2013 MINI Paceman wheel bolts

MOBILITYReplacing components
232
Correct the tire inflation pressure
1.After driving approx. 3.1 miles/5 km or
ten minutes, stop at a suitable location.
2. Screw the connection hose 6 of the com-
pressor directly onto the tire valve.
3. Insert the plug 5 into the power socket in
the vehicle interior.
4. Adjust tire pressure to 1.8 bar/26 psi. With
the engine running:
> To increase the inflatio n pressure: switch on
the compressor. To ch eck the current infla-
tion pressure, switch off the compressor.
Do not run the comp ressor for longer
than 10 minutes; otherwise, the
device will overheat and possibly be dam-
aged.<
> To decrease the inflation pressure: press the
release button 9.
If the tire cannot m aintain the inflation
pressure, drive the vehicle again, refer to
Distributing the sealan t. Then repeat steps
1to4.
If an inflation pressure of 1.8 bar/26 psi still can-
not be reached, then the tire is too heavily dam-
aged. Contact your ne arest MINI dealer.<
Driving on
Do not exceed the permitted maximum
speed of 50 mph/80 km/h; doing so may
result in an accident. <
Replace the defective tire as soon as possible
and have the new wheel/tire assembly bal-
anced.
Have the Mobility Kit refilled.
Changing wheels
The tire change set is available from as an
optional accessory at your MINI dealer.
Preparing for a wheel change
Observe the safety precautions regarding
flat tires on page 230.<
Additional safety measures when chang-
ing tires:
Only change the tire wh en parked on a surface
that is level, firm and not slippery.
The vehicle or the jack could slip sideways on
soft or slippery support surfaces, such as snow,
ice, flagstones, etc.
Do not use a wooden block or similar object as a
support base for the jack, as this would prevent
it from extending to its full support height and
reduce its load-carrying capacity.
Do not lie under the vehicle or start the engine
when the vehicle is supported by the jack; other-
wise, there is a risk of fatal injury. <
1. Place the foldable chock
behind the front
wheel on the other side of the vehicle or in
front of the wheel if the vehicle is on an
incline. If the wheel is changed on a surface
with a more severe sl ope, take additional
precautions to secure the vehicle from roll-
ing.
2. Uncover the lug bolts if necessary.
3. Loosen the lug bolts by a half turn.
Jacking up the vehicle
The vehicle jack is designed for changing
wheels only. Do not attempt to raise
another vehicle model with it or to raise any load
of any kind. To do so could cause accidents and
personal injury. <
1. Place the jack at the jacking point closest to
the wheel.
The jack base must be perpendicular to the
surface beneath the jacking point.

00320051004F004C00510048000300280047004C0057004C005200510003

Replacing componentsMOBILITY
233
MINI Countryman:
MINI Paceman:
2. Slide reversible ratchet onto the fixture on
the jack, arrow 1.
3. As you ratchet up the jack, place the jack
head onto the lifting point on the body,
arrow 2.
4. Jack the vehicle up until the wheel you are
changing is raised off the ground.
Mounting the wheel
1.Unscrew the lug bolts and remove the
wheel.
2. Remove accumulations of mud or dirt from
the mounting surfaces of the wheel and
hub. Clean the lug bolts. 3.
Lift the new wheel into place.
4. Screw at least two lug bo lts finger-tight into
opposite bolt holes.
5. Screw in the remaining bolts.
6. Tighten all the lug bolts firmly in a diagonal
pattern.
7. Lower the vehicle.
8. Remove the jack.
Tightening the lug bolts
Tighten the lug bolts in a diagonal pattern.
Immediately have the wheels checked
with a calibrated torque wrench to ensure
that the lug bolts are firmly seated. Otherwise,
incorrectly tightened lug bolts can present a
safety hazard. <
Tightening torque: 103.3 lb ft or 140 Nm.
Replace the defective tire as soon as possible
and have the new wheel/tire assembly bal-
anced.
Vehicle battery
Maintenance
The battery is maintenance-free; that is, the
electrolyte will last for the life of the battery
when the vehicle is operated in a temperate cli-
mate.
If you have any questions regarding your bat-
tery, please contact your MINI dealer.
Battery replacement
Only use vehicle batteries that have been
approved for your vehicle by the manu-
facturer; otherwise, the vehicle could be dam-
aged and systems or func tions may not be fully
available. <
After a battery replacement, have the battery
registered on the vehicle by your MINI dealer to
ensure that all convenie nce functions are fully
available and, if nece ssary, the corresponding

00320051004F004C00510048000300280047004C0057004C005200510003

Everything from A to ZREFERENCE
271
Telephone
– hands-free system171,183
– installation location, refer to Center armrest 97
– voice commands 183
Telephone receiving power, refer to Status
information 19
Temperature display
– setting the units 64
Temperature of coolant, refer to Coolant temperature 217
Temperature setting
– air conditioner 89
– automatic climate control 91
Tempomat, refer to Cruise
control 58
Tensioning straps, refer to Securing cargo 112
Text message 190
Third brake lamp, refer to Center brake lamp 229
Three-point safety belt 42
Tightening the lug bolts
– torque 233,234
Tightening torque, refer to Tightening lug bolts 233
Tire failure
– Flat Tire Monitor 76
– indicator/warning lamp 76
– MINI Mobility Kit 230
– run-flat tires 76
– Tire Pressure Monitor 77
Tire inflation pressure 203
– loss 76,77
Tire pressure monitoring, refer
to Flat Tire Monitor 75
Tire Pressure Monitor TPM 77
– limitations of system 77
– resetting system 78
– warning lamp 78
Tire Quality Grading 210Tires
– age
212
– breaking in 104
– changing, refe r to Changing
wheels 232
– condition 211
– damage 211
– inflation pressure 203
– inflation pressure loss 78
– minimum tread depth 211
– new tires 212
– pressure monitoring, refer to Flat Tire Monitor 75
– pressure monitoring, refer to Tire Pressure Monitor
TPM 77
– puncture 76
– s ize
210
– wear in

dicators, refer to
Minimum tread depth 211
– winter tires 213
– with emergency operation
properties 212
Tires with emergency operation properties, refer to
Run-flat tires 212
Tires with safety features, refer
to Run-flat tires 212
TMC station, refer to Traffic information 133
Tone
– middle setting 142
Tone during audio playback
– adjusting 141
Torque 244
– lug bolts 233
Tow bar 239
Tow fitting 238
– screw thread 238
Tow fittings for tow-starting and towing away 238
Towing 237
– car with automatic transmission 238
– methods 239 Tow rope
239
Tow-starting 237
TPM, refer to Tire Pressure Monitor 77
Track
– selecting on CD 151
Track width, refer to
Dimension 246
Traction control, refer to
– Dynamic Stability Control
DSC 72
Traffic bulletins
– categories 135
Traffic bulletins, filtering 135
Traffic congestion
– displaying traffic
information 133
– refer to Route, bypassing segments 130
Traffic information for navigation
– displaying 134
Traffic information in navigation
– screen display in the map
view 135
Transmission
– automatic transmission with
Steptronic 52
– manual transmission 52
– overriding selector lever lock for automatic transmission
with Steptronic 54
Transporting children safely 46
Transport securing devices, refer to Securing cargo 112
Tread depth, refer to Minimum tire tread 211
Treble, refer to Tone
control 141
Tr ip computer
62
Trip-dista n

ce counter, refer to
Trip odometer 61
Triple turn signal activation 55
Trip odometer 61

00320051004F004C00510048000300280047004C0057004C005200510003