2013 Lancia Voyager oil type

In general, you will first loosen the
child seat adjusters on the lower
straps and tether straps so that you
can more easily attach the hook or
connector to the lower anchorages
and tether anchorages. Then tighten
all three straps as you push the child
restraint rearward and downward
into the seat.
Not all child restraint systems will be
installed as we have described here.
Again, carefully follow the instruc-
tions that come with the child re-
straint system.WARNING!
Improper installation of a child re-
straint to the ISOFIX anchorages
can lead to failure of an infant or
child restraint. The child could be
badly injured or killed. Follow the
manufacturer's directions exactly
when installing an infant or child
restraint.Transporting Pets
Air Bags deploying in the front seat
could harm your pet. An unrestrained
pet could be thrown about and possi-
bly injured, or injure a passenger dur-
ing panic braking or in a collision.
Pets should be restrained in the rear
seat in pet harnesses or pet carriers
that are secured by seat belts.
ENGINE BREAK-IN
RECOMMENDATIONS
A long break-in period is not required
for the engine and drivetrain (trans-
mission and axle) in your vehicle.
Drive moderately during the first
500 km. After the initial 100 km,
speeds up to 80 or 90 km/h are desir-
able.
While cruising, brief full-throttle ac-
celeration within the limits of local
traffic laws contributes to a good
break-in. Wide-open throttle accel-
eration in low gear can be detrimental
and should be avoided. The engine oil installed in the engine
at the factory is a high-quality energy
conserving type lubricant. Oil
changes should be consistent with an-
ticipated climate conditions under
which vehicle operations will occur.
For the recommended viscosity and
quality grades, refer to “Maintenance
Procedures” in “Maintaining Your Ve-
hicle”. NON-DETERGENT OR
STRAIGHT MINERAL OILS MUST
NEVER BE USED.
A new engine may consume some oil
during its first few thousand kilome-
ters of operation. This should be con-
sidered a normal part of the break-in
and not interpreted as an indication of
difficulty.
Additional Requirements
For Diesel Engine
During the first 1500 km avoid heavy
loads, e.g. driving at full throttle. Do
not exceed 2/3 of the maximum per-
missible engine speed for each gear.
Change gear in good time. Do not shift
down a gear manually in order to
brake.
64

 Five Second Unstored Messages
When the appropriate conditions oc-
cur, this type of message takes control
of the main display area for five sec-
onds and then returns to the previous
screen. Examples of this message type
are "Memory System Unavailable -
Not in Park" and "Automatic High
Beams On".
The Reconfigurable Telltales section
is divided into the white telltales area
on the right, amber telltales in the
middle, and red telltales on the left.
When the appropriate conditions ex-
ist, the EVIC displays the following
messages:
 Key in ignition
 Ignition or Accessory On
 Wrong Key
 Damaged Key
 Key not programmed
 Vehicle Not in Park
 Key Left Vehicle
 Key Not Detected Press Brake Pedal and Push Button
to Start
 Liftgate Ajar (chime will sound when vehicle starts moving)
 Low Tire Pressure
 Service TPM System (refer to “Tire Pressure Monitoring System” in
“Starting And Operating”)
 Turn Signal On
 RKE Battery Low
 Service Keyless System
 LOW WASHER FLUID
 Oil Change Required
 Check Gascap
 Left Front Turn Signal Lamp Out
 Left Rear Turn Signal Lamp Out
 Right Front Turn Signal Lamp Out
 Right Rear Turn Signal Lamp Out
 Park Assist Disabled
 Service Park Assist System  Personal Settings Not Available —
Vehicle Not in Park
 Blind Spot System Off — This mes- sage is displayed when the ignition
is turned to ON to indicate the Blind
Spot System has been turned off.
 Blind Spot System Not Available — This message is displayed to indi-
cate the Blind Spot Monitor (BSM)
system is temporarily unavailable
due to sensor blockage, electronic
interference, or other "temporary"
conditions. When this message is
displayed both outside rear view
icons will be illuminated. If elec-
tronic interference is present, the
BSM system will illuminate the icon
only on the side of interference as
long as interference is present.
 Service Blind Spot System — This message is displayed to indicate the
Blind Spot Monitor (BSM) system is
permanently unavailable. The
driver will receive an EVIC mes-
sage and the BSM display warning
in both mirrors will be permanently
illuminated. If this message is pres-
ent see an authorized dealer.
180

