2013 SSANGYONG NEW ACTYON SPORTS turn signal

02-30
▶Center Room Lamp Control
The overhead console lamp (front room lamp) and the center room lamp come on at 100% when
opening the door (driver's/passenger's/rear) while the center room lamp switch\
is at the doo
r
coupled/tailgate coupled operating position and the key reminder switch \
is "OFF".
When the door (driver's/passenger's/rear) is opened, the front and center room lamps come on at
100% and automatically go off after 30 seconds.
The room lamp stays on for 2 seconds and then dims through 3 seconds whe\
n closing the doors
within 30 seconds.
The dimming operation must have greater than 32 steps per one second.
The room lamp output should stop immediately after turning on the ignition key during the
dimming operation.
The front room lamp and the center room lamp come on for 30 seconds when\
receiving the
unlock signal from the remote control key while the doors are closed.
The front room lamp and the center room lamp output period is extended b\
y 30 seconds when
receiving the unlock signal from the remote control key again during output under step (5). (The
lamp stays on when unlocked by the remote control key.)
When a door is opened during its extended period, the lamp stays on. If closed, operates as in
step (2).
The room lamp output stops immediately after receiving the lock signal from door lock switches
while all doors are closed or entering into the anti-theft mode by pushi\
ng LOCK button on the
remote control key.
1.
2.
3.
4.
5.
6.
7.
8.

02-32
▶Ignition Key Hole IlluminationThe ignition key hole illumination comes on when opening the driver's door or passenger's doo
r
while the ignition key is removed.
The ignition key hole illumination stays on for 10 seconds when closing \
the door after step (1).
The output stops when the ignition key is turned to the "ON" position.
The output stops when receiving the lock signal from the remote control key and entering armed
mode.
1.
2.
3.
4.
▶Key cylinder with key hole illumination With diesel and gasoline engine With diesel engine With gasoline engine
Without immobilizer
→With key hole
illumination With immobilizer
→With key hole
illumination With immobilizer
→Without key hole
illumination function

02-418710-01
The door lock system outputs "LOCK" when the vehicle speed maintains over 30 km/h.
However, it doesn't output "LOCK" when all doors are locked or failed.
If any of doors is unlocked after outputting "LOCK" in step 1, outputs "LOCK" up to 5 times
(except step (1)) at the interval of one second.
If any of doors is unlocked after 5 times of "LOCK" outputs, the door (driver's/passenger's/rear) is
regarded as "FAIL".
If the door that was regarded as fail is changed (UNLOCK to LOCK), it will be recognized as a
normal one.
If any door is regarded as FAIL, the auto door lock function does not work. (if it is occurred when
the vehicle speed is over 30 km/h, the auto door lock output does not occur even if the vehicle
speed falls below 30 km/h and accelerates again to over 30 km/h.) Nonetheless, the central
door lock function works properly.
When the system receives "UNLOCK" signal fr om a door switch, it outputs "LOCK" signals 5
times. If additional "LOCK" signal from another door switch is detected during \
the period, the
system outputs five "LOCK" signals 5 times for the switch.
The door lock system outputs "UNLOCK" automatically if the "LOCK" output conditions are
established by this function or the key is cycled (IGN=OFF) (even when there is no "LOCK"
output while the vehicle speed maintains over 30 km/h under lock conditi\
on).
(If the LOCK condition is established with the ignition switch ON, the system outputs UNLOCK
signal unconditionally when turning the ignition switch to OFF position.\
)
However, when the ignition key is turned to "OFF" position, the lock output conditions will be
cancelled.
The "FAIL" condition of the door will be erased when the ignition key is\
turned to "OFF" position.
1.
2.
3.
4.
5.
6.
7.
8.
▶Auto Door Lock
T2: 0.5 s
(*1) LOCK: Driver's & Passenger's & Rear door & = Lock

02-42
▶Auto Door Unlock (Crash Unlock: Automatic Door Unlock in Collision)
The air bag collision signal input cannot be accepted within 7 seconds after turning the ignition
key to "ON" position.
After this period, the door lock system outputs "UNLOCK" for all doors for 5 seconds from 40 ms
after receiving the air bag collision signal.
Even though the key is turned to "OFF" position during the output of "UNLOCK", the output
continues on for remaining period.
The function is erased when turning "OFF" the ignition switch.
1.
2.
3.
4.
Cautions for door lock/unlock control
The "Unlock" control by air bag signal prevails over any "LOCK" or "UNLOCK" control by othe
r
functions.
The "LOCK/UNLOCK" request by other functions will be ignored after/durin\
g the output o
f
"UNLOCK" by the air bag.
However, the door lock is controlled by other functions when the ignitio\
n switch is "OFF".
"LOCK" (or "UNLOCK") output is ignored if "LOCK" (or "UNLOCK") output is required while
performing the output of "LOCK" (or "UNLOCK").
(However, UNLOCK by air bag signal and operation by the remote control \
key are valid.)
If the door lock system outputs "LOCK" and "UNLOCK" simultaneously, only\
the "LOCK" output
can be activated.
1.
2.
3.
4.

