2014 DODGE CHARGER SRT Owners Manual

Page 513 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual WARNING!(Continued)
service job, take your vehicle to a competent me-
chanic.
MAINTENANCE PROCEDURES
The pages that follow contain the requiredmaintenance
services determined by the engineers who desi

Page 514 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual Engine Oil
Checking Oil Level
To assure proper engine lubrication, the engine oil must
be maintained at the correct level. Check the oil level at
regular intervals, such as every fuel stop. The best t

Page 515 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual CAUTION!
Do not use chemical flushes in your engine oil as the
chemicals can damage your engine. Such damage is
not covered by the New Vehicle Limited Warranty.
Engine Oil Viscosity
Use Pennzoil Ultra

Page 516 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual quality filters should be used to assure most efficient
service. MOPAR® engine oil filters are a high quality oil
filter and are recommended.
Engine Air Cleaner Filter
Refer to the “Maintenance Sch

Page 517 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual WARNING!
•Battery fluid is a corrosive acid solution and can
burn or even blind you. Do not allow battery fluid
to contact your eyes, skin, or clothing. Do not lean
(Continued)
WARNING! (Continued)

Page 518 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual CAUTION!
•It is essential when replacing the cables on the
battery that the positive cable is attached to the
positive post and the negative cable is attached to
the negative post. Battery posts are

Page 519 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual CAUTION!
Do not use chemical flushes in your air conditioning
system as the chemicals can damage your air condi-
tioning components. Such damage is not covered by
the New Vehicle Limited Warranty.
Ref

Page 520 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual 1. Remove the access door in the cowl screen by pressingthe retaining clips.
2. Unsnap both ends and lift the filter access cover. 3. Remove the used filter.
4. Install the new filter with arrows poin