DS3_en_Chap00b_vue-ensemble_ed01-2014
Exterior
customising kits
These expressive stickers form part of a range of kits, very
d
ifferent one from another, which
a
llow you to create a unique
and
attractive exterior for your
v
ehicle.
Guide-me-home lighting
After switching off the ignition, under low lighting conditions the headlamps remain on for a few seconds to help you leave the vehicle.
Active city Brake
The purpose of this system is to avoid a frontal collision or reduce the speed of impact if the
d
river fails to take action or does not take
s
ufficient action.
2 41
13 5 157
Stop & Start
This system puts the engine t
emporarily on standby during
s
tops in the traffic (red lights, traffic
j
ams, etc...). The engine restarts
a
utomatically as soon as you want
t
o move off. The Stop & Start system
r
educes fuel consumption, exhaust
e
missions and the noise level when
s
tationary. 118
DS3_en_Chap01_controle-de-marche_ed01-2014
Warning lampis oncau seAction / Observations
di
esel engine
pre-heating fixed.
The
key is at position 2 (ignition on) in
t
he ignition switch.Wait
until the warning lamp goes off before starting.
The
period of illumination of the warning lamp is
d
etermined by the climatic conditions (up to about
t
hirty seconds in extreme climatic conditions).
If
the engine does not start, switch the ignition off and
t
hen on, wait until the warning lamp goes off again,
t
hen start the engine.
Parking brake fixed. The
parking brake is applied or not
p
roperly
r
eleased.Release
the parking brake to switch off the warning
l
amp, keeping your foot on the brake pedal.
Observe
the safety recommendations.
For
more information on the parking brake, refer to the
c
orresponding
s
ection.
Stop & Star t fixed. When
the vehicle stops (red lights,
t
raffic jams, ...) the Stop & Start system
h
as put the engine into STOP mode.The
warning lamp goes off and the engine restarts
a
utomatically in START mode, as soon as you want to
m
ove off.
flashes for a few
seconds,
then goes
o
f f.STOP
mode is temporarily
u
navailable.
or
START
mode is invoked
au
tomatically.For
more information on special cases with STOP
m
ode and START mode, refer to the "Stop & Start"
s
ection.
27
DS3_en_Chap01_controle-de-marche_ed01-2014
Warning lamps
When the engine is running or the vehicle is being driven, the illumination of one of the
f
ollowing warning lamps indicates a fault which
r
equires action on the part of the driver.Any
fault resulting in the illumination of a warning lamp must be investigated further by r
eading the associated message in the multifunction screen.
If
you encounter any problems, do not hesitate to contact a CITROËN dealer or a qualified
w
orkshop.
Warning lamp is on
cau
seAction / Observations
STOP fixed,
alone or
a
ssociated with
another
w
arning
lam
p,
a
ccompanied by an
a
udible signal and a
m
essage on the screen.Illumination
of the warning lamp is
a
ssociated with a serious braking
s
ystem or engine coolant temperature
pro
blem.Stop
as soon as it is safe to do so as the engine may
c
ut out when driving.
Park,
switch off the ignition and call a CITROËN dealer
o
r a qualified workshop.
Service temporarily. Minor
problems have occurred for
w
hich there is no specific warning
lam
p.Identify
the problem by reading the message shown in
t
he screen, such as, for example:
-
t
he engine oil level,
-
t
he screenwash level,
-
t
he remote control battery,
-
s
aturation of the particle emission filter on Diesel
v
ehicles (see the "Checks - Particle emissions
f
ilter" section).
For any other faults, contact a CITR
oË
N dealer or a
qualified
w
orkshop.
fixed. Major
problems have occurred for
w
hich there is no specific warning
lam
p.Identify
the problem by reading the message shown
i
n the screen and contact a CITR
oË
N dealer or a
qualified
w
orkshop.
Monitoring
DS3_en_Chap01_controle-de-marche_ed01-2014
Brakingfixed, associated with t
he STOP warning
lam
p.The
braking system fluid level is too l
ow.You
must stop as soon as it is safe to do so.
Top up with brake fluid recommended by CITROËN.
If
the problem persists, have the system checked by a
C
ITROËN dealer or a qualified workshop.
+ fixed,
associated with
t
he ST
oP a
nd ab
S
w
arning
lam
p.The
electronic brake force distribution
(
EBFD) system has a fault.You
must stop as soon as it is safe to do so.
Have
it checked by a CITROËN dealer or a qualified
w
orkshop.
Warning lamp
is on
cau
se
Action / Observations
Anti-lock Braking
System (ABS) fixed.
The
anti-lock braking system has a
f
ault.The
vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
CITROËN
d
ealer
o
r
a q
ualified
w
orkshop
w
ithout
d
elay.
dy
namic stability
control (ESP/
ASR) flashing.
