2013 Peugeot 208 light

133
6
Safety
Airbags


System designed to maximise the safety of the
occupants (with the exception of the rear centrepassenger) in the event of violent collisions.
The airbags supplement the action of the force-
limiting seat belts (with the exception of the centre rear passenger).
If a collision occurs, the electronic detectors
record and analyse the front and side impacts sustained in the impact detection zones:


- in the case of a serious impact, the airbagsare deployed instantly and contribute
towards better protection of the occupants
of the vehicle
(with the exception of the rear centre passenger); immediately after the
impact, the airbags deflate rapidly so that
they do not hinder visibility or the exit ofthe occupants,

- in the case of a minor or rear impact
or in cer tain roll-over conditions, the
airbags will not be deployed; the seat belt
alone contributes towards ensuring your protection in these situations.
The airbags do not operate whenthe ignition is switched off.
This equipment will only deploy once.
If a second impact occurs (during thesame or a subsequent accident), the airbag will not be deployed again.
Deployment of the airbag(s) is accompanied by a slight emission of smoke and a noise, due to theactivation of the pyrotechnic cartridgeincorporated in the system.This smoke is not harmful, but sensitiveindividuals may experience slight irritation.
The noise of the detonation may resultin a slight loss of hearing for a shorttime.
Impact detection zones
A.
Front impact zone.B.
Side impact zone.
Front airbags


Deployment

The airbags are deployed, except the passenger's front airbag if it has been deactivated, in the eventof a serious front impact to all or part of the front impact zone A
, in the longitudinal centreline of the
vehicle on a horizontal plane and directed from thefront to the rear of the vehicle.
The front airbag inflates between the thorax and
head of the front occupant of the vehicle and the
steering wheel, driver's side, and the dashboard,
passenger's side to cushion their forward
movement.
System which protects the driver and front
passenger in the event of a serious front impact
in order to limit the risk of injury to the head and
thorax.
The driver's airbag is fitted in the centre of the steering wheel; the front passenger's airbag isfitted in the dashboard above the glove box.

161
7
Practical information











Changing a bulb


Front lamps
A. Model with light guide

In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal sur face of the glass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.

The headlamps are fitted with polycarbonate glass with a protectivecoating:)
do not clean them using a dry or abrasive cloth, nor with a detergent or solvent product,)
use a sponge and soapy water or apH neutral product,)
when using a high pressure washer on persistent marks, do not keep the lance directed towards thelamps or their edges for too long, so as not to damage their protectivecoating and seals,)
do not touch the bulb directly withyour fingers, use lint-free cloths.
Changing a bulb should only be doneafter the headlamp has been switched off for a few minutes (risk of serious burns). It is imperative to use only anti-ultraviolet (UV) type bulbs in order notto damage the headlamp. Always replace a failed bulb with a new bulb with the same type andspecification.
B. Model without light guide
1.Main beam headlamps (H7-55W).2.Dipped beam headlamps (H7-55W).3.Daytime running lamps / sidelamps(light emitting diodes - LEDs).4.Direction indicators (PWY-24W).
5.Front foglamps (directional accordingto version) (H11- 55W).
1.Main beam headlamps (H7-55W).2.Dipped beam headlamps (H7-55W).3.Daytime running lamps / sidelamps (W5-5W).4.Direction indicators (PWY-24W).5. Front foglamps (directional accordingto version) (H11- 55W).

163
7
Practical information

Changing main beam headlamp bulbs
)Remove the protective cover by pulling on the tab.)Disconnect the bulb connector. )Pull out the bulb and replace it.
Changing daytime running lamp /
sidelamp bulbs
) Turn the bulb holder a quar ter turn and pull it out. )
Pull out the bulb and replace it.
To reassemble, carry out these operations inreverse order.

Changing the daytime running lamps / sidelamps (light-emittingdiodes - LEDs)

For the replacement of this type of LED lamp, contact a PEUGEOT dealer or a qualified
workshop.

To reassemble, carry out these operations in
reverse order, positioning the alignment lug at
the bottom.

165
7
Practical information
1.Brake lamps (P21W).2.Reversing lamps (R10W).3.Direction indicators (PY21W amber).4.Sidelamps (light emitting diodes -LEDs).
Rear lamps


Changing the light emitting diode-LED lamps

For replacement, contact a PEUGEOT dealer or qualified workshop.
5
.Foglamp (P21W).

181
7
Practical information








Towing a trailer
We recommend the use of genuinePEUGEOT towbars and their harnessesthat have been tested and approved from the design stage of your vehicle, and that the fitting of the towbar is entrusted to a PEUGEOT dealer or a qualified workshop.If the towbar is not fitted by a PEUGEOT dealer, it is imperative that it is fitted in accordance with the vehiclemanufacturer's instructions.
T
owbar suitable for the attachment of atrailer or installation of a bicycle carrier, with
additional lighting and signalling.
Driving with a trailer places greater demands on the towing vehicle and the driver must take par ticular care.

