
14
C4-2_en_Chap01_controle-de-marche_ed01-2014
CUSTOMISABLE COLOUR INSTRUMENT PANEL WITH AUDIO SYSTEM OR NAVIGATION SYSTEM
1. Rev counter (x 1 000 rpm or tr/min).
2.
Gear
efficiency
indicator
or
gear
se
-
lector
lever
position
and
gear
for
an
electronic
or automatic gearbox.
3.
Analogue
speedometer
(mph
or
km/h).
4.
Cruise
control
or
speed
limiter
set
-
ting.
5.
Digital
speedometer (mph or km/h).
6.
Engine
oil level indicator. A.
Dial COLOUR: customisation of the background
colour of the dials.
B.
Screen
COLOUR:
customisation
of
the
background
colour
of
the
screens.
C.
Lighting
dimmer
(available
in
night
mode).
D.
Reminder
of
the
servicing
informa
-
tion.
Reset
the
service
indicator
or
the
trip
mileage recorder.
Dials and screens
7. Service indicator
(miles
or km) then,
total
mileage recorder.
These
two
functions
are
displayed
successively
on
switching
on
the
ig
-
nition.
Lighting
dimmer
setting
(when
mak
-
ing
an adjustment).
8.
T
rip
mileage
recorder
(miles
or
km).
9.
Fuel
gauge
and
associated
low
fuel
level
warning lamp.
10.
Range
(miles
or
km)
for
the
remain
-
ing
fuel
(
a)
or
the
AdBlueadditive
and
the SCR system (b).
Control buttons
1
MONITORING

15
C4-2_en_Chap01_controle-de-marche_ed01-2014
Rev counter
Approaching the maximum engine speed, the
bars are displayed in red and flash, to indicate
to
you
the
need
to
change
up
a gear
.
When
switching
the
ignition
on
or
of
f,
the
speedometer
needle
and
the
bars
of
the
rev
counter
and
fuel
gauge
carry
out
a
full
sweep
and then return to 0.
1
MONITORING

20
C4-2_en_Chap01_controle-de-marche_ed01-2014
Warning/indicator lampis onCause Action/Observations
Anti-lock Braking
System (ABS) fixed.
The
anti-lock braking system
has
a fault.The
vehicle retains conventional braking.
Drive
carefully at reduced speed and
contact
a CITROËN dealer or a qualified
workshop
without delay.
Engine
autodiagnosis system flashing.
The
engine management
system
has a fault.Risk
of destruction of the catalytic converter.
Have
it checked by a CITROËN dealer or a
qualified
workshop.
fixed. The
emission control system
has
a fault.The
warning lamp should go off when the
engine
is started.
If
it does not go off, contact a CITROËN
dealer
or qualified workshop without delay.
Low fuel level fixed,
accompanied
by
and audible
signal
and a
message.When
it first comes on there
remains
approximately
6
litres of fuel in the tank.
At
this point, you begin to use
the
fuel reserve.Refuel
as soon as possible to avoid
running
out of fuel.
Until
sufficient fuel is added, this warning
lamp
will come on every time the ignition
is
switched on, accompanied by an
audible
signal and a message.
This
audible signal and message are
repeated
with increasing frequency as
the
fuel level drops towards "0".
Fuel
tank capacity: approximately
60
litres.
Never
continue to drive until you run
out
of fuel, as this could damage the
emission
control and injection systems.
1
MONITORING

