors 72, 74
- opening / closing
- central locking
Child lock 176
Electric windows 78-79
Alarm 75 -77
Panoramic sunroof 80
Roof bars 209
Accessories 210 -211
Braking assistance 148 -149
Trajectory control 150 -151
Tyre pressures 180, 241
Boot 73
- opening / closing
- emergency release
Temporary puncture repair kit 177-180
Changing a wheel 181-186
- tools
- removing / refitting
Snow chains 187
Changing bulbs 192-193
- rear lamps
- 3rd brake lamp
- number plate lamps
- foglamp
Parking sensors 129 -131
Reversing camera 132
Towbar 207-208
Towing 204-206
Fuel tank 216
Remote control key /
electronic key 62-71
- opening / closing
- anti-theft protection
- battery
