2013 MITSUBISHI OUTLANDER SPORT turn signal bulb

Features and controls3-177
3
Indicators
N00519900127
Turn signal indicators/Hazard warning lights
N00520000216
The arrows will flash in time with the corresponding exterior
turn signals when the turn signal lever is used.
Both arrows will flash when the hazard warning flasher switch
is pressed.NOTE

If the indicator flashes faster than usual or if the indicator
stays on without flashing, check for a malfunctioning turn
signal light bulb or turn signal connection.High beam indicator
N00520100086
A blue light comes on when the headlights are on high beam.Front fog light indicator
(if so equipped)
N00520200175
This indicator comes on while the front fog lights are on.Position indicator
N00551300026
This indicator light illuminates while the position lights are on.ECO mode indicator
(if so equipped)
N00568800023
This indicator will be displayed when fuel-efficient driving is
achieved.
Wa r n i n g l i g h t s
N00520300147
Brake warning light
N00520400470
This light comes on when the ignition switch is turned to the
“ON” position (engine off) or the operation mode is put in ON.
When the engine is started, the light should go off a few sec-
onds later. A warning is also displayed in the multi-information
display.
The warning light also illuminates after starting the engine
under the following conditions.

When the parking brake is still applied.

When the brake fluid level is low.

When the brake system circuit is not working properly.
Before driving, be sure that the parking brake is fully released
and brake warning light is off.
BK0150700US.book 177 ページ ２０１２年３月２２日　木曜日　午後６時４６分

3-192 Features and controls
3Turn signal lever
N00522600450
When changing lanes, or to making a gradual turn, hold the
lever in the “lane change” position (1). It will return to the neu\
-
tral position when you let go. Use the full position (2) when
making a normal turn. The lever will return to the neutral posi-
tion when the turn is complete. There may be times when the
lever does not return to the neutral position. This usually hap-
pens when the steering wheel is turned only slightly. You can
easily return the lever by hand.
Also, when you move the lever to (1) slightly then release it,
the turn signal lights and the indicator light in the instrument
cluster will flash three times.
NOTE

A light in the instrument panel flashes to show when the
front and rear turn signal lights are working properly.
If this light flashes faster than usual, check for a burned
out turn signal light bulb or malfunctioning connection in
the signal.
If the panel light does not come on when the lever is
moved, check for a blown fuse or a burned out bulb in the
panel.
Have the system inspected by your authorized Mitsubishi
Motors dealer or a repair facility of your choice.

It is possible to modify functions as follows:
• Deactivate the turn signal light 3-flash function for lane changes.
• Adjust the time required to operate the lever for the 3-
flash function.
See your authorized Mitsubishi Motors dealer for details.
For vehicles equipped with the Mitsubishi Multi-Commu-
nication System, adjustments can be made using screen
operations. For further details, refer to the separate
owner’s manual.
BK0150700US.book 192 ページ ２０１２年３月２２日　木曜日　午後６時４６分

7-48 Vehicle care and maintenance
7
Bulb capacity
N00943000132
The bulb should only be replaced with a new bulb with the
same rating and type. The type and rating are listed on the base
of the bulb.Outside
N00950300850
Front
Description
Wattage
ANSI Trade No. or Bulb type
1 Front turn signal light 21 W WY21W
2 Headlight, high beam 60 W HB3
3 Daytime running light
/ Front fog light
(Type 1) Front fog
light
35 W H8
Daytime
running
light 13 W P13W
Front fog light (Type 2) 55 W H11
4 Headlight, low beam Halogen
bulb
55 W H11
Discharge
bulb 35 W —
5 Front side-marker and parking
light
5 W WY5W
6 Side turn signal light 5 W —
BK0150700US.book 48 ページ ２０１２年３月２２日　木曜日　午後６時４６分

