2013 YAMAHA RHINO 700 engine

4-5
NOTICE●
The engine may overheat if the vehicle
is overloaded. If this happens, reduce
the load to specification.
●
After restarting, make sure that the
warning light is out. Continuous use
while this warning light is on may
cause damage to the engine.
5B410003Engine trouble warning light “ ”
This warning light comes on or flashes if a
problem is detected in the electrical circuit
monitoring the engine. When this occurs,
have a Yamaha dealer check the self-diagno-
sis system. (See pages 4-11–4-12 for an ex-
planation of the self-diagnosis device.)
The electrical circuit of the warning light can
be checked by turning the key to “ON”. If the
warning light does not come on initially when
the key is turned to “ON”, or if the warning light
remains on, have a Yamaha dealer check the
electrical circuit.
1RB7A_EE.book Page 5 Tuesday, April 24, 2012 9:07 AM

4-7
●
two tripmeters (which show the distance
traveled since they were last set to zero)
●
a clock
●
an hour meter (which shows the total time
the engine has been running)
●
a voltage display (which shows the battery
voltage)
●
a fuel meter
●
a self-diagnosis device
Odometer and tripmeter modes
1. Odometer/Tripmeter A/Tripmeter B
2. “TRIP/ODO” buttonPushing the “TRIP/ODO” button switches the
display between the odometer mode “ODO”
and the tripmeter modes “TRIP A” and
“TRIP B” in the following order:
ODO
→ TRIP A → TRIP B → ODO
1
2
1RB7A_EE.book Page 7 Tuesday, April 24, 2012 9:07 AM

4-11
TIPThis fuel meter is equipped with a self-diagno-
sis system. If a problem is detected in an elec-
trical circuit, all the display segments and fuel
level warning indicator start flashing. If this oc-
curs, have a Yamaha dealer check the electri-
cal circuit.
Self-diagnosis device1. Engine trouble warning light “ ”
2. Error code displayThis model is equipped with a self-diagnosis
device for various electrical circuits.
If a problem is detected in any of those cir-
cuits, the engine trouble warning light comes
on or flashes, and the multi-function display
indicates an error code.
If the multi-function display indicates an error
code, note the code number, and then have a
Yamaha dealer check the vehicle.
2
1
1RB7A_EE.book Page 11 Tuesday, April 24, 2012 9:07 AM

4-13
NOTICEDo not use the headlights with the engine
turned off for an extended period of time.
The battery may discharge to the point
that the starter motor will not operate
properly. If this should happen, remove
the battery and recharge it.
EVU01183On-Command four-wheel-drive and differ-
ential gear lock switches1. On-Command four-wheel-drive switch “2WD”/“4WD”
2. On-Command differential gear lock switch “4WD”/“LOCK”This vehicle is equipped with an On-Com-
mand four-wheel-drive switch “2WD”/“4WD”
and a differential gear lock switch “4WD”/
“LOCK”. Select the appropriate drive accord-
ing to terrain and conditions.●
“2WD” (two-wheel drive): Power is supplied
to the rear wheels only.
1RB7A_EE.book Page 13 Tuesday, April 24, 2012 9:07 AM

4-15
EVU00260Accelerator pedal
Press the accelerator pedal down to increase
engine speed. Spring tension returns the ped-
al to the rest position when released. Always
check that the accelerator pedal returns nor-
mally before starting the engine.1. Accelerator pedal
EVU00270Brake pedal
Press the brake pedal to slow or stop the ve-
hicle.1. Brake pedal
1RB7A_EE.book Page 15 Tuesday, April 24, 2012 9:07 AM

4-36
EVU00370Trailer hitch bracket and receiver
This vehicle is equipped with a trailer hitch
bracket and a 5 cm (2 in) receiver for a stan-
dard trailer hitch. Trailer towing equipment
can be obtained at a Yamaha dealer. (See
pages 6-9–6-11 for precaution information.)1. Trailer hitch bracket 2. Receiver
EVU00380Auxiliary DC jack
The auxiliary DC jack is located at the right
side of the front panel. The auxiliary DC jack
can be used for suitable work lights, radios,
etc. The auxiliary DC jack should only be used
when the engine is running and the headlights
are turned off.1. Auxiliary DC jack cap1. Set the light switch to “OFF”.
2. Turn the accessory off.
3. Start the engine. (See pages 6-2–6-3.)
2
1
1RB7A_EE.book Page 36 Tuesday, April 24, 2012 9:07 AM

4-37
EVU003804. Open the auxiliary DC jack cap, and theninsert the accessory power plug into the
jack.1. Auxiliary DC jack5. Turn the accessory on.
6. When the auxiliary DC jack is not beingused, cover it with the cap.
NOTICE●
Do not use accessories requiring
more than the maximum capacity stat-
ed above. This may overload the cir-
cuit and cause the fuse to blow.
●
If accessories are used without the
engine running, the battery may dis-
charge.
●
Do not use an automotive cigarette
lighter or other accessories with a
plug that gets hot, because the jack
can be damaged.
Maximum rated capacity for the auxiliary
DC jack:DC 12 V, 10 A (120 W)
1RB7A_EE.book Page 37 Tuesday, April 24, 2012 9:07 AM

5-1
EVU01200
1-FOR YOUR SAFETY – PRE-OPERATION CHECKS
Inspect your vehicle each time you use it to make sure the vehicle is in safe operating condition.
Always follow the inspection and maintenance procedures and schedules described in the Own-
er’s Manual.
WARNING
Failure to inspect or maintain the vehicle properly increases the possibility of an accident
or equipment damage. Do not operate the vehicle if you find any problem. If a problem
cannot be corrected by the procedures provided in this manual, have the vehicle inspect-
ed by a Yamaha dealer.Before using this vehicle, check the following points:
ITEMROUTINE PAGE
Brakes Check operation, free play, fluid level, and fluid leakage.
Fill with DOT 4 brake fluid if necessary. 5-3, 8-35–8-38, 8-40
Parking brake Check for proper operation, condition, and free play. 8-38–8-39
Fuel Check fuel level.
Fill with fuel if necessary. 5-4–5-5
Engine oil Check oil level.
Fill with oil to proper level if necessary. 5-6, 8-10–8-15
Coolant Check coolant level.
Fill with coolant if necessary. 5-6, 8-22–8-23
1RB7A_EE.book Page 1 Tuesday, April 24, 2012 9:07 AM