Page 9 of 245
In brief7Seat adjustmentSeat positioning
Pull handle, slide seat, release
handle.
Seat adjustment 3 50, Seat position
3 49.
9 Danger
Do not sit nearer than 25 cm from
the steering wheel, to permit safe
airbag deployment.
Seat backrests
Turn handwheel. Do not lean on seat when adjusting.
Seat adjustment 3 50, Seat position
3 49, Folding front passenger seat
backrest 3 52.
Seat height
Lever pumping motion
up=higherdown=lower
Seat adjustment 3 50, Seat position
3 49.
Page 10 of 245
8In brief
Seat inclination
Pull lever, adjust inclination by
shifting body weight. Release lever
and audibly engage seat in position.
Seat adjustment 3 50, Seat position
3 49.
Head restraint adjustment
Press release button, adjust height,
engage.
Head restraints 3 47.
Seat belt
Pull out the seat belt and engage in
belt buckle. The seat belt must not be twisted and must fit close against the
body. The backrest must not be tilted
back too far (maximum approx. 25 °).
To release belt, press red button on
belt buckle.
Seat belts 3 54, Airbag system
3 57, Seat position 3 49.
Page 43 of 245

Keys, doors and windows41Retractable hardtop9Warning
Take care when operating the
convertible hardtop. Risk of injury. Monitor the action zone above, to
the side and to the rear of the
vehicle during roof operation.
Make sure that nothing could
become pinched. Make sure no
one is in the action zone of the roof
or boot lid during roof operation.
Risk of injury.
Check the amount height, length
and width of available space
before operating the roof, e. g. in a
garage, parking garage or when a bicycle rack is fitted.
Vehicle passengers should be
informed accordingly.
Before leaving the vehicle, remove
the ignition key in order to prevent unauthorised operation of the
windows and sunroof.
Stand-by with key in ignition switch from position 1, or for Open&Start-
System switch on ignition.
Requirements: ■ Vehicle is stationary or driving no more than 30 km/h
■ Load compartment blind is closed and engaged 3 73
■ Boot lid is closed
If any of these requirements are not
fulfilled, a warning buzzer sounds
when the switch is actuated and the
roof does not open or close.
OpenThere must be no objects in front of
the rear window or in the pivot area of the roof and boot lid.
Hold button > in the roof console
depressed until the roof is completely
open and the boot lid is closed.
An acoustic signal sounds at the end
of the opening procedure.
The door windows are opened slightly before the roof is opened. If button
> is pressed again after the
acoustic signal sounds, the door
windows will close.
Open with remote control
Page 46 of 245

44Keys, doors and windows
The convertible roof must not be
operated if the anti-roll bars have
been deployed. A continuous warning will sound if the switch is actuated.
The airbag control indicator v
illuminates if the anti-roll bars have
been deployed.
Note
Do not place any objects on the
covers of the anti-roll bars behind
the head restraints.
Extended anti-roll bars can be
retracted (e.g. in order to close the
roof after a collision).
Press the lever between the rods of
an anti-roll bar to unlock the system.
Push the anti-roll bar all the way down
until it engages. Fit the cover.
Repeat the procedure on the other
anti-roll bar.
Control indicator v will remain
illuminated and the anti-roll bars will not deploy in the event of another
collision. Seek the assistance of a workshop.9 Warning
The roof cannot be closed or
opened if the anti-roll bars are
extended. The anti-roll bars must
first be retracted.
After deployment of the anti-roll
bar, have the system repaired by
a workshop immediately.
Manually retracted anti-roll bars
will not deploy in the event of a
collision.
Load compartment
The roof can only be opened if the
load in the load compartment does
not exceed the height of the load
compartment blind or protrude
sideways. The load height must not
be exceeded. The load compartment
blind must be flat; objects below it must not press it upwards. Otherwise the roof and load may be damaged.
Blockage of boot lid
To avoid damage to the open roof,
boot lid or load, the boot lid can only
be closed if the electric load aid is in
the lower end position 3 77.
Page 48 of 245
46Keys, doors and windows
Insert the guide clips of the wind
deflector in the seat belt recesses
between the rear head restraints.
Pull the toggle of the right and left
locking pin and turn to lock.
Straighten out the wind deflector, turn
the toggle back and engage the
locking pin in the recess in the side
trim.
The wind deflector can be folded back when not in use.
If the wind deflector is folded and the
rear seats are unoccupied, the wind
deflector can remain mounted in the
vehicle when the roof is closed.
Removing
Remove in reverse order, wind
deflector is completely folded down in
the load compartment:
■ for tyre repair kit in the compartment below the loading
floor cover
■ for version with spare wheel , place
in load compartment
The wind deflector must never
protrude upwards or sideways above
the permissible loading height.
Page 49 of 245
Seats, restraints47Seats, restraintsHead restraints............................ 47
Front seats ................................... 49
Rear seats ................................... 53
Seat belts ..................................... 54
Airbag system .............................. 57
Child restraints ............................. 61Head restraints
Position9 Warning
Only drive with the head restraint
set to the proper position.
The upper edge of the head restraint
should be at upper head level. If this
is not possible for extremely tall
people, set to highest position, and
set to lowest position for small people.
Adjustment
Front and rear outboard head
restraints
Press the button, adjust height and
engage.
Page 51 of 245

Seats, restraints49
Note
Approved accessories may only be
attached to the front passenger seat head restraint if the seat is not in use.Front seats
Seat position9 Warning
Only drive with the seat correctly
adjusted.
■ Sit with buttocks as far back against
the backrest as possible. Adjust the distance between the seat and the
pedals so that legs are slightly
angled when pressing the pedals.
Slide the front passenger seat as
far back as possible.
■ Sit with shoulders as far back against the backrest as possible.
Set the backrest rake so that it is possible to easily reach the
steering wheel with arms slightly bent. Maintain contact between
shoulders and the backrest when
turning the steering wheel. Do not
angle the backrest too far back. We recommend a maximum rake of
approx. 25°.
■ Adjust the steering wheel 3 86.
■ Set seat height high enough to have a clear field of vision on allsides and of all display instruments.
There should be at least one hand
of clearance between head and the
roof frame. Your thighs should rest
lightly on the seat without pressing
into it.
■ Adjust the head restraint 3 47.
■ Adjust the height of the seat belt 3 55.
Page 53 of 245
Seats, restraints51
Seat height
Lever pumping motion
up=seat higherdown=seat lowerSeat inclination
Pull lever, adjust inclination by
shifting body weight. Release lever
and audibly engage seat in position.
Lumbar support
Turn handwheel. Do not lean on
backrest when adjusting.