The
ESP/ASR regulation is active. The system optimises traction and improves the
d
irectional stability of the vehicle.
fixed,
associated with
i
llumination of the lamp
i
n the "ESP OFF"
button,
accompanied by
a
n audible signal and a
m
essage in the screen.The
ESP/ASR system has a fault. Have it checked by a CITROËN dealer or a qualified
w
orkshop.
29
DS3_en_Chap01_controle-de-marche_ed01-2014
Warning lampis oncau seAction / Observations
Engine
autodiagnosis
system flashing.
The
engine management system has
a
fault.Risk
of destruction of the catalytic converter.
Have
it checked by a CITROËN dealer or a qualified
w
orkshop.
fixed. The
emission control system has a
f
ault.
The warning lamp should go off when the engine is started.
I f it does not go off, contact a CITROËN dealer or qualified w
orkshop without delay.
Low fuel level fixed. When it first comes on there remains a
pproximately 5 litres of fuel in the
tank. You
must refuel as soon as possible to avoid running o
ut of fuel.
This
warning lamp will come on every time the ignition is
s
witched on, until a sufficient addition of fuel is made.
Fuel
tank capacity: approximately 50 litres (petrol),
4
6 litres (Diesel) or 33 litres (LPG); depending on
v
ersion: approximately 30 litres (petrol or Diesel).
Never continue to drive until you run out of fuel as
this
could damage the emission control and injection
s
ystems.
Maximum coolant
temperature fixed.
The
t
emperature
o
f
t
he
c
ooling
s
ystem
i
s too high.Stop
as soon as it is safe to do so.
Wait
until the engine has cooled down before topping
u
p the level, if necessary.
If
the problem persists, contact a CITROËN dealer or
q
ualified
w
orkshop.
Monitoring
DS3_en_Chap01_controle-de-marche_ed01-2014
Warning lampis oncau seAction / Observations
Engine oil
pressure fixed.
There
is a fault with the engine
l
ubrication system.You
must stop as soon it is safe to do so.
Park,
switch off the ignition and contact a CITROËN
d
ealer or a qualified workshop.
Battery charge fixed. The
battery charging circuit has a fault
(
dirty or loose terminals, slack or cut
a
lternator belt, ...).The
warning lamp should go off when the engine is
s
tarted.
If
it does not go off, contact a CITROËN dealer or a
q
ualified
w
orkshop.
d
oor(s) open fixed
if the speed is
b
elow 6 mph (10 km/h).A
door or the boot is still open. Close the door or boot.
fixed
and accompanied
b
y an audible signal if
t
he speed is above
6
mph (10 km/h).
35
DS3_en_Chap01_controle-de-marche_ed01-2014
With the engine running, when the needle is:
- i n zone A ,
the temperature is correct,
-
i
n zone B, the temperature is too high;
t
he central STOP
warning lamp and the
m
aximum temperature warning lamp 1
come
on in red, accompanied by an
a
udible signal and a message in the
m
ultifunction
s
creen.
You must stop as soon as it is safe to do so.
Wait
a few minutes before switching off the
e
ngine.
Contact a CITR
oË
N dealer or a qualified
workshop.
coolant temperature indicator
After driving for a few minutes, the temperature a nd pressure in the cooling system increase.
To
top up the level:
F
w
ait for the engine to cool down,
F
u
nscrew the cap by two turns to allow the
pressure to drop,
F
w
hen the pressure has dropped, remove
t
he cap,
F
t
op up the level to the "MA X" mark.
Monitoring
43
DS3_en_Chap01_controle-de-marche_ed01-2014
Monochrome screen c
Information displays
F Press the button, located at the end of the wiper stalk , to display the various trip
computer
tabs in succession. -
t
he current information tab
w
ith:
●
t
he range,
●
t
he current fuel
c
onsumption,
●
t
he distance remaining to
b
e travelled or the Stop &
Start time counter,
-
t
he trip "1"
tab with:
●
t
he distance travelled,
●
t
he average fuel
c
onsumption,
●
t
he average speed,
f
or the first trip.
-
t
he trip "2"
tab with:
●
t
he distance travelled,
●
t
he average fuel
c
onsumption,
●
t
he average speed,
f
or the second trip.
F P ressing the button again returns you to t
he normal display.
16/9 colour screen (eMyWay)
Trip zero reset
F When the trip required is displayed, press
the button on the end of the wiper stalk for
m
ore than two seconds.
Tr i p s "1" and "2" are independent but their use
is
identical.
For
example, trip "1" can be used for daily
figures,
and trip "2"
for monthly figures.
Monitoring