2013 SSANGYONG NEW ACTYON SPORTS turn signal

02-54
Outside rearview mirror folding/unfolding control
▶
If you press the folding/unfoling switch with the ignition switch in "ON\
" position, the outside rearview
mirror is folded or unfolded depending on the previous status. At this t\
ime, folding/unfolding outputs
are maintained for about 15 to 17 seconds.
Even though the ignition switch is turned to "OFF" position during foldi\
ng/unfolding output, the output
continues on for remaining time.
When removing and refitting the battery, the first switch input folds th\
e mirror.
If you turn the ignition switch to the "OFF" from "ON" position, operating time is extended by 60
seconds. Unlikely the previous model, opening the front door does not af\
fect the extension time.
(i.e., opening/closing the front door is irrelevant)
If the unfolding input is received from the switch during folding output\
or the folding input is received
during unfolding output, the existing output stops and new output is act\
ivated after the delay time of
about 0.1 second.
When the vehilce speed is above 50 km/h with the mirror unfolded, even t\
hough the folding signal is
received it is overridden.
(folding is possible only at vehicle speed of less than 50 km/h )
1.
2.
3.
4.
5.
6.

03-6
3. FUNCTIONS OF IMMOBILIZER
The functions of the immobilizer are similar to that of the normal REKES key. But, there are the
immobilizer function that permits the engine to start only after confirming the encrypted coding.
The followings are common functions of the normal REKES key and the immobilizer.
Door Unlock and Panic Function
Breifly press (below 0.5 sec): Door unlock and
　　　　　　　　　　　　 theft deterrent
mode deactivated
Press and hold (over 2 sec): Panic function
1. Door unlock (Briefly press)
If you send the door unlock signal using the
remote control key, with all the doors locked, the
door will be opened and the theft deterrent mode
will be deactivated. If the door coupled switch o
f
front room lamp is pressed, the lamp will come
on for 30 seconds. It will turn off immediately
after the lock button of the remote control is
pressed.
2. Panic function: activated in the theft deterrent mode
When pressing the door UNLOCK and PANIC button for approx.
2 seconds or longer, the warning alarm sounds and the hazard
warning lamp blinks for approx. 27 seconds.
The function is inactivated if any button of remote control is
pressed. ·
·
Breifly press (below 0.5 sec): Door lock and theft deterrent mode is activated
1. Door unlock (Briefly press)
If you press this button briefly, all doors and the tailgate are locked and the theft deterrent mode is
activated.When the theft deterrent mode is activated, the hazard warning flashers blink twice.LED flasher
Briefly press: blink once
Press and hold: blink twice
Door Lock

03-97010-06
Immobilizer and Warning Lamp ▶
This indicator comes on when the ignition key is
communicating with the engine control unit
(during engine starting) and goes out after
starting the engine.
When turning the ignition key to the "ON"
position, the ECU (engine control unit) transmits
the challenge message to the immobilizer unit.
(This is to verify whether the key is valid. If the
verification fails, it transmits re-verification signals
3 times for 2 seconds. If three re-verifications fail,
it stops verification and starts re-verification after
10 seconds.) (1)
ECUOnly when the two signals are identical, it recognizes the
key as the authorized one and transmits the positive
message to the ECU. (6)
The ECU enable the engine to be started. (7)
Do not drop or shock to the transponder in the key as it may be damaged.
With a damaged transponder, the engine cannot be started.
When you erase the code or register an extra key, please attend on the site.
In any cases, the immobilizer system can not be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove,
damage or modify it.
The remote engine starter cannot be installed to the vehicle equipped with the immobilizer system. ·
·
·
·
·ON: In communication
Blinks twice at one second intervals: Immobilizer
system fault
Blinks once at 2 second intervals: Immobilizer unit
not coded
The immobilizer indicator does not come on if
the communication time between immobilizer
key and ECU is too short.
Instrument
panel

04-58210-01
1. DESCRIPTIONS OF INDICATOR DISPLAY
Tachometer
SSPS warning light
Immobilizer indicator
Glow indicator
ESP indicator/warning light
Front fog light indicator
High beam indicator
ESP OFF indicator
Seat belt reminder (driver’s seat)
Seat belt reminder (passenger’s seat)
Engine oil pressure warning light
LCD Display
Engine overheat warning light
Engine check warning light
Auto cruise indicator
Light indicator
Winter mode indicator 1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.Engine hood open warning light
Battery charge warning light
Hazard Indicator
Water separator warning light
Air bag warning light
4WD CHECK warning light
4WD LOW indicator
4WD HIGH indicator
Speedometer
Turn signal indicator
Coolant temperature gauge
Brake warning light
Door ajar warning light
ABS warning light
Fuel gauge
Low fuel level warning light 18.
19.
20.
21.
22.
23.
24.
25.
26.
27.
28.
29.
30.
31.
32.
33. It sends and receives information to/from each unit through CAN communication line. The LCD display
and separate ESP ON/OFF indicator are newly added.

04-8
Indicators on Instrument Cluster ▶
No. Symbol Item
1
Turn signal lamp-L
2
Turn signal lamp-R
3
4WD HIGH indicator
4Winter mode indicator
5Front fog lamp
indicator
6Cruise control
indicator
7Light illumination
indicator
8
High beam indicator
9
ABS warning lamp
10
Glow indicator
11
Immobilizer indicator
12Low fuel level warnig
lightPower Turning ON condition
Multifunction
switchWhen activating switch
Multifunction
switchWhen activating switch
IGN IGN ON/ CAN signal input
IGN IGN ON/ CAN signal input
Fog lamp
relayWhen activating switch
IGN IGN ON/ CAN signal input
BATT Tail lamp ON
Headlamp
high beam
relayWhen activating switch
IGNIGN ON/ CAN signal input
(ABS, EBD)
IGN IGN ON/ CAN signal input
IGN IGN ON/ CAN signal input
IGN When analog inputting fuel level

04-98210-01
Power Turning ON condition
IGN IGN ON/ CAN signal input
IGN IGN ON/ CAN signal input
IGNIGN ON/ CAN signal input
(ESP & buzzer activated)
IGN IGN ON/ CAN signal input
IGN IGN ON, CAN signal input (EBD)
IGN IGN ON/ CAN signal input
IGN Signal input
BATT When door opened
IGN Charge system fault
IGN Switch input
IGN Switch inputNo. Symbol Item
13Engine check warning
lamp
144WD LOW
indicator
15ESP indicator/ warning
light
16 ESP OFF indicator
17 Brake warning light
184WD CHECK
indicator
19Air bag warning lamp
20Door ajar waning light
21Charge warning lamp
22Seat belt warning light
(driver)
23Seat belt warning light
(passenger)

04-10
No. Symbol Item
24Engine oil pressure
warning lamp
25Water separator
warning light
26Engine coolant
overheat warning light
27Engine hood open
warning lamp
28 EBD warning light
29 SSPS warning lamp
30Hazard warning lampPower Turning ON condition
IGN Signal input
IGN IGN ON/ CAN signal input
IGN IGN ON/ CAN signal input
IGN Switch ground
IGN CAN signal input
IGN Digital input
IGN Switch to High

04-258210-01
WARNING LAMP (BATT CHARGE, OIL, HOOD, DOOR, ENG CHECK, AIR BAG, SEAT BELT),
TURN SIGNAL, FOG LAMP, HAZARD ▶