2013 NISSAN MURANO ignition

*See your Owner’s Manual for information.
INSTRUMENT BRIGHTNESS CONTROL SWITCH*TWIN TRIP ODOMETER SWITCHES*
HEADLIGHT AND TURN SIGNAL CONTROL
LOW TIRE PRESSURE WARNING LIGHT
DOT MATRIX LIQUID CRYSTAL DISPLAY*
WINDSHIELD WIPER AND WASHER SWITCH STEERING
WHEEL SWITCHES FOR
AUDIO* / BLUETOOTH
® / NAVIGATION
CRUISE CONTROL
HEATED STEERING WHEEL SWITCH
TRUNK LID / LIFTGATE RELEASE SWITCH
BLIND SPOT WARNING /
LANE DEPARTURE WARNING
FUEL-FILLER DOOR RELEASE SWITCH INTELLIGENT KEY
® PORT
VEHICLE DYNAMIC CONTROL (VDC)
OFF SWITCH*
ALL-WHEEL DRIVE (AWD) LOCK SWITCH*
REMOTE WALK-IN SWITCH
TILT / TELESCOPIC STEERING COLUMN*
HOOD RELEASE* CONTROL
PANEL DISPLAY*
PUSH-BUTTON IGNITION SWITCH
AUDIO SYSTEM
AUTOMATIC CLIMATE CONTROLS
FRONT PASSENGER AIR BAG
STATUS LIGHT*
SOFT TOP OPENER SWITCH
010203040506
1011
17
0712
18
192021222324
08
1315
09
1416
2122
09
18
14
12
11
16
10
02
05
0613
20
08
0301
04
17
15
07
19
23
24
Behind
steering wheel
Behind
steering wheel

To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.2
new system features
HEATED STEERING WHEEL (if so equipped)
Once activated, your heated steering wheel will
automatically turn on and off to maintain a temperature
above 6 8°F (20°C).

When the surface temperature of the steering wheel
is above 68°F (20°C) and the control switch

01 is
turned on, the system will not heat the steering wheel.
This does not indicate a malfunction.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
OPENING THE SOFT TOP (CrossCabriolet models)
The soft top can be opened from outside the vehicle
using the door handle request switch
01 as follows:
• The luggage cover must be pulled out and hung
on both hooks.
• The ignition switch must be in the OFF position.
• Push and hold the door handle request switch
01
until the soft top is fully opened.
NOTE: It is important to make sure the NISSAN Intelligent
Key
® is with you (that is, in your pocket or purse).
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
MOVING OBJECT DETECTION (MOD) (if so equipped)
If the MOD system detects moving objects in the rearview view a yellow frame
01 will be
displayed on the camera image and a chime will sound.

To temporarily disable the MOD function, follow this procedure:
1. Start with the vehicle in the P (PA R K) position
2. On the vehicle information display push the SETTING button.
3. Select DRIVER ASSISTANCE and push ENTER.
4. Select MOVING OBJECT DETECTION (MOD )
and press ENTER.

When the following are displayed:
• Blue MOD

02 icon; the system is operative in
this view.
• Gray MOD

02 icon; the system is not operative in this view.
• No MOD icon; the system is off.
For more information, refer to the “Monitor, heater, air conditioner, audio, phone and voice recognition systems (section 4)” of your
Owner’s Manual.
01
01
02
01

t








(
T
t








(
NISSAN INTELLIGENT KEY® SYSTEM
The NISSAN Intelligent Key® system allows you to lock
or unlock your vehicle, open your liftgate/trunk lid and
start the engine.
NOTE: It is important to make sure the Intelligent Key is
with you (that is, in your pocket or purse).

The operating range of the Intelligent Key is within
31.5 in (80 cm) from each request switch.

To lock the vehicle, push either door handle
request switch
01 once or press the
button02 on the keyfob.

To unlock the vehicle, perform one of the
following procedures:
• Push either door handle request switch
01 once;
the corresponding door will unlock. Push the door
handle request switch
01 again within 1 minute;
all other doors will unlock, or
• Press the
button 03 on the keyfob to unlock the driver’s side door. Press the
button
again; all other doors will unlock.

