2014 MITSUBISHI OUTLANDER SPORT fuses

Modification/alterations to th
e electrical or fuel systemsGeneral information 2-15
2
zTy r e s a n d w h e e l s w h i c h d o n o t m e e t s p e c -ifications must not be used.Refer to the “Specifications” section forinformation regarding wheel and tyresizes.
Due to large number of accessory andreplacement parts of different manufacturesavailable in the market, it is not possible, notonly for MITSUBISHI MOTORS, but also aMITSUBISHI MOTORS Authorised ServicePoint, to check whether the attachment orinstallation of such parts affects the overallsafety of your MITSUBISHI-vehicle.Even when such parts are officially author-ised, for example by a “general operators per-mit” (an appraisal for the part) or through theexecution of the part in an officially approvedmanner of construction, or when a singleoperation permit following the attachment orinstallation of such parts, it cannot bededuced from that alone, that the drivingsafety of your vehicles has not been affected.Consider also that there basically exists noliability on the part of the appraiser or theofficial. Maximum safety can only be ensuredwith parts recommended, sold and fitted orinstalled by a MITSUBISHI MOTORS
authorised Service Point (MITSUBISHIMOTORS GENUINE replacement parts andMITSUBISHI MOTORS accessories). Thesame also pertains to modifications ofMITSUBISHI vehicles with respect to theproduction specifications. For safety reasons,do not attempt any modifications other thanthose that follow the recommendations of aMITSUBISHI MOTORS authorised ServicePoint.
E00200400368
MITSUBISHI MOTORS CORPORATIONhas always manufactured safe, high qualityvehicles. In order to maintain this safety andquality, it is important that any accessory thatis to be fitted, or any modifications carriedout which involve the electrical or fuel sys-tems, should be carried out in accordancewith MITSUBISHI guidelines.
E00200500499
MITSUBISHI MOTORS has gone to greatlengths to bring you a superbly crafted auto-mobile offering the highest quality anddependability.Use MITSUBISHI MOTORS GENUINEParts, designed and manufactured to maintainyour MITSUBISHI MOTORS automobile attop performance. MITSUBISHI MOTORSGENUINE Parts are identified by this markand are available at all MITSUBISHIMOTORS Authorised Service Points.
E00200600155
Important points!
Modification/alterations to the electrical or fuel systems
CAUTIONzIf the wires interfere
with the vehicle body or
improper installation methods are used (pro-tective fuses not included, etc.), electronicdevices may be adversely affected, resultingin a fire or other accident.
Genuine Parts Safety and disposal informa-tion for used engine oil
WA R N I N GzProlonged and repeated contact maycause serious skin disorders, includingdermatitis and cancer.zAv o i d c o n t a c t w i t h t h e s k i n a s f a r a s p o s s i -ble and wash thoroughly after any con-tact.
BK0203201EN.book 15 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Emergency starting
For emergencies 9-3
9
2. Turn off all lamps, heater and other elec-trical loads.3. Set the parking brake firmly on each vehi-cle. Set the gear of another vehicle in “P”(PARK) position (with A/T) or in “N”(Neutral) position (with M/T) and stop theengine.4. Open the bonnet, remove the fuse coverof the main fuse block.Refer to “Bonnet” on page 11-3 and“Fuses: Engine compartment” on page11-16.
5. Open the cover of the jumper cable termi-nal in the main fuse block.
6. Connect one end of one jumper cable to the jumper cable terminal (A) of yourvehicle, and the other end to the posi-tive (+) terminal of the booster battery(B).Connect one end of the other jumper cable to the negative (-) terminal of thebooster battery, and the other end tothe designated ground location of yourvehicle.
WA R N I N GzWhen connecting the jumper cable, stopthe engine in another vehicle. Otherwise,the cables or your cl
othes may be caught
by the fan or drive belt and personalinjury could result.zThe cooling fan turns on and off depend-ing on the coolant temperature. Do notbring your hands close to the fan while theengine is running or Plug-in Hybrid EVSystem is operating.
NOTE
zYo u c a n n o t r e s c u e o t h e
r vehicle’s discharged
battery by connecting jumper cables usingthis jumper cable terminal.
BK0203201EN.book 3 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

11
MaintenanceService precautions ......................................................................... 11-2Catalytic converter .......................................................................... 11-3Bonnet ............................................................................................. 11-3Engine oil ........................................................................................ 11-5Engine coolant/Plug-in hybrid EV system coolant ......................... 11-6Wa s h e r f l u i d . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 - 7Brake fluid ...................................................................................... 11-7Auxiliary battery ............................................................................. 11-8Ty r e s . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 - 9Wiper blade rubber replacement ................................................... 11-12General maintenance .................................................................... 11-14Fusible links .................................................................................. 11-15Fuses ............................................................................................. 11-15Replacement of lamp bulbs .......................................................... 11-21
BK0203201EN.book 1 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

