2014.5 Citroen NEMO RHD Owner's Manual

87Menu...Press... Sub-menu... Press... Select... Confirm
and exitEnables you to...
11 Service (Km/Miles
before oil
change)
Display the miles/kilometres
remaining before the next oil change.
Display the engine oil level.
12 Bag p
onYe

s Activate the passenger's front
airbag.
n

o
o

FF Ye s
Deactivate the passenger's
front airbag.
n

o
13

Exit from


menu Quit the menu.
Press the arrow at the bottom to
go to the first menu.
5
TECHNOLOGY on BOARD
Vehicle configuration

88
REAR PARKING SENSORS
The audible system consists of four
proximity sensors, fitted in the rear bumper.
It detects any obstacle which comes within
range: person, vehicle, tree, fence, behind
the vehicle during the manoeuvre.
However, it will not be able to detect
obstacles located immediately below the
bumper.
An object, such as a stake, a roadworks
cone or any other similar object may be
detected at the beginning of the manoeuvre
but may no longer be detected when the
vehicle moves close to it.
This system does not take the place of
vigilance on the part of the driver.Ending operation
Come out of reverse gear and into neutral.
Operating fault
If this warning lamp or the service
warning lamp comes on in the instrument
panel, accompanied by a message in the
screen, contact a CITRo Ë n dealer or a
qualified workshop.
Good practice
In bad weather or in winter, ensure that the
sensors are not covered with mud, ice or
snow.
Operation
Engage reverse gear with the gear lever.
The proximity information is indicated by an
audible signal which becomes more frequent
as the vehicle approaches the obstacle.
When the distance between the rear of
the vehicle and the obstacle is less than
approximately thirty centimetres, the audible
signal becomes continuous.
This function will be deactivated
automatically if a trailer is being towed.
You are advised to obtain a towbar
recommended by CITR
o Ë n and have it
installed by a qualified workshop.
88
Parking sensors

89
Volume Increase/
d
ecrease.
o

n.
o

ff.
Mute On/Off.
Selection of the CD/CD MP3 source.
Use the left/right arrows to select the previous/
next track.Use the left/right arrows to fast forward/
backward playing of the current track.
In CD MP3 mode: use the up/down arrows
to change folder. Setting the audio options: bass, treble, fader (front/rear), balance (left/
right), loudness, EQ Preset (equaliser).
Use the up/down arrows to select the option.
Use the left/right arrows to increase or decrease the value of the option
or change the equaliser.
a

ccess to the menu.
Use the up/down arrows to
select one of the following
functions: ●

AF switching.
●


T
raffic info.
●

Regional mode.
●


MP3 display
.
●

Speed volume.
●


External audio vol.
●


Radio of
f.
●

Restore default.
Use the left/right arrows to


change the setting of the
function selected.
CD eject.
Selection of the FM waveband. Automatic storing of stations
(autostore
a S). Selection of the
a

M waveband.
Use the left/right arrows for an automatic station search.
Use the up/down arrows for a manual station search.
1/2/3/4/5/6: selection of the stored station. Storing a station.
Control panel FIRST STEPS
Requires a
long press.
5
TECHNOLOGY on BOARD
Audio equipment

90FIRST STEPS
Steering
mounted
controls
Increase volume.
Mute On / Off.
Bluetooth hands-free system*. Reduce volume.RADIO: select the next preset station
down.
CD: select the previous track.
CD MP3: select the previous folder.
Change audio source: RADIO /
CD / CD MP3.
Select waveband: FM1 / FM2 /
FMT / MW / LW.
Bluetooth hands-free system*.
RADIO: select the next preset station up.
CD: select the next track.
CD MP3: select the next folder.
*

For more information on the using the Bluetooth hands-free syst
em,
refer to the corresponding section.
Audio equipment

91"AUDIO FUNCTIONS" MENU
RDS "AF Switching"
The RdS (Radio data System) enables you
to continue listening to the same station,
regardless of the frequency that it uses in
your current location. The audio equipment
continuously searches for the transmitter
which offers the best reception for the
station.
Press the "3 " or "4" button to activate (
on )
or deactivate (
o FF) the R d S.
o

