441
uuFuses uInspecting and Changing Fuses
Handling the Unexpected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK
(0
*1. Turn
headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine
compartment.
u If the fuse is blown, use a Phillips-head
screwdriver to remove the screw and
replace it with a new one.
4. Inspect the small fuses in the engine
compartment and the vehicle interior.
u If there is a burned out fuse, remove it
with the fuse puller and replace it with a
new one.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Inspecting and Changing FusesNOTICEReplacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Confirm the specified amperage using the charts on
P. 439 to 440.
There is a fuse puller on the back of the engine
compartment fuse box cover.
Combined
Fuse Blown FuseFuse Puller
451
Continued
Information
Emissions TestingTesting of Readiness CodesYour vehicle has “Readiness Codes,” as part of the onboard self diagnostic system.
Some States use these codes as a test to see if your vehicle's emissions components
are working properly.
The codes may not be read properly if testing is performed just after the battery has
gone dead or been disconnected.
To check if they are set, turn the ignition switch to ON
(w
*1, without starting the
engine. The malfunction indicator lamp will come on for several seconds. If it then
goes off, the readiness codes are set. If it blinks five times, the readiness codes are
not set.
If you are required to have your vehicle tested before the readiness codes are ready,
prepare the vehicle for retesting by doing the following:
1. Fill the gas tank to approximately 3/4 full.
2. Park the vehicle and leave the engine off for six hours or more.
3. Make sure the ambient temperature is between 40°F and 95°F (4°C and 35°C).
4. Start the engine without touching the accelerator pedal, and let it idle for 20
seconds.
5. Keep the vehicle in
(P
(CVT) or
(N
(manual transmission). Increase the engine
speed to 2,000 rpm, and hold it there for about three minutes.
6. Let the engine idle with your foot off the accelerator for 20 seconds.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Testing of Readiness Codes
The readiness codes are erased when the battery is
disconnected, and set again only after several days of
driving under a variety of conditions.
If a testing facility determines that the readiness
codes are not set, you may be requested to return at
a later date to complete the test.
If the testing faci lity determines the readiness codes
are still not set, see a dealer.
460Index
Fuel Fill Door....................................... 18, 344
Fuses .......................................................... 439
Inspecting and Changing ......................... 441
Locations ......................................... 439, 440GGasoline (Fuel) Economy ................................................. 346
Gauge ....................................................... 82
Information ............................................. 343
Instant Fuel Economy ........................... 82, 89
Low Fuel Indicator ..................................... 71
Refueling ................................................. 343
Gauges ......................................................... 82
Gear Shift Lever Positions
Automatic Transmission (CVT) ................. 320
Manual Transmission ............................... 323
Glass (care) ................................................ 407
Glove Box .................................................. 156HHalogen Bulbs ................................... 376, 380
Handling the Unexpected ........................ 409
HandsFreeLink® (HFL)....................... 246, 277
Automatic Import of Cellular Phonebook and Call History .................................... 262, 289
Automatic Transferring ............................ 260
Caller’s ID Information ............................. 260
Displaying Messages ........................ 273, 298 HFL Buttons..................................... 246, 277
HFL Menus ...................................... 248, 279
HFL Status Display ........................... 247, 278
Limitations for Manual Operation ............ 247
Making a Call .................................. 266, 292
Options During a Call ...................... 271, 295
Phone Setup.................................... 253, 283
Receiving a Call ............................... 270, 295
Receiving a Text Message/E-mail...... 272, 296
Ring Tone................................................ 288
Selecting a Mail Account ......................... 297
Speed Dial ....................................... 263, 290
Text Message .................. 258, 272, 287, 296
To Clear the System ................................ 261
To Create a Security PIN .......................... 259
To Set Up a Text Message/E-mail
Options ......................................... 258, 287
Hazard Warning Button .............................. 2
Head Restraints ........................................ 149
Headlights ................................................. 136
Aiming .................................................... 376
Automatic Operation............................... 137
Dimming ......................................... 136, 139
Operating................................................ 136
Heaters (Seat) ........................................... 160
Heating and Cooling System ................... 161
Cooling ................................................... 163
Defrosting the Windshield and
Windows ............................................... 164
Dust and Pollen Filter............................... 403
Heating ................................................... 162 HFL (HandsFreeLink
®) ...................... 246, 277
High Beam Indicator .................................. 74
Hill Start Assist System ..................... 314, 317
IIdentification Numbers ............................ 448
Engine and Transmission ......................... 448
Vehicle Identification............................... 448
Ignition Switch ......................................... 131
Illumination Control ................................ 141
Knob ...................................................... 141
i-MID ........................................................... 86
Immobilizer System .................................. 125
Indicator ................................................... 75
Indicators .................................................... 68
Anti-lock Brake System (ABS) .................... 71
Brake System (Amber) ............................... 68
Charging System............................... 69, 435
CRUISE CONTROL ............................. 76, 327
CRUISE MAIN.................................... 76, 326
Daytime Running Lights ............................ 73
Door Open.......................................... 31, 72
ECON Mode ..................................... 76, 325
Electric Power Steering (EPS) System ............................................ 73, 437
Fog Light .................................................. 74
High Beam ................................................ 74
High Temperature ..................................... 72
Immobilizer System ................................... 75
i-VTEC ................................................ 76, 83
