2013 SSANGYONG NEW ACTYON SPORTS warning

02-578710-01
Central Door Lock Circuit
▶
The door ajar warning lamp in the instrument cluster does not come on ev\
en though the tailgate is
opened.

03-37010-06
ECUREKES keyDiagnostic connector
1. SYSTEM CONFIGURATION
1) Components and Locations
Immobilizer warning lamp in instrument panelImmobilizer unit

03-6
3. FUNCTIONS OF IMMOBILIZER
The functions of the immobilizer are similar to that of the normal REKES key. But, there are the
immobilizer function that permits the engine to start only after confirming the encrypted coding.
The followings are common functions of the normal REKES key and the immobilizer.
Door Unlock and Panic Function
Breifly press (below 0.5 sec): Door unlock and
　　　　　　　　　　　　 theft deterrent
mode deactivated
Press and hold (over 2 sec): Panic function
1. Door unlock (Briefly press)
If you send the door unlock signal using the
remote control key, with all the doors locked, the
door will be opened and the theft deterrent mode
will be deactivated. If the door coupled switch o
f
front room lamp is pressed, the lamp will come
on for 30 seconds. It will turn off immediately
after the lock button of the remote control is
pressed.
2. Panic function: activated in the theft deterrent mode
When pressing the door UNLOCK and PANIC button for approx.
2 seconds or longer, the warning alarm sounds and the hazard
warning lamp blinks for approx. 27 seconds.
The function is inactivated if any button of remote control is
pressed. ·
·
Breifly press (below 0.5 sec): Door lock and theft deterrent mode is activated
1. Door unlock (Briefly press)
If you press this button briefly, all doors and the tailgate are locked and the theft deterrent mode is
activated.When the theft deterrent mode is activated, the hazard warning flashers blink twice.LED flasher
Briefly press: blink once
Press and hold: blink twice
Door Lock

03-97010-06
Immobilizer and Warning Lamp ▶
This indicator comes on when the ignition key is
communicating with the engine control unit
(during engine starting) and goes out after
starting the engine.
When turning the ignition key to the "ON"
position, the ECU (engine control unit) transmits
the challenge message to the immobilizer unit.
(This is to verify whether the key is valid. If the
verification fails, it transmits re-verification signals
3 times for 2 seconds. If three re-verifications fail,
it stops verification and starts re-verification after
10 seconds.) (1)
ECUOnly when the two signals are identical, it recognizes the
key as the authorized one and transmits the positive
message to the ECU. (6)
The ECU enable the engine to be started. (7)
Do not drop or shock to the transponder in the key as it may be damaged.
With a damaged transponder, the engine cannot be started.
When you erase the code or register an extra key, please attend on the site.
In any cases, the immobilizer system can not be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove,
damage or modify it.
The remote engine starter cannot be installed to the vehicle equipped with the immobilizer system. ·
·
·
·
·ON: In communication
Blinks twice at one second intervals: Immobilizer
system fault
Blinks once at 2 second intervals: Immobilizer unit
not coded
The immobilizer indicator does not come on if
the communication time between immobilizer
key and ECU is too short.
Instrument
panel

03-117010-06
5. REKES OPERATION LOGIC
1) Remote Door Lock
When briefly pressing the door lock switch on the remote control key for less than 0.5 seconds, all
doors are locked.
The system outputs the "LOCK" signal immediately after receiving the door lock message from the
remote control key. If the vehicle is locked while all doors including engine hood are closed, the theft
deterrent mode is activated (hazard warning lamps are blinking twice). 1.
2.

03-12
2) Door Unlock
When briefly pressing the door unlock switch on the remote control key for less than 0.5 seconds, all
doors are unlocked.
When receiving the DOOR UNLOCK message from the remote control key, the door unlock relay is
turned on for 0.5 seconds.
The hazard warning lamps blink once only when all the doors unlocked successfuly. 1.
2.
3.

04-38210-01
1. SPECIFICATIONS
Item Specification
Rated voltage DC 13.5 V
Operating voltage DC 9 V ~ 16 V
Checking voltage DC 13.5 V
Operating temperature-30℃ ~ +80℃
Storage temperature-40℃ ~ +85℃
Illumination color Dial White
Pointer Red
LCD Red
Displays on Instrument
ClusterWarning and indicator
lamp1 blue indicator
13 red indicators
7 green indicators
8 yellow indicators
Gauge Vehicle speed
Fuel level
Engine coolant temperature
Engine speed (rpm)
LCD display Driving distance
Trip meter
Gear position display
Gear position display in
A/T(Left hand of LCD
display)A/T vehicle P, R, N, D, 1, 2, 3, 4, 5, 6
M/T vehicle R

04-4
SSPS system-specific information reflected to instrument cluster
2. MAJOR CHANGES
SSPS warning lamp (red) added to lower left corner of the instrument cluster due to introducing of
SSPS (Speed Sensing Power Steering) system
No. 7 terminal (SSPS system malfunction signal) added to sub-connector at rear of instrument
cluster -
-
SSPS warning lamp
Comes on when fault occurs in
SSPS system
Sub-connector
Main connector
SSPS system malfunction
signal (No. 7 terminal)