Vehicle care and maintenance7-49
7
NOTE
It is not possible to repair or replace only the bulb for the
side turn signal light.
Check with an authorized Mitsubishi Motors dealer or a
repair facility of your choice when the light needs to be
repaired or replaced.
NOTE
The rear side-marker light, the tail and stop light and the
high-mounted stop light use an LED instead of the bulb.
Check with an authorized Mitsubishi Motors dealer or
repair facility of your choice when either light needs to be
repaired or replaced.
WARNING
!
Check with an authorized Mitsubishi Motors dealer
or a repair facility of your choice when it is neces-
sary to repair a high intensity discharge headlight or
to replace the bulb.
The power circuit, bulb and electrodes generate high
voltages that may cause a severe shock.
Item
Wattage
ANSI trade No.
or bulb type
7 High-mounted stop light — —
8 License plate light 5 W W5W
9 Back-up light 16 W W16W
10 Rear turn signal light 21 W W21W
11 Rear side-marker light,
and tail and stop light ——Rear
BK0150700US.book 49 ページ
２０１２年３月２２日　木曜日　午後６時４６分

7-56 Vehicle care and maintenance
7
Front turn signal lights
N00943400367
To remove1. Remove the upper cover. For information regarding how to remove the upper cover,
refer to “Removing and installing the upper cover and
duct” on page 7-14.
2. Turn the socket (A) counterclockwise to remove it. 3. Pull the bulb out of the socket.
To install 1. To install the bulb, perform the removal steps in reverse.
2. Install the upper cover. For information regarding how to install the upper cover,
refer to “Removing and installing the upper cover and
duct” on page 7-14.*- Front of the vehicle
BK0150700US.book 56 ページ ２０１２年３月２２日　木曜日　午後６時４６分

Vehicle care and maintenance7-57
7
Side turn signal lights
N00943500137
NOTE
It is not possible to repair or replace only the bulb for the
side turn signal light.
Check with an authorized Mitsubishi Motors dealer or a
repair facility of your choice when the light needs to be
repaired or replaced.
Front fog lights
(if so equipped)
N00943600750
1. Insert a straight blade (or minus) screwdriver with a cloth
over its tip info the light cover (A) and pry gently to
remove it.
BK0150700US.book 57 ページ ２０１２年３月２２日　木曜日　午後６時４６分

Vehicle care and maintenance7-63
7
2. Turn the socket and bulb assembly counterclockwise toremove it.NOTE
The rear side-marker light, and the tail and stop light uses
an LED instead of the bulb.
Check with an authorized Mitsubishi Motors dealer or a
repair facility of your choice when the light needs to be
repaired or replaced. 3. Pull the bulb out of the socket.B- Rear side-marker light, and tail and stop light (LED)
- cannot be replaced
C- Rear turn signal light
BK0150700US.book 63 ページ ２０１２年３月２２日　木曜日　午後６時４６分

Alphabetical index3
EngineCompartment 7-6
Coolant 7-10
,9-9
Hood 7-4
Oil and oil filter 7-7
,9-9
Overheating 6-5
Serial number 9-2
Specification 9-7
Engine coolant temperature display 3-139
Engine hood 7-4
Engine switch 3-22
Exhaust system 7-37
F
Floor console box 3-248
Floor mat 4-3
Fluid Automatic transaxle fluid 9-9
Brake fluid 9-9
Continuously variable transmission (CVT) fluid 7-18
,9-9
Engine coolant 7-10
,9-9
Power steering fluid 9-9
Washer fluid 7-19
,9-9
Fluid capacities and lubricants 9-9
Free-hand advanced security transmitter (F.A.S.T.-key) 3-14 Front fog lights
Bulb capacity 7-48
Indicators 3-177
Replacement 7-57
Switch 3-193
Front seat adjustment 2-3
Front side-marker lights Bulb capacity 7-48
Replacement 7-55
Front turn signal light Bulb capacity 7-48
Replacement 7-56
Fuel Filling the fuel tank 1-4
Fuel economy 4-2
Fuel hoses 7-35
Fuel selection 1-2
Tank capacity 9-9
Fuses 7-39
Fusible links 7-39
G
General maintenance Maintenance 7-36
General vehicle data 9-5
Genuine parts 1-9
Glove compartment 3-247
BK0150700US.book 3 ページ ２０１２年３月２２日　木曜日　午後６時４６分