n the FM waveband, " a F" appears on
the display if the R
d S is activated and the
station is broadcasting with the RDS.
"Traffic Info"
All traffic information announcements will be given
priority regardless of which source is currently
playing.
The EON (Enhanced Other Networks) system
links stations which belong to the same network. It
allows you to receive traffic information transmitted
by a station which belongs to the same network as
the station to which you are listening.
"Regional Mode"
Some stations, organised in a network,
broadcast regional programmes in the
various areas which they serve. The regional
mode allows you to choose to continue
listening to the same programme.
Press the "3 " or "4" button to activate (
on )
or deactivate (
o FF) the REG function.
o

n the FM waveband, "L o C" appears on the
display if the REG function is activated and
the station finds a local frequency.
"MP3 Display"
Press the "3 " or "4" button to display the
track number or the MP3 CD information
(Artist / Album / Folder / File / Title / Time
elapsed).
Automatic volume control "Speed
Volume"
Press the "3 " or "4" button to minimise
(L o W), maximise (HIGH) or deactivate
(
o FF) the automatic control of the volume in
relation to the vehicle speed.
The volume of the traffic information is
independent of the volume of the other
sources. You can adjust it using the volume
button during traffic announcements;
this setting will be stored for the next
announcement.
Press the "3
" or "4" button to activate (
on
)
or deactivate (
o
FF) the T
a function.
o

n the FM waveband, "T
a

" appears on the
display if the T
a function is activated and


"TPM" appears if the station broadcasts
traffic information.
"External Audio Vol"
Press the "3 " or "4" button to decrease
(down to 0 minimum), increase (up to
40
maximum) or deactivate (OFF) the volume
of the external source (e.g.: hands-free kit).
Programmed switching off "Radio Off"
Press the "3 " or "4" button to programme
the switch-off time of "00 MIN" or "20 MIN".
This countdown is taken into account
with the doors closed and the key in the
STOP
position.
"Restore Default"
Press the "3 " or "4" button to retain the
modified values ( no ) or restore the default
values (YES).
"Restoring" appears on the display during
the resetting of the configuration values. "MP3" appears on the display if the function
is activated and the CD contains tracks in
the MP3 format.
Press the MENU

button on
the audio equipment to gain
access to the "
a
udio functions"
menu.
Press the "5 " or "6" button to
select one of the configurable
audio functions below.
5
TECHNOLOGY on BOARD
Audio equipment

2 1
92CD
PLAYING A CD OR AN MP3 COMPILATION
Insert circular compact discs only.
Some anti-pirating systems, on original
discs or CDs copied using a personal
recorder, may cause faults which are no reflection on the
quality of the original player.

Insert a CD or an MP3 compilation in
the player, play begins automatically.
If the player already contains a disc,
press the C
d button.
Press one of the buttons to select a
track on the CD. The MP3 format, an abbreviation of MPEG 1.2 & 2.5 Audio
Layer
3, is an audio compression standard which permits the
recording of several tens of music files on a single disc.
MP3
In order to be able to play a recorded CdR or CdRW, when
recording it is preferable to select standards ISO 9660
level
1.2 or Joliet.
If the disc is recorded in another format, it may not be played
correctly.
It is recommended that the same recording standard is
always used for an individual disc, with as low a speed as
possible (4x maximum) for optimum sound quality.
In the particular case of a multi-session CD, the Joliet
standard is recommended.
The audio equipment will only play files with the extension
".mp3" with a sampling rate of 22.05 KHz or 44.1 KHz.No
other type of file (.wma, .mp4, m3u...) can be played.
It is advisable to restrict file names to 20 characters without
using special characters (e.g.: () " " ? ; , space) to avoid any
playing or displaying problems.
Audio equipment

93
INTRODUCTION
This system allows you to:-
send and receive calls via the Bluetooth® connection with your mobile telephone,
-

display the names of your contacts and numbers from the directo
ry of your mobile phone in the instrument panel screen,
-

use voice commands to make a call and manage your contacts whil
e keeping both hands on the steering wheel,
-

hear your text messages via the voice synthesiser built into th
e system,
-

listen to MP3, WMA,

AAC, M4A, MP4 and WAV audio files from a USB storage device,
-

display information on the track being played in the radio scre
en (title, artist, etc...),
-

control vocally a portable music player (iPod® type),
-

recharge your portable music player (iPod® type) via the USb port.
BLUETOOTH HANDS-FREE SYSTEM
K

EY
Indicates that a long press is required to start the action described.
Voice mode
Speak the designated voice command clearly and distinctly. Requires a press on the steering mounted "voice" control before speaking the desired voice command.
TECHnoLoGY on boaRd
bluetooth hands-free system
5

94PRESENTATION
Display
, USB port, controls
Bluetooth hands-free system