2014 FORD ESCAPE jump cable

HAZARD WARNING FLASHERS
Note:If used when the vehicle is not
running, the battery will lose charge. There
may be insufficient power to restart your
vehicle.
The hazard warning button is
located on the instrument panel.
Use it when your vehicle is
creating a safety hazard for other
motorists.
• Press the button to turn on the hazard
warning function, and the front and
rear direction indicators will flash.
• Press the button again to turn them
off.
FUEL SHUTOFF
WARNING
Failure to inspect and, if necessary,
repair fuel leaks after a collision may
increase the risk of fire and serious
injury. Ford Motor Company recommends
that the fuel system be inspected by an
authorized dealer after any collision.
In the event of a moderate to severe
collision, this vehicle is equipped with a
fuel pump shut-off feature that stops the
flow of fuel to the engine. Not every impact
will cause a shut-off.
Should your vehicle shut off after a
collision, you may restart your vehicle by
doing the following:
1. Turn the ignition off.
2. Turn the ignition to crank.
3. Turn the ignition off.
4. Turn the ignition on again to re-enable
the fuel pump.
For vehicles equipped with a push button
start system:1. Press the START/STOP button to
turn the ignition off.
2. Press the brake pedal and press the
START/STOP button (crank
attempt).
3. Remove your foot from the brake pedal
and press the START/STOP button
(ignition off).
4. Press the START/STOP button again
to re-enable the fuel system.
JUMP-STARTING THE VEHICLE
WARNINGS
The gases around the battery can
explode if exposed to flames, sparks,
or lit cigarettes. An explosion could
result in injury or vehicle damage.
Batteries contain sulfuric acid which
can burn skin, eyes and clothing, if
contacted.
Use only an adequate-sized cable
with insulated clamps.
Preparing Your Vehicle
Note:Do not attempt to push-start your
automatic transmission vehicle. Automatic
transmissions do not have push-start
capability. Attempting to push-start a
vehicle with an automatic transmission may
cause transmission damage.
Note:Use only a 12-volt supply to start your
vehicle.
Note:Do not disconnect the battery of the
disabled vehicle as this could damage the
vehicle's electrical system.
Park the booster vehicle close to the hood
of the disabled vehicle, making sure the
two vehicles do not touch. Turn all
accessories off.
187
Roadside Emergencies

Connecting the Jumper Cables
WARNING
Do not attach the cables to fuel lines,
engine rocker covers, the intake
manifold or electrical components
as grounding points. Stay clear of moving
parts. To avoid reverse polarity
connections, make sure that you correctly
identify the positive (+) and negative (-)
terminals on both the disabled and booster
vehicles before connecting the cables.
Note:In the illustration, the bottom vehicle
represents the booster vehicle.
4
2
1
3
E142664
1. Connect the positive (+) jumper cable
to the positive (+) terminal of the
discharged battery.
2. Connect the other end of the positive
(+) cable to the positive (+) terminal
of the assisting battery.3. Connect the negative (-) cable to the
negative (-) terminal of the assisting
battery.
4. Make the final connection of the
negative (-) cable to an exposed metal
part of the stalled vehicle's engine, or
connect the negative (-) cable to a
ground connection point if available.
WARNING
Do not connect the end of the
second cable to the negative (-)
terminal of the battery to be jumped.
A spark may cause an explosion of the
gases that surround the battery.
Jump Starting
1. Start the engine of the booster vehicle
and rev the engine moderately, or press
the accelerator gently to keep your
engine speed between 2000 and 3000
rpms, as shown in your tachometer.
2. Start the engine of the disabled vehicle.
3. Once the disabled vehicle has been
started, run both vehicle engines for an
additional three minutes before
disconnecting the jumper cables.
Removing the Jumper Cables
Remove the jumper cables in the reverse
order that they were connected.
188
Roadside Emergencies

4
1
3
2
E142665
1. Remove the jumper cable from the
ground metal surface or connecting
point, if available.
2. Remove the jumper cable on the
negative (-) terminal of the booster
vehicle's battery.
3. Remove the jumper cable from the
positive (+) terminal of the booster
vehicle's battery.
4. Remove the jumper cable from the
positive (+) terminal of the disabled
vehicle's battery.
After the disabled vehicle has been started
and the jumper cables removed, allow it
to idle for several minutes so the battery
can recharge.
189
Roadside Emergencies

Information....................................................359911 Assist...............................................................365
Alerts......................................................................365
Calendar...............................................................365
SIRIUS Travel Link.............................................362
SYNC Services (If Equipped, United States
Only).................................................................360
Vehicle Health Report......................................367
Information Messages..................................91Airbag........................................................................91
Alarm........................................................................92
Battery and Charging System.........................92
Blind Spot Information and Cross Traffic
Alert System......................................................92
Doors.........................................................................93
Engine.......................................................................94
Hill Start Assist.....................................................94
Keyless Vehicle.....................................................94
Lighting....................................................................95
Maintenance..........................................................96
Message indicator.................................................91
MyKey.......................................................................96
Park Aid....................................................................97
Park Brake...............................................................97
Power Steering.....................................................98
Starting System ...................................................98
Tire Pressure Monitoring System.................100
Traction Control..................................................100
Transmission and Four-Wheel Drive............98
Installing Child Seats.....................................19Child Seats...............................................................19
Using Lap and Shoulder Belts..........................19
Using Lower Anchors and Tethers for
CHildren (LATCH)............................................22
Using Tether Straps.............................................23
Instrument Cluster........................................83
Instrument Lighting Dimmer......................74
Vehicles With Front Fog Lamps......................74
Vehicles Without Front Fog Lamps...............74
Interior Lamps..................................................75Front Interior Lamp .............................................76
Rear Interior Lamp...............................................76
Interior Mirror...................................................80Auto-Dimming Mirror...........................................81Introduction.........................................................7
J
Jump-Starting the Vehicle........................187Connecting the Jumper Cables.....................188
Jump Starting......................................................188
Preparing Your Vehicle......................................187
Removing the Jumper Cables.......................188
K
Keyless Entry....................................................62SECURICODE™ KEYLESS ENTRY
KEYPAD...............................................................62
Keyless Starting.............................................123Ignition Modes.....................................................124Keys and Remote Controls.........................44
Knee Airbag.......................................................37
L
Lighting Control...............................................73Headlamp Flasher................................................73
High Beams.............................................................73
Lighting...............................................................73
Load Carriers
See: Roof Racks and Load Carriers..............167Load Carrying.................................................166
Load Limit.......................................................168
Special Loading Instructions for Owners of
Pick-up Trucks and Utility-type
Vehicles..............................................................175
Vehicle Loading - with and without a
Trailer.................................................................168
Locking and Unlocking.................................55Activating Intelligent Access ..........................56
Autolock...................................................................57
Battery Saver.........................................................58
Illuminated Entry..................................................58
Illuminated Exit.....................................................58
Mechanical Key.....................................................56
Opening a Rear Door from Inside..................56
Power Door Locks................................................55
Remote Control....................................................55
Smart Unlocks For Integrated Keyhead
Transmitter.........................................................57
Smart Unlocks For Intelligent Access Keys
................................................................................5 7
Locks...................................................................55
419
Index