2013 NISSAN MAXIMA Owners Manual

Page 377 of 444

NISSAN MAXIMA 2013 A35 / 7.G Owners Manual BRAKE FLUID
Check the brake fluid level in the reservoir. If the
fluid level is below the MIN line or the brake
warning light comes on, add Genuine NISSAN
Super Heavy Duty Brake Fluid or equivalentDOT

Page 378 of 444

NISSAN MAXIMA 2013 A35 / 7.G Owners Manual ●Keep the battery surface clean and dry.
Clean the battery with a solution of baking
soda and water.
● Make certain the terminal connections are
clean and securely tightened.
● If the vehicle is

Page 379 of 444

NISSAN MAXIMA 2013 A35 / 7.G Owners Manual 1. Remove the vent caps with a screwdriver asshown. Use a cloth to protect the battery
case.
2. Check the fluid level in each cell. If it isnecessary to add fluid, add only distilled
water to bring th

Page 380 of 444

NISSAN MAXIMA 2013 A35 / 7.G Owners Manual CAUTION
●Do not ground accessories directly to
the battery terminal. Doing so will by-
pass the variable voltage control sys-
tem and the vehicle battery may not
charge completely.
● Use electrica

Page 381 of 444

NISSAN MAXIMA 2013 A35 / 7.G Owners Manual 2. Have the belt checked regularly for condi-tion and tension in accordance with the
maintenance schedule found in the
“NISSAN Service and Maintenance Guide”.
REPLACING SPARK PLUGS
Iridium-tipped

Page 382 of 444

NISSAN MAXIMA 2013 A35 / 7.G Owners Manual The air cleaner filter should not be cleaned and
reused. Replace it according to the maintenance
log shown in the “NISSAN Service and Mainte-
nance Guide.” When replacing the filter, wipe the
insi

Page 383 of 444

NISSAN MAXIMA 2013 A35 / 7.G Owners Manual CLEANING
If your windshield is not clear after using the
windshield-washer or if a wiper blade chatters
when running, wax or other material may be on
the blade or windshield.
Clean the outside of the

Page 384 of 444

NISSAN MAXIMA 2013 A35 / 7.G Owners Manual Be careful not to let anything get into the washer
nozzle
A. This may cause clogging or improper
windshield washer operation. If something gets
into the nozzle, remove it with a needle or small
pin