Your vehicle is primaril
y designed for
transpor ting people and luggage, but it may
also be used
for towing a trailer.

182
Practical information
Driving advice
Distribution of loads
)Distribute the load in the trailer so that theheaviest items are as close as possible to
the axle and the nose weight approaches the maximum permitted without exceeding it.
Air density decreases with altitude, thus reducing engine performance. Above
1 000 metres, the maximum towed load must
be reduced by 10
% for every 1 000 metres of altitude.
Side wind
)Take into account the increased sensitivity
to side wind.

Cooling

To w i ng a trailer on a slope increases the
temperature of the coolant.
As the fan is electricall
y controlled, its cooling capacity is not dependent on the engine speed.)
To lower the engine speed, reduce your speed.
The maximum towed load on a long incline
depends on the gradient and the ambient
tem
perature.
In all cases, keep a check on the coolant
temperature.
)If the warning lamp and the
STOP warning lamp come on, stop the vehicle and switch off
the engine as soon as possible.



Braking

To w i ng a trailer increases the braking distance.
To avoid overheating of the brakes on a longmountain type of descent, the use of engine braking is recommended.

Tyres
)Check the tyre pressures of the towingvehicle and of the trailer, obser ving the recommended pressures.



Lighting
)Check the electrical lighting and signalling on the trailer.


The rear parking sensors will be deactivated automatically if a genuine PEUGEOT towbar is used.
R
efer to the "Technical data" section for details
of the weights and towed loads which apply to your vehicle.

184
Practical information














Advice on care and maintenance
Recommendations on the care and maintenance your vehicle are given in the ser vicing booklet.
Matt paint


We recommend the use of a high pressurejet wash, or at least a water hose with a high
output.
We recommend that the vehicle be rinsed using
de-ionised water.
Use only a microfibre cloth to dry the vehicle.
It must be clean and used without heavy pressure.
Lightly wipe off any fuel stains present on the
bodywork using a soft cloth, then leave to dry.
From the range of cleaning and maintenanceproducts in the "TECHNATURE" range
recommended and approved by PEUGEOT,
use only the insect remover and car shampoo,
which are the only products to be used on the
bodywork.
The insect remover can also be used to removeminor marks (for example: finger marks...).
Always have paint repairs done by a PEUGEOT
dealer or a qualified workshop.
I
f you vehicle is finished with a clear matt
lacquer, please obser ve the followingrecommendations to avoid damaging thepaintwork by the use of an inappropriate
cleaning procedures.
These recommendations are also valid for alloy road wheels finished with clear matt lacquer.
Never clean the vehicle without water. Never wash your vehicle in an automatic roller brush car wash.Never polish the vehicle body, nor the alloy wheels. Doing this will make the paintwork shiny.Do not use paint cleaners, abrasive products or paint polishing or preserving products (such as wax, for example) onthe paintwork. These products are only suitable for bright finishes. Application of these products on vehicles with amatt finish will seriously damage thepaint sur face of the vehicle, giving rise to irreversible shiny or stained areas.Never use a high pressure jet wash with
a lance fitted with a brush, this may scratch the paintwork. Never select a wash programme that finishes with a hot wax cycle.

185
7
Practical information




Accessories
A wide range of accessories and genuine par ts is available from the PEUGEOT dealer network.
These accessories and par ts have been tested and approved for reliability and safety.
They are all adapted to your vehicle and benefit from PEUGEOT's recommendation and warranty.



Conversion kits
You can obtain an "Enterprise" kit to conver t a
tra
de vehicle to a private car and vice-versa.

"Comfort":

door deflectors, side blinds and rear blind,
cigarette lighter, boot dividers, coat hanger fixed to head restraint, front centre armrest,
under shelf storage, front and rear parking sensors...
"Transport solutions":
boot liner with dividers, luggage net, roof bars,
bic
ycle carrier on roof bars, ski carrier, roof box...

*
To avoid an
y risk of jamming of the pedals:
- ensure that the mat is positioned and
secured correctly,
- never fit one mat on top of another.
"Styling":
aluminium gear lever knob, spoiler, styling
str
ips, alloy wheels, trims, chromed mirror
shells, body kit, three personalisation lines(Ligne S, Street and Graffic), stickers, interior and exterior mirror shells, parking brake lever grip, alloy wheels, alloy wheel caps...


"Security and safety":

anti-theft alarm, window engraving, wheel
security bolts, child seats and booster cushions, breathalyzer, first aid kit, warning
triangle, high visibility jacket, stolen vehicle
tracking system, temporary puncture repair kit, snow chains, non-slip covers, front foglamps
kit...
"Protection":

mats * , seat covers compatible with lateral
airba
gs, mud flaps, side rubbing strips, bumper
protective mouldings, aluminium or PVC door
aperture finishers...
Tow bar, which mst be fitted byPEUGEOT dealer or a qualified workshop.