2014 LEXUS RX270 Owners Manual

529
4-3. Do-it-yourself maintenance
4
Maintenance and care
RX350/270_EE
CAUTION
■Replacing light bulbs
●Turn off the lights. Do not attempt to replace the bulb immediately after turning
off the lights.
The bulbs become very hot and may cause burns.
●Do not touch the glass portion of the light bulb with bare hands. When it is
unavoidable to hold the glass portion, use and hold with a clean dry cloth to avoid
getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
●Fully install light bulbs and any parts used to secure them. Failure to do so may
result in heat damage, fire, or water entering the headlight unit. This may damage
the headlights or cause condensation to build up on the lens.
●Vehicles with discharge headlights:
While the low beam headlights are turned
on, and for a short time after they have
been turned off, metal components at the
rear of the headlight assembly will be
extremely hot. To prevent burns, do not
touch these metal components until you
are certain they have cooled down.Metal components
RX350_270_EE_48D77E.book 529 ページ ２０１４年１月２４日　金曜日　午前１０時４分

530
4-3. Do-it-yourself maintenance
RX350/270_EE
CAUTION
■Discharge headlights (if equipped)
●Contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional, before replacing discharge headlights (including light
bulbs).
●Do not touch the discharge headlight’s high voltage socket when the headlights
are turned on.
An extremely high voltage of 30000 V will be discharged and could result in
serious injury or death by electric shock.
●Do not attempt to take apart or repair the low beam discharge headlight bulbs,
connectors, power supply circuits, or related components.
Doing so could result in electric shock and serious injury or death.
■To prevent damage or fire
Make sure bulbs are fully seated and locked.
RX350_270_EE_48D77E.book 530 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5When trouble arises
531
RX350/270_EE
5-1. Essential information
Emergency flashers .............. 532
If your vehicle needs to
be towed ................................ 533
If you think something
is wrong ................................... 541
Fuel pump shut off
system..................................... 5425-2. Steps to take in an
emergency
If a warning light turns
on or a warning buzzer
sounds... ................................ 543
If a warning message is
displayed ................................ 552
If you have a flat tire ............... 572
If the engine will not
start.......................................... 587
If the shift lever cannot be
shifted from P....................... 589
If you lose your keys .............. 590
If the electronic key
does not operate
properly ................................... 591
If the vehicle battery is
discharged ............................. 594
If your vehicle
overheats .............................. 598
If the vehicle becomes
stuck ......................................... 601
If your vehicle has to
be stopped in an
emergency ............................ 603
RX350_270_EE_48D77E.book 531 ページ ２０１４年１月２４日　金曜日　午前１０時４分

532
RX350/270_EE
5-1. Essential information
Emergency flashers
■Emergency flashers
If the emergency flashers are used for a long time while the engine is not operating,
the battery may discharge.
The emergency flashers are used to warn other drivers when the vehicle
has to be stopped in the road due to a breakdown, etc.
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch
once again.
RX350_270_EE_48D77E.book 532 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5
533
5-1. Essential information
When trouble arises
RX350/270_EE
If your vehicle needs to be towed
Situations needs to contact dealers before towing
The following may indicate a problem with your transmission. Contact
any authorized Lexus dealer or repairer, before towing.
●The engine is running but the vehicle will not move.
●The vehicle makes an abnormal sound.
If towing is necessary, we recommend having your vehicle towed by any
authorized Lexus dealer or repairer, or another duly qualified and
equipped professional, or a commercial towing service, using a lift-type
truck or flatbed truck.
Use a safety chain system for all towing, and abide by all state/provincial
and local laws.
2WD models: If towing your vehicle with a wheel-lift type truck from the
front, the vehicle's rear wheels and axles must be in good conditions.
(→P. 534, 539)
If they are damaged, use a towing dolly or flatbed truck.
AWD models: If towing your vehicle with a wheel-lift type truck, use a tow-
ing dolly. (→P. 5 3 4 , 5 3 9 )
RX350_270_EE_48D77E.book 533 ページ ２０１４年１月２４日　金曜日　午前１０時４分

534
5-1. Essential information
RX350/270_EE
Towing with a sling-type truck
Do not tow with a sling-type truck
to prevent body damage.
Towing with a wheel-lift type truck
From the front (2WD models)
Release the parking brake.
From the front (AWD models)
Use a towing dolly under the rear
wheels.
RX350_270_EE_48D77E.book 534 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5
535
5-1. Essential information
When trouble arises
RX350/270_EEFrom the rear
Use a towing dolly under the front
wheels.
Using a flatbed truck
If your Lexus is transported by a
flatbed truck, it should be tied
down at the locations shown in the
illustration.
If you use chains or cables to tie
down your vehicle, the angles
shaded in black must be 45°.
Do not overly tighten the tie downs
or the vehicle may be damaged.
RX350_270_EE_48D77E.book 535 ページ ２０１４年１月２４日　金曜日　午前１０時４分

536
5-1. Essential information
RX350/270_EE
Emergency towing
If a tow truck is not available in an emergency, your vehicle may be tem-
porarily towed using a cable or chain secured to the emergency towing
eyelet. This should only be attempted on hard surfaced roads for 80 km
(50 miles) at under 30 km/h (18 mph).
A driver must be in the vehicle to steer and operate the brakes. The vehi-
cle’s wheels, drive train, axles, steering and brakes must be in good condi-
tion.
Installing towing eyelets
Take out the towing eyelet. (→P. 5 7 2 )
Type A
Insert the mechanical key (→P.
27) into the groove and release
the claws. With the mechanical key
inserted, remove the eyelet cover
by pulling it towards you.
Type B
Insert the mechanical key (→P.
27) into the groove and release
the claws. With the mechanical key
inserted, remove the eyelet cover
by pulling it towards you.
STEP1
STEP2
STEP2
RX350_270_EE_48D77E.book 536 ページ ２０１４年１月２４日　金曜日　午前１０時４分