General maintenance11-14 Maintenance
11
3. Slide a new wiper blade through the hook(B) on the wiper arm.
4. Firmly insert the retainer (C) into thegroove (D) in the wiper blade.Refer to the illustration to ensure that theretainers are correctly aligned as youinsert them into the groove.
E01002701556
Look under the body of your vehicle to checkfor fuel, engine coolant, oil and exhaust gasleaks.Operate the combination lamp switch tocheck that all lamps are functioning properly.If the lamps do not illuminate, the probablecause is a blown fuse or defective lamp bulb.Check the fuses first. If there is no blownfuse, check the lamp bulbs.For information regarding the inspection andreplacement of the fuses and the bulbs, referto “Fuses” on page 11-15 and “Replacementof lamp bulbs” on page 11-21.
NOTE
zDo not allow the wiper arm to fall onto thewindows glass; it could damage the glass.
NOTE
zIf a retainer is not supplied with the newwiper blade, use the retainer from the oldblade.
General maintenance Fuel, engine coolant, oil and exhaust gas leakage
WA R N I N GzIf you see a suspicious
fuel leak or if you
smell fuel, do not operate the vehicle; callyour MITSUBISHI MOTORS Author-ised Service Point for assistance.
Exterior and interior lamp operation
BK0203201EN.book 14 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Fusible links
Maintenance 11-15
11
If the fuses and bulbs are all OK, we recom-mend you to have your vehicle checked andrepaired.Start the plug-in hybrid EV system and checkthe operation of all instruments, gauges andindicator and warning lamps.If there is anything wrong, we recommendyou to have your vehicle inspected.Check all latches and hinges, and, if neces-sary, have them lubricated.
E01002901633
The fusible links will melt to prevent a fire ifa large current attempts to flow through cer-tain electrical systems.In case of a melted fusible link, we recom-mend you to have your vehicle inspected.For the fusible links, please refer to “Passen-ger compartment fuse location table” on page11 -17 a nd “Engine co mpa rtment fuse loc a-tion table” on page 11-18.
E01003003332E01011800035
To p r e v e n t d a m a g e t o t h e e l e c t r i c a l s y s t e mdue to short-circuiting or overloading, eachindividual circuit is provided with a fuse.There are fuse blocks in the passenger com-partment and in the engine compartment.The fuse blocks in the passenger compart-ment are located behind the fuse lid in frontof the driver’s seat at the position shown inthe illustration.Pull the fuse lid to remove it.
The fuse blocks in the passenger compart-ment are located behind the glove box at theposition shown in the illustration.
Meter, gauge and indica-tor/warning lamps operation Hinges and latches lubrication Fusible links
WA R N I N GzFusible links must not be replaced by anyother device. Failing to fit the correct fusi-ble link may result in fire in the vehicle,property destruction and serious or fatalinjuries at any time.
Fuses Fuse block location Passenger compartment (LHD vehicles)
A- Main fuse blockB- Sub fuse blockPassenger compartment (RHD vehicles)
BK0203201EN.book 15 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Fuses11-16 Maintenance
11
1. Open the glove box.2. Uncouple the rod (A) on the right side ofthe glove box.
3. While pressing the side of the glove box,unhook the left and right hooks (B) andlower the glove box.4. Remove the glove box fastener (C), andthen remove the glove box.
When changing the fuse of the sub fuseblock, perform it with the hole of the bottomcover.
E01011900023
In the engine compartment, the fuse block islocated as shown in the illustration. Whilepressing the tab (C), pull up the cover.
A- Main fuse blockB- Sub fuse blockMain fuse block
Sub fuse block
Engine compartment
BK0203201EN.book 16 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Fuses
Maintenance 11-17
11
E01007701753
The fuse capacity and the names of electricalsystems protected by the fuses are indicatedon the inside of the fuse lid (LHD vehicles),the back side of the glove box (RHD vehi-
cles) and inside of the fuse block cover(inside of the engine compartment).
E01007900790
A- Main fuse blockB- Sub fuse blockFuse load capacity
NOTE
zSpare fuses are provided on the cover ofmain fuse block in the engine compartment.Always use a fuse of the same capacity forreplacement.
Passenger compartment fuse loca-tion table
Main fuse block
Sub fuse block(LHD)Sub fuse block(RHD)
No.
Symbol
Electrical sys-
tem
Capacity
1
Electric win-dow control
30 A
*
2
Rear window demister
30 A
*
3 Heater 30
A
4
Wi n dsc reen wipers
30 A
5
Door locks 20 A
6
Rear fog lamp 10 A
7
Accessory socket
15 A
8
Rear window
wiper
15 A
9
Sunroof 20 A
10 Ignition
switch 10
A
11 Option 10
A
12
Hazard warn-ing flasher
15 A
13
4-wheel drive
system
10 A
14
Stop lamps(Brake lamps)
15 A
15
Instruments 10 A
BK0203201EN.book 17 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分

Fuses11-18 Maintenance
11
*: Fusible linkzSome fuses may not be installed on yourvehicle, depending on the vehicle modelor specifications.
zThe table above shows the main equip-ment corresponding to each fuse.
E01008001867
16
SRS airbag 7.5 A
17
Radio 15 A
18
Control unit
relay
7.5 A
19
Interior lamps(Room lamps)
15 A
20
Reversing lamps
(Backup lamps)
7.5 A
21
Heated door
mirror
7.5 A
22
Outside rear-view mirrors
10 A
23
Cigarette lighter/Accessory socket
15 A
24
Charge 7.5 A
25
Power seat 30 A
*
26
Heated seat 30 A
No.
Symbol
Electrical sys-
tem
Capacity
Engine compartment fuse location table Behind of the fuse block coverMain fuse block
No.
Sym-bol
Electrical sys-
tem
Capacities
SBF1
Air condition-ing condenser fan motor
30 A
*
SBF2 — — —SBF3 — — —SBF4
Radiator fan
motor
40 A
*
SBF5
Anti-lock brak-ing system
40 A
*
SBF6 — — —SBF7
Anti-lock brak-ing system
30 A
*
BF1
Electric tailgate 30 A
BF2
Audio system
amp
30 A
BF3 IOD IOD 30 ABF4 — — —F1 — — —F2
Wiper deicer 15A
F3 — — —F4
Daytime run-ning lamps
10 A
F5
Front fog lamps 15 A
F6 — — —
BK0203201EN.book 18 ページ ２０１３年１１月１９日　火曜日　午前１１時５０分