2014 DODGE CHARGER SRT Owners Manual

Page 465 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual NOTE:
•The TPMS is not intended to replace normal tire care
and maintenance or to provide warning of a tire failure
or condition.
• The TPMS should not be used as a tire pressure gauge
while adjus

Page 466 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual •Various TPMS messages, which display in the Elec-
tronic Vehicle Information Center (EVIC)
• TPM Telltale Light
The matching full size spare wheel and tire assembly (if
equipped) has a TPM sensor

Page 467 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual Should this occur, you should stop as soon as possible
and inflate the tires with a low pressure condition (those
flashing or in a different color in the EVIC graphic) to the
vehicle’s recommended c

Page 468 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual for a minimum of five seconds and then display dashes
(- -) in place of the pressure value to indicate which
sensor is not being received.
If the ignition switch is cycled, this sequence will repeat,

Page 469 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual limit, upon the next ignition switch cycle, a chime will
sound and the TPM Telltale Light will turn ON. In
addition, the EVIC will display a low pressure mes-
sage and a graphic showing the low tire p

Page 470 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual will display aSERVICE TPM SYSTEM message for a
minimum of five seconds and then display dashes (- -)
in place of the pressure value.
5. Once you repair or replace the original road tire and reinstal

Page 471 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual Light spark knock at low engine speeds is not harmful to
your engine. However, continued heavy spark knock at
high speeds can cause damage and immediate service is
required. Poor quality gasoline can

Page 472 of 614

DODGE CHARGER SRT 2014 7.G Owners Manual CAUTION!(Continued)
blends may result in starting and drivability prob-
lems, damage critical fuel system components, cause
emissions to exceed the applicable standard, and/or
cause the “Malfunction