Engine Oil Selection – 3.6L
Engine
SAE 5W-30 SELENIA K Power fully
synthetic engine oil that meets FIAT
Classification 9.55535-CR1, API SN,
ILSAC GF-5 or equivalent.
Engine Oil Selection – 2.8L Diesel
Engine
SAE Grade 5W-30 SELENIA MUL-
TIPOWER C3 fully synthetic engine
oil that meets FIAT Qualification
9.55535-S3, API SM/CF, ACEA C3 or
equivalent.
Synthetic Engine Oils
You may use synthetic engine oils pro-
vided the recommended oil quality
requirements are met, and the recom-
mended maintenance intervals for oil
and filter changes are followed.
Materials Added To Engine Oil
Do not add any supplemental materi-
als, other than leak detection dyes, to
the engine oil. Engine oil is an engi-
neered product and its performance
may be impaired by supplemental ad-
ditives.Disposing Of Used Engine Oil And
Oil Filters
Care should be taken in disposing of
used engine oil and oil filters from
your vehicle. Used oil and oil filters,
indiscriminately discarded, can pres-
ent a problem to the environment.
Contact your authorized dealer, ser-
vice station or governmental agency
for advice on how and where used oil
and oil filters can be safely discarded
in your area.
ENGINE OIL FILTER
The engine oil filter should be re-
placed with a new filter at every en-
gine oil change.
Engine Oil Filter Selection
This manufacturer's engines have a
full-flow type oil filter. Use a filter of
this type for replacement. The quality
of replacement filters varies consider-
ably. Only high quality filters should
be used to assure most efficient ser-
vice. LANCIA engine oil filters are a
high quality oil filter and are recom-
mended.
ENGINE AIR CLEANER
FILTER
Refer to the “Maintenance Schedule”
for the proper maintenance intervals.
WARNING!
The air induction system (air
cleaner, hoses, etc.) can provide a
measure of protection in the case of
engine backfire. Do not remove the
air induction system (air cleaner,
hoses, etc.) unless such removal is
necessary for repair or mainte-
nance. Make sure that no one is
near the engine compartment be-
fore starting the vehicle with the air
induction system (air cleaner,
hoses, etc.) removed. Failure to do
so can result in serious personal
injury.
303

BULB REPLACEMENTCAUTION!
Where possible, it is advisable to
have bulbs changed at a LANCIA
Dealership. Proper operation and
orientation of the external lights are
essential for driving safety and
complying with the law.
HIGH INTENSITY
DISCHARGE HEADLAMPS
(HID) (for versions/markets,
where provided)
The headlamps are a type of high
voltage discharge tube. High voltage
can remain in the circuit even with the
headlamp switch off and the key re-
moved. Because of this, you should
not attempt to service a headlamp
bulb yourself. If a headlamp bulb
fails, take your vehicle to an au-
thorized dealer for service.
WARNING!
A transient high voltage occurs at
the bulb sockets of High Intensity
Discharge (HID) headlamps when
the headlamp switch is turned ON.
It may cause serious electrical
shock or electrocution if not ser-
viced properly. See your authorized
dealer for service.
NOTE: On vehicles equipped
with High Intensity Discharge
(HID) headlamps, when the head-
lamps are turned on, there is a
blue hue to the lamps. This dimin-
ishes and becomes more white af-
ter approximately 10 seconds, as
the system charges.
QUAD HEADLAMPS (for
versions/markets, where
provided)
1. Raise the hood to access the high
or low beam bulbs at the rear of the
headlamp housing.
2. Release the two tabs on the side of
the connector and remove the connec-
tor from the bulb. 3. Twist the headlamp bulb and pull
the bulb from the headlamp housing.
4. Install the new headlamp bulb and
twist until locked into the headlamp
housing.
CAUTION!
Do not touch the new bulb with
your fingers. Oil contamination will
severely shorten bulb life. If the
bulb comes in contact with an oily
surface, clean the bulb with rub-
bing alcohol.
5. Reconnect the wiring connector to
the bulb.
FRONT TURN SIGNAL AND
SIDE MARKER LAMPS
Access to change the turn signal or
side marker bulb is from the rear of
the headlamp housing.
1. Twist the turn signal or side
marker socket to remove the socket.
2. Pull bulb from the socket.
3. Replace the bulb and reinstall
socket.
324

