Keyless operation system
Locking and unlocking 4-11
4
E00305901715
In order to prevent vehicle theft or the accidental operation of
the keyless operation system, the buzzer and the display on th
e information screen
in the multi-information display are used to alert the driver.If a warning is activated, always check the vehicle and the keyless operation key. The warning is also displayed if there is a
fault in the keyless
operation system.
NOTE
zFunctions can be modified as stated below.For further information, please contact yourMITSUBISHI MOTORS Authorised ServicePoint.On vehicles equipped with Mitsubishi Multi-Communication System (MMCS), screenoperations can be used
to make the adjust-
ment. Refer to the se
parate owner’s manual
for details.
•Set the confirmation function (blinking ofthe turn-signal lamps) to operate only whenthe vehicle is locked or only when the vehi-cle is unlocked.•Disable the operation confirmation function(blinking of the turn-signal lamps).•Change the number of blinks for the opera-tion confirmation function (blinks of theturn-signal lamps).NOTE
Wa r n i n g a c t i v a t i o n
Item
Display
Buzzer
Note (Solution)
Detection of failure
Inner buzzer sounds once
There is a fault in the keyless operation system.
Fall of battery voltage
Inner buzzer sounds once
The battery starts to run out, the warning is activated.
(The warning is
not activated if the battery is completely dead.
)
BK0203201EN.book 11 ページ 2013年11月19日 火曜日 午前11時50分
Keyless operation system4-12 Locking and unlocking
4
Key not detected
Inner buzzer sounds once
When the engine switch is turned to the ACC or ON from OFF or when the engine is started, the warning is activated, if any of the following conditions is occurred.•••Carrying another keyless operation key with a different code, or the keyless operation key could be outside the operating range.The battery of the keyless operation key is dead.Communication is blocked by electric wave environment.
Keyless operation key reminder
Inner buzzer sounds about 1 minuteOuter buzzer sounds about 3 seconds inter-mittently
If the operation mode is in OFF and the driver’s door is opened with the keyless operation key in the key slot, a warning is issued and the outer buzzer sounds for about 3 seconds and the inner buzzer sounds for about 1 minute to remind you to remove the key. If the key removed from key slot, the buzzer is stopped.
Keyless operation key take-out monitoring system
Inner buzzer sounds onceOuter buzzer sounds intermittently
••••When the vehicle is parked with the operation mode in any mode other than OFF, if you close the door after opening any of the doors and taking the keyless operation key out of the vehicle, a warning is issued until the key is detected in the vehicle.If you take the keyless operation key out of the vehicle through a window without opening a door, the keyless operation key take-out monitoring system does not operate.It is possible to change the setting to make the keyless operation key take-out monitoring system operate if you take the keyless operation key out from the vehicle through a window without opening a door. For further information, please contact a MITSUBISHI MOTORS Authorised Service Point.Even if you have the keyless operation key within the engine start operating range, if the keyless operation key and vehicle ID codes cannot be matched, for example due to the ambient environment or electromagnetic conditions, the warning may be activated.
Item
Display
Buzzer
Note (Solution)
BK0203201EN.book 12 ページ 2013年11月19日 火曜日 午前11時50分
If the vehicle breaks down9-2 For emergencies
9
E00800102378
If the vehicle breaks down on the road, moveit to the shoulder and use the hazard warningflashers and/or the warning triangle etc.Refer to “Hazard warning flasher switch” onpage 6-45.Ve h i c l e o p e r a t i o n a n d c o n t r o l a r e a f f e c t e d i fthe ready indicator goes out while driving.Before moving the vehicle to a safe area, beaware of the following: zThe brake booster may becomes inopera-tive and the pedal effort will increase.Press down the brake pedal harder thanusual.
zThe power steering system may not oper-ate, the steering wheel feels heavy whenturning it.
E00800503920
If the Plug-in Hybrid EV system cannot bestarted because the auxiliary battery is weakor dead, the battery from another vehicle canbe used with jumper cables to start the Plug-in Hybrid EV system.
1. Get the vehicles close enough so thejumper cables can reach, but be sure thevehicles aren’t touching each other.
If the vehicle breaks down
WA R N I N G zIf you are unable to safely assess the vehi-cle due to vehicle damage, do not touchthe vehicle. Leave the vehicle and contactemergency services. Advise emergencyresponders that this is a Plug-in HybridElectric vehicle.