22
C4-2_en_Chap01_controle-de-marche_ed01-2014
Water in Dieselfixed.The Diesel fuel filter contains water
.Risk
of damage to the injection system on
Diesel engines.
Contact a CITROËN dealer or a qualified
workshop
without delay.
Particle
emissions filter (Diesel) fixed,
accompanied
by
an
audible signal
message
on the
risk
of blockage
of the particle
emissions
filter.This
indicates that the particle
emissions
filter is starting to
become
saturated.As
soon as driving conditions allow,
regenerate
the filter by driving at a speed
of
at least 35 mph (60 km/h) until the
warning
lamp goes off.
fixed,
accompanied by
an audible
signal
and and a
message
that the
particle
emissions
filter
additive level
is
too low.This
indicates the low level of
the
additive reservoir.Have
the reservoir topped up as soon
as
possible by a CITROËN dealer or a
qualified
workshop.
Warning/indicator lamp
is onCause Action/Observations
Airbags temporarily.
This lamp comes on for a few
seconds
when
you
turn
on
the
ignition,
then goes off.
This lamp should go off when the engine
is
started.
If it does not go off, contact a CITROËN
dealer
or a qualified workshop.
fixed. One of the airbag or seat belt
pretensioner
systems has a
fault.
Have
it checked by a CITROËN dealer or
a
qualified workshop.
1
MonIToRInG

33
C4-2_en_Chap01_controle-de-marche_ed01-2014
System allowing certain screens to be switched
off for night driving.
The
instrument
panel
remains
on
with
the
vehicle
speed,
electronic
or
auto
-
matic
gearbox
gear
selected,
cruise
control
or
speed
limiter
information,
if
in
use,
and
the
low
fuel
alerts
as
ap
-
propriate.
If
there
is
an
alert
or
a
change
in
a
function
or
to
a
setting,
the
black
panel
mode
is interrupted.
Black panel (black screen)
Activation
F
With
the
vehicle
lighting
on,
press
this
button
again
to
activate
the
black
panel.
F
Press
once
more
to
illu
minate
on
the
various screens again.
Permits manual adjustment of the bright -
ness of the instruments and controls in relation
to
the
exterior
brightness.
Only operates
when
the
vehicle
lighting
is
on
in night
mode.
Lighting dimmer
Activation
F
Press button
A
to
change
the
bright
-
ness
of the instruments and controls.
F
When
the
lighting
reaches
the
mini
-
mum
setting,
release
the
button,
then
press again to increase it.
or
F
When
the
lighting
reaches
the
maxi
-
mum
setting,
release
the
button,
then
press again to reduce it.
F
When
the
lighting
reaches
the
level
of
brightness
required,
release
the
button.Deactivation
When
the
vehicle
lighting
is
of
f,
or
in
day
mode
(daytime
running
lamps
on),
pressing
the
button
or
turning
the
thumb
wheel does not have any effect.
You
can also modify the level of lighting
by
turning
the
thumb
wheel
B
,
located
on
the left of the steering wheel:
F
upwards;
to reduce the level,
F
downwards;
to increase the level.
This
indicator
and
the
lighting
value
appear
in
the
middle
of
the
instrument
panel
during
adjustment
to
show
the
lighting
level
compared
to
the
16
levels
avail
-
able.
1
MONITORING

