2013 SSANGYONG KORANDO Back seat

7410-00
Seatback folding
Rear seat heated wire
Rear seat heated wire switch
(2) Rear seat heated wire functions
Rear armrest
LH
RH

Mounting location Seat heated wire and
ventilation unit
4) Front Seat Heated Wire and Ventilation Unit
(1) Front seat heated wire and ventilation unit operation
The seat heated wire and ventilation unit is mounted at the bottom of the driver seat. The temperature of
ventilation switch. Every time the seat heated wire and ventilation switch is pressed, the temperature
level goes down by one level. Pressing the switch a third time will turn off the operation. Pressing the
desired side of the switch heats the seat cushion and seatback or activates the seat ventilation function.
The temperature of the seat is kept uniform by cutting off or connecting power through thermistor fitted in
the seat. The seat heated wire and ventilation unit controls the rpm of the motor using PWM control to
operate the seat ventilation.
Seat heated wire and ventilation unit & switch application
The seat heated wire and ventilation unit is not fitted in a vehicle without seat ventilation function. -

(3) Connector pin description
Seat heated wire and
ventilation unit side
Seat heated wire and
ventilation unit wiring side Pin No. Function
1IGN2
2-
3-
4 Ventilation switch
5 Heater switch (LH)
6 Heater switch (RH)
7 Heater level 1 (LH)
8 Heater level 1 (RH)
9 Ventilation level 1 (LH)
10 Heater back (LH) NTC -
11 Heater back (RH) NTC +
12 Cushion ventilation power (+)
13 Heater back (LH) HTR
14 ALT
15 -
16 -
17 -
18 -
19 -
20 Heater level 2 (LH)
21 Heater level 2 (RH)
22 Ventilation level 2 (LH)
23 Heater back (LH) NTC +
24 Heater back (RH) NTC -
25 Heater back (RH) HTR
26 Ground

7410-00
3) ISO FIX
Installation using lower latch
There are marks (A), which indicate that the
ISOFIX for child restraint system can be fixed,
at the bottom of the rear seatback as shown in
the figure.
Attach the ISOFIX child restraint system (C) to
the two latches (B) located at the bottom of the
rear seat.
If a ISOFIX child restraint system is used, the
seat belt is not needed.
No lower anchor is installed to the rear center
seat.
The approved ISOFIX child restraint system
can be mounted to the vehicle with ISOFIX
system (2 lower latches and one rear seatback
anchor). -
-
-
-
-
When installing ISOFIX child restraint system to the vehicle, all the seat belts in the rear seat should
be buckled.
The mounting latches and anchors for the ISOFIX system are only for the child restraint system, so
DO NOT install any restraint system other than ISOFIX specifications, seat belt or other device to
these latches or anchors. -
-

Installation using rear seatback anchor
There are anchors (for hook mounting) for fixing child restraint system, on the back side of the rear
seatback as shown in the figure. -
Route the belt of the child restraint system over the seatback of the rear seat.
Attach the hook of the child restraint system belt to the anchor firmly, and securely tighten the child
restraint to the seat. -
-