If the ready indicator goes out while driving
Emergency starting
WA R N I N G zTo s t a r t t h e P l u g - i n H y b r i d E V s y s t e musing jumper cables from another vehicle,perform the correct procedures accordingto the instruction below. Incorrect proce-dures could result in a fire, explosion, elec-tric shock or damage
to the vehicles.
zKeep sparks, cigarettes and flames awayfrom the battery because the battery mayproduce an explosion.CAUTION zThe Plug-in Hybrid EV system cannot bestarted by pulling or pushing the vehicle. zCheck the other vehicle.
It must have a 12-
volt battery. If the other system isn’t 12-volt,shorting can damage
both vehicles.
zUse the proper cables suitable for the batterysize to prevent overhea
ting of the cables.
zCheck the jumper cables for damage and cor-rosion before use. zAlways wear protect
ive eye goggles when
working near the battery. zKeep the battery out of the reach of children. zDo not attempt jump starting the auxiliarybattery while the drive battery is beingcharged. Doing so could damage the vehicleor charging equipment.NOTE
zIf the auxiliary battery is disconnected, theoperation mode of the power switch is mem-orized. When a booster
battery is connected
by jumper cables, the operation mode returnsto the state before the auxiliary battery rundown.Pay due attention if you do not know theoperation mode before
the auxiliary battery
was fully discharged. zIf the auxiliary battery is fully dischargedwith the select position in the “P” (PARK)position, the select position cannot bechanged to other position from the “P”(PARK) position in some cases. In such acase, the front wheels have been locked.Therefore, the vehicle cannot be moved.CAUTION
BK0203201EN.book 2 ページ 2013年11月19日 火曜日 午前11時50分
Cleaning the exterior of your vehicle10-6 Vehicle care
10
E00901500347
1. Remove dirt using a sponge while sprin-kling water on the vehicle.2. Use neutral detergent on any dirt that can-not be removed easily with water.Rinse off the neutral detergent after wash-ing the vehicle.3. Dry the vehicle thoroughly using a cham-ois leather or a soft cloth.
E00901600117
The window glass can normally be cleanedusing only a sponge and water.Glass cleaner can be used to remove oil,grease, insect carcasses, etc. After washing
the glass, wipe it dry with a clean, dry, softcloth. Never use a cloth that is used for clean-ing a painted surface to clean a window. Waxfrom the painted surface could get on theglass and lower glass transparency and visi-bility.
E00901700062
Use a soft cloth and glass cleaner to removegrease, dead insects, etc., from the wiperblades. Replace the wiper blades when theyno longer wipe properly. (Refer to page11-12.)
E00902200051
Use a soft cloth to clean the inner side of thesunroof. Hard deposits should be wiped awaywith a cloth dipped in warm, neutral deter-gent solution. Wipe away the solution with asponge dipped in fresh water.
E00902100483
Clean the engine compartment at the begin-ning of autumn and end of winter. Pay partic-ular attention to flanges, crevices andperipheral parts where dust containing roadchemicals and other corrosive materialsmight collect.If salt and other chemicals are used on theroads in your area, or you live within 20 kmof the sea, clean the engine compartment atleast every three months.Never spray or splash water on the electricalcomponents in the engine compartment, asthis may cause damage.Do not bring the nearby parts, the plasticparts and so on into contact with sulphuricacid (battery electrolyte) which may crack,stain or discolour them.If they are in contact, wipe off with soft cloth,chamois or the like and an aqueous solutionof neutral detergent then immediately rinsethe affected parts with plenty of water.
Aluminium wheels*
CAUTION zDo not use a brush or other hard implementon the wheels.Doing so could scratch the wheels. zDo not use any cleaner th
at contains an abra-
sive substance or is aci
dic or alkaline. Doing
so could cause the coating on the wheels topeel or become discoloured or stained. zDo not directly apply
hot water using a steam
cleaner or by any other means. zContact with seawater and road deicer cancause corrosion. Rinse off such substances assoon as possible.
Window glass
NOTE
zTo c l e a n t h e i n s i d e o f t h e r e a r w i n d o w,always use a soft cloth and wipe the windowglass along the demister heater element so asnot to cause damage.
Wiper blades Cleaning the sunroof*
NOTE
zThe surface treatment on the inside of theglass may be removed if hard cloth ororganic solvent (benzi
ne, kerosene, thinner,
etc.) is used.
Engine compartment
BK0203201EN.book 6 ページ 2013年11月19日 火曜日 午前11時50分