2013 SSANGYONG TURISMO turn signal

02-98710-01
▶ Rain sensing operation point
The wiper relay is turned on and the wiper motor runs one cycle when the ignition key is turned to
“ON” position (while the wiper switch is in “AUTO” position).
The wiper relay (LO) is turned on and the wiper motor runs one cycle when changing the wiper
switch to “AUTO” position from any other positions (while the ignition key is in “ON”
position). When the wiper switch is turned to “AUTO” position again from other positions,
the system drives the wiper relay (LO) to run the wiper motor one cycle only when the rain sensor
detects the “Rain Detected” signal. 1)
2)

02-10
The wiper relay is turned on and the wiper motor runs one cycle when the volume sensitivity is
increased (ex: from 0 to 1) (while the ignition key is in “ON” position, the wiper switch is in
“AUTO” position, and the wiper motor is in “Parked” position). However, the wiper motor can
be operated only when the rain sensor detects the “Rain Detected” signal.
▶ Rain sensing sensitivity control
If the volume sensitivity is changed more than 2 stages within 2 seconds, the wiper motor runs only
one cycle. *

02-12
The wiper relay (LO) is turned on and the wiper motor runs one cycle when the wiper sensitivity is
changed to 2 from 3 during receiving the malfunction signal (1) from the rain sensor. However, the
wiper motor can be operated only when the rain sensor detects the "Rain Detected" signal. 1)
If the volume sensitivity is changed more than 2 stages within 2 seconds, the wiper motor runs
only one cycle. ▶ Defective rain sensor

02-138710-01
The wiper relay (LO) is turned on and the wiper motor runs one cycle when the wiper sensitivity is
changed to 3 from 4 during receiving the malfunction signal (2) from the rain sensor (while the
ignition key is in “ON” position and the wiper switch is in “AUTO” position). 2)
The wiper relay (LO) is turned on and the wiper motor runs one cycle when the wiper sensitivity is
changed to 2 from 1 during receiving the malfunction signal (3) from the rain sensor (while the
ignition key is in “ON” position and the wiper switch is in “AUTO” position). Also, the wiper
relay (LO) is turned on and the wiper motor runs one cycle when the wiper sensitivity is changed to 2
from 1 during receiving the ground fixed or IGN fixed signal from the rain sensor. 3)

02-24
7) Room Lamp Control
▶ Front Room Lamp
The front room lamp comes on when opening the
driver’s door or passenger’s door while the front
room lamp switch is at door coupled position and the
key reminder switch is turned off.
The room lamp stays on for 2 seconds (T1) and then
decays through 3 seconds (T2) when closing the
driver’s door or passenger’s door.
The room lamp output should stop immediately afte
r
turning on the ignition key during decaying operation.
The front room lamp comes on for 30 seconds (T3)
when receiving the unlock signal from the remote
control key while the door is closed. 1.
2.
3.
4.
The front room lamp output period is extended by 30 seconds (T3) when receiving the unlock signal
from the remote control key again during output.
When a door is opened during its extended period, the lamp stays on. If closed, operates as in step
2.
The room lamp output stops immediately after receiving the lock signal from driver’s door and
passenger’s door lock switch while the driver’s door and passenger’s door are closed. 5.
6.
7.
Door coupled front
room lamp switch

02-258710-01
The rear room lamp comes on when opening the
rear door while the door coupled rear room lamp
switch is pressed (except for luggage room lamp).
The rear room lamp extends its lighting period by 5
seconds when closing the rear door.
The room lamp output stops immediately after
turning the ignition key to “ON” position during
the extended period.
The room lamp output stops immediately after
receiving the lock signal from the rear door lock
switch or the remote control key while the rear door
is closed. 1.
2.
3.
4.
Door coupled front
room lamp switch
▶Rear Room Lamp

02-26
8) Ignition Key Hole Illumination
The ignition key hole illumination comes on when opening the driver’s door or passenger’s
door while the ignition key is removed.
The ignition key hole illumination stays on for 10 seconds when closing the door after step 1.
The output stops when the ignition key is turned to “ON” position.
The output stops when receiving the lock signal from the remote control key (under armed mode). 1.
2.
3.
4.

02-28
10) Defogger Timer
The system outputs the tailgate, windshield and outside rearview mirror heated glass “ON”
signal when turning on the defogger switch (while the engine is running).
The output stops when turning on the defogger switch again during its operation.
The output is “ON” only for 6 minutes (T3) when turning “ON” the rear defogger switch within
10 minutes (T2) after completion of output.
When turning on the defogger switch again within 10 minutes (T2) after completion of initial 12
minutes (T1) of output, the output comes on for 6 minutes (T3) again once only.
The output stops when the IGN 2 switch is turned to “OFF” position or the ALT is “OFF”. 1.
2.
3.
4.