Adding Engine Coolant(Antifreeze) . . . . . . . . . . . . . .311
Adding Fuel . . . . . . . . . . . . . . .270
Adding Washer Fluid . . . . . . . . .308
Additives, Fuel . . . . . . . . . . . . . .269
Adjustable Pedals . . . . . . . . . . . .130
Airbag . . . . . . . . . . . . . . . . .44, 50
Airbag Deployment . . . . . . . . . . .51
Airbag Light . . . . . . .49, 53, 66, 172
Airbag Maintenance . . . . . . . . . . .52
Airbag, Side . . . . . . . .47, 48, 49, 50
Airbag, Window (Side Curtain) . . . . . . . . . . . .47, 48, 50
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . . . . . . . . . .303
Air Conditioner Maintenance . . . .306
Air Conditioning Filter . . . . .222, 307
Air Conditioning, Operating Tips . . . . . . . . . . . . . . . . . . .222
Air Conditioning, Rear Zone . . . .220
Air Conditioning Refrigerant . . . . . . . . . . .306, 307
Air Conditioning System . . .215, 306
Air Pressure, Tires . . . . . . . . . . .248
Alarm Light . . . . . . . . . . . . . . .173
Alarm (Security Alarm) . . . . . . . . .15
Alterations/Modifications, Vehicle . . .8
Antifreeze (Engine Coolant) . . . . . . . . .310, 311, 327 Disposal
. . . . . . . . . . . . . . .311
Anti-Lock Warning Light . . . . . .170
Anti-Theft System . . . . . . . . . . . .15
Ashtray . . . . . . . . . . . . . . .145, 147
Auto Down Power Windows . . . . . .26
Automatic Dimming Mirror . . . . . .77
Automatic Door Locks . . . . . . . . .22
Automatic Headlights . . . . . . . . .124
Automatic Oil Change Indicator . .184
Automatic Temperature Control (ATC) . . . . . . . . . . . . . . . . . .215
Automatic Transaxle Adding Fluid . . . . . . . . . . . .315
Fluid Level Check . . . . . . . . .315
Automatic Transmission . . .232, 314,
315
Adding Fluid . . . . . . . . . . . .315
Fluid and Filter Changes . . . .315
Fluid Change . . . . . . . . . . . .315
Fluid Type . . . . . . . . . . . . . .314
Gear Ranges . . . . . . . . . . . . .234
Special Additives . . . . . . . . . .314
Auto Up Power Windows . . . . . . . .26
Battery . . . . . . . . . . . . . . . . . . .305
Jump Starting . . . . . . . . . . . .291
Keyless Transmitter Replacement
(RKE) . . . . . . . . . . . . . . . . . .20
Saving Feature (Protection) . .125Belts, Seat
. . . . . . . . . . . . . . . . . .65
Blind Spot Monitoring . . . . . . . . . .80
Body Mechanism Lubrication . . . .308
B-Pillar Location . . . . . . . . . . . .258
Brake Assist System . . . . . . . . . .244
Brake Control System, Electronic . . . . . . . . . . . . . . .243
Brakes . . . . . . . . . . . . . . . . . . .313
Brake System . . . . . . . . . . . . . . .313
Fluid Check . . . . . . . . . . . . .313
Parking . . . . . . . . . . . . . . . .241
Warning Light . . . . . . . . . . .173
Brake/Transmission Interlock . . . .233
Break-In Recommendations, New Vehicle . . . . . . . . . . . . . . . . . .64
Bulb Replacement . . . . . . . . . . .324
Bulbs, Light . . . . . . . . . . . . .67, 323
Calibration, Compass . . . . .178, 187
Camera, Rear . . . . . . . . . . . . . .138
Capacities, Fluid . . . . . . . . . . . .327
Caps, Filler Fuel . . . . . . . . . . . . . . . . . .270
Oil (Engine) . . . . . . . . . . . . .300
Power Steering . . . . . . . . . . .240
Carbon Monoxide Warning . . . . . .65
Cargo Area Features . . . . . . . . . .154
Cargo Compartment . . . . . . . . . .154
Luggage Carrier . . . . . . . . . .155
342