The Intelligent Key can also be used to activate the panic alarm by pressing and holding \
the
button 04 for more than 1 second. Once activated, the panic alarm and headlights w\
ill stay
on for 25 seconds.
NISSAN INTELLIGENT KEY
® BATTERY DISCHARGE

If the battery in the Intelligent Key is almost discharged,
the guide light
05 of the Intelligent Key port blinks and
the Intelligent Key battery discharge indicator 06 is
displayed in the dot matrix liquid crystal display.

To start the engine under these circumstances, insert
the Intelligent Key into the key port with the buttons
facing upward and the key ring end toward you until
it latches into place. Then push the ignition switch to
start the engine.

To remove the Intelligent Key from the port, push the
ignition switch to turn the engine off and then pull the
Intelligent Key out of the port.

The Intelligent Key port does not charge the Intelligent
Key battery. If you see the low battery indicator
06 ,
replace the battery in the Intelligent Key.
NOTE: Do not insert the mechanical key or other objects into the key port because it will damage
the key port.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” , the “Starting and driving (section
5)” and the “Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
6
first drive features
F
02
03
04
01
06
05
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.

11
OUTSIDE MIRROR CONTROL SWITCH
To select the right or left side mirror, turn the control
switch
01 right or left.

To adjust the mirror angle, move the control switch
up, down, right or left.

To prevent accidentally moving the mirror, turn and
set the switch to the middle “neutral” position.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
05
06
To slide the front passenger’s seat back into position,
push the bottom half of the seatback
05 until it
locks. Next, adjust the seatback by pulling the
seatback lever
06 up. Release the lever to lock
the seatback into position.
For more information, refer to the “Safety – Seats, seat belts and
supplemental restraint system (section 1)” of your Owner’s Manual.
AUTOMATIC DRIVE POSITIONER (if so equipped)
Two positions for the driver’s seat, steering column
and outside mirrors can be stored in the automatic
drive positioner memory.

Follow these procedures to set the memory positions:
• Confi rm the shift lever is in the P (PARK) position.
• Push the ignition switch to the ON position.
• Adjust the driver’s seat, steering column and outside mirrors to the desired positions usi\
ng
the adjusting switches for each feature.
• Push the SET switch and within 5 seconds, push the memory switch (1 or 2) for at least
1 second.
• The indicator light on the memory switch you select will illuminate for approximately
5 seconds.
• The driver’s seat, steering column and outside mirror positions are now set to your\
preference.

These memorized positions can also be linked to your NISSAN Intelligent Key®.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
01
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.

HEADLIGHT CONTROL SWITCH
HEADLIGHT CONTROL

Turn the headlight control switch to the
position

01 to turn on the front parking, side
marker, tail, license plate and instrument panel
lights. Turn the switch to the
position
02 to
turn on the headlights.
AUTOLIGHT SYSTEM (if so equipped)

The autolight system will automatically turn the headlights on when it is\
dark and off when it
is light. The system will keep the headlights on for a period of time after you tur\
n the ignition
off and all doors are closed.

To activate the autolight system, turn the headlight control switch to the AUTO position
03
then push the ignition switch to ON. To deactivate the autolight system, turn the headlight
control switch to the OFF,
01 or
position
02 .
HIGH BEAM SELECT

Push the headlight control switch forward 04 to
select the high beam function. The blue indicator
light
illuminates in the instrument panel. Pull
the headlight switch back to the original position to
select the low beam. The blue indicator light goes off.

Pull and release the headlight control switch 05 to
fl ash the headlight high beams on and off.
12
first drive features
01
03
02
STARTING/STOPPING THE EN GINE
Depress the brake pedal.

Press the ignition switch START/STOP button to
start the engine.
NOTE: It is important to make sure the NISSAN Intelligent
Key
® is with you (that is, in your pocket or purse).
TURNING THE ENGINE OFF

Move the shift lever to the P (PARK) position and
apply the parking brake.

Press the ignition switch START/STOP button to
turn the engine off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
04
05
W
















s




To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.