22
42
C4-2_en_Chap02_ecran-multifonction_ed01-2014
Choice of sounds
This
menu
allows
you
to
choose
a
family
of
polyphonic
sounds
from
four
available.
These
sounds
are
grouped
together
in
a
family
and
are
adapted
to
suit
the
situation
and
context
(alert,
confirmation,
rejection,
direction
indica
-
tors,
lighting left on, key in ignition...).
Display configuration
This
menu
is
used
to
select
the
colour scheme
for
the
screen,
adjust
the
bright
-
ness,
set
the
date
and
time
and
to
choose the
units
for
distance
(km
or
miles),
fuel consumption
(l/100
km,
mpg
or
km/l)
and temperature
(°Celsius or °Fahrenheit).Adjusting the voice synthesiser
This
menu
is
used
to
adjust
the
volume
setting
for
navigation
instructions
and
to
choose
the
type
of
voice
(male
or
female).
Adjusting the date and time
-
Press
on SETUP.
-
Select
"Display
configuration"
and
confirm.
-
Select
"Set
date
and
time"
and
con
-
firm.
Select
"Minute
adjustment
via
GPS"
so
that
the
minutes
are
adjusted
automati
-
cally
by satellite reception.
-
Select
the
setting
to
modify
.
Confirm
by
pressing
on
OK
,
then
modify
the
setting
and
confirm
again
to
save
the
modification.
-
Adjust
the settings one by one.
-
Select
"
OK" in the screen then con-
firm
to save the setting. Choice of language
This
menu
is
used
to
choose
the
language used
by the screen from a defined list.
Vehicle parameters
This
menu
is
used
to
activate
or
deac
-
tivate
certain
driving
and
comfort
sys
-
tems,
classified by category:
-
"Driver
aid":
●
"Electric
brake*"
(Automatic
elec
-
tric
parking
brake;
see
"Driving"
section),
●
"Rear
wiper"
(Rear
wiper
coupled
to
reverse
gear;
see
"V
isibility"
section),
●
"Speed
limits"
(Memorising
speed settings
for
the
cruise
control
and speed
limiter;
see
"Driving"
section).Alert log
This
lists
the
active
alerts
by
displaying
in
turn
the
dif
ferent
messages
associ
-
ated
with them.
-
"V ehicle access" (see "Access" sec -
tion):
●
"Driver
doors
selectivity"
(Selective unlocking
of the driver's door),
●
"Rear
doors
selectivity"
(Selective
unlocking
of
the
boot
using
the
centre
button
on
the
remote
con
-
trol;
see "Access section).
-
"Driving
lights"
(see
"V
isibility"
sec
-
tion):
●
"Day lights*" (Daytime running lamps),
● "Directional headlights" (Main / additional
directional lighting).
-
"Comfort
lighting"
(see
"V
isibility"
section):
●
"W
elcome
lights"
(Interior
wel
-
come
lighting),
●
"Running
lights"
(Automatic
timed
operation
of headlamps).
*
Depending on country.
MULTIFUNCTION SCREENS

22
43
C4-2_en_Chap02_ecran-multifonction_ed01-2014
TRIP COMPUTER
Monochrome
screen A
Information displays The
trip
computer
provides
the
follow
-
ing information:
-
range,
-
current
fuel consumption,
- Stop & Start time counter,
-
distance
travelled,
-
average
fuel consumption,
-
average
speed.
F
Press
the
button,
located
at
the
end
of the
wiper stalk,
to
display
the
various
items
of
trip
computer
infor
-
mation
in succession.
System
that
gives
you
information
on
the
current
journey
(range,
fuel
con
-
sumption…).
F Press the control for more than
two
seconds
to
reset
to
zero
the
distance
travelled,
the
average
fuel
consumption
and
the
average
speed.
Zero reset
F
The
next
press
then
returns
you
to
the
normal display.
MULTIFUNCTION SCREENS

22
44
C4-2_en_Chap02_ecran-multifonction_ed01-2014
Monochrome screen C
You can choose between two types of
display by pressing button A:
-
the trip computer information appears temporarily
above the audio informa -
tion,
displayed
permanently
in
full screen,
or
-
the
trip
computer
and
audio
infor
-
mation
both
appear
permanently
in
a
shared screen.
Information displays
-
the
current
information
tab
with:
●
the
range,
●
the current fuel
consumption,
● the
Stop & Start time counter
,
-
the
trip "1" tab with:
●
the
distance travelled,
●
the
average fuel
consumption,
●
the
average speed,
for
the first trip. -
the
trip "2" tab with:
●
the
distance travelled,
●
the
average fuel
consumption,
●
the
average speed,
for
the second trip.
F
Press
the
button,
located
at
the
end
of the
wiper stalk,
to
display
the
various
trip
computer
tabs
in
suc
-
cession.
F
When the trip required is displayed, press
the button on the end of the wiper stalk
for more than two seconds.
Trips "1" and "2" are independent but their
use is identical.
For
example,
trip
"1"
can
be
used
for
daily
figures,
and
trip
"2"
for
monthly
figures. T
rip zero reset
MULTIFUNCTION SCREENS