02-438710-01
▶Time Lag Power Window Control
The power window relay output is "ON" when turning on the ignition switc\
h.
The power window relay output is "ON" for 30 seconds when turning off th\
e ignition switch.
The power window relay output is "OFF" when opening the driver's door or the passenger's
door.
The power window relay is turned "OFF" when receiving the remote control\
key lock signal
(armed mode) during its extended operation period of 30 seconds.
1.
2.
3.

02-46
(2) Armed mode cancellation requirements(3) Warning operation requirements
(4) Warning operation
(5) Warning cancellation requirements
(6) Operation when warning is cancelled
Receiving UNLOCK signal from the remote control key or starting the engi\
ne.
a.
When opening the door in armed mode
When unlocking the door lock switch in armed mode by other than the remo\
te control key
When closing and then opening the door after completion of warning (27 \
seconds)
a.
b.
c.
The theft deterrent horn and hazard warning flasher output is "ON" for 2\
7 seconds at the interval of 1
second.
a.
Cancels warning by using any signal from the remote control key (LOCK, \
UNLOCK, PANIC) during
warning operation.
Cancels warning after 27 seconds (remaining time) while the ignition k\
ey is turned to "ON"
position.
If the ignition switch is turned to ON position when the warning is acti\
vated in armed mode, the
warning is cancelled immediately and the warning buzzer stops after 27 s\
econds (remaining time).
a.
b.
c.
The theft deterrent horn and hazard warning flasher outputs are "OFF".
a.

02-48
Automatic Hazard Warning Lamp Switch (SHP: Safety Hazard Protection)
▶
When the automatic hazard warning lamp switch is pressed for approx. 0.1\
to 0.59 seconds, the
hazard warning lamp blinks 3 times at an interval of 0.35 seconds.
When the automatic hazard warning lamp switch is pressed for approx. 0.6\
seconds or longer,
the hazard warning lamp blinks 10 times at an interval of 0.35 seconds.
This function is only available when the ignition key is in the "ON" pos\
ition.
If the ignition key is turned to the "OFF" position dur ing this function is activated, this function is
immediately deactivated.
If the system receives signals for the turn signal lamp operation during\
this function is activated,
this function is immediately deactivated.
While the turn signal lamp signals are already inputted, pressing the au\
tomatic hazard warning
lamp switch does not activate the automatic hazard warning lamp function\
.
1.
2.
3.
4.
5.
6.
Automatic hazard warning lamp switch
▶
Press briefly (0.1 ~ 0.59 seconds): The hazard
warning lamp blinks three times.
Press and hold (more than 0.6 seconds): The
hazard warning lamp blinks ten times.
·
·

02-498710-01
▶Specifications of Remote Control Key
When any of switches on remote control key is pressed, the integrated CP\
U in remote control key sends
the coded control message to the CPU in receiver to control the vehicle.\
Door Unlock and Panic Function Breifly press (below 0.5 sec): Door unlock and theft deterrent mode is\

deactivated
Press and hold (over 2 sec): Panic function
Door unlock (Briefly press)
1.
If you send the door unlock signal using the remote control key, with al\
l the doors locked, the
door will be opened and the theft deterrent mode will be deactivated. If\
the door coupled switch
of front room lamp is pressed, the lamp will come on for 30 seconds. It \
will turn off immediately
after the lock button of the remote control is pressed.
·
Panic function: activated in the theft deterrent mode
2.
If you press and hold the door unlock and panic buttons, the buzzer will\
sound for 27 seconds
and the hazard warning flasher blinks.
The function is inactivated if any button of remote control is pressed.
* For the previous model, only the theft deterrent horn has been activat\
ed.
·
·
LED flasher
Briefly press: blink once
Press and hold: blink twice
Door Lock Function
Breifly press (below 0.5 sec): Door lock and theft deterrent mode is a\
ctivated
Door unlock (Briefly press)
1.
Pressing this button locks all doors and activates the theft deterrent m\
ode.
·