2013 FORD F150 ECO mode

OFF-ROAD MODE
Off road mode changes the calibrations of four systems on the vehicle to
enhance off road performance:
•Electronic locking differential (ELD)-Any speed thresholds for
the ELD are lifted. The ELD will remain locked up to the maximum
vehicle speed when engaged.
•AdvanceTrac–When off-road mode is engaged, the AdvanceTrac
settings are altered for optimized off-road performance.
•Transmission shifting and response-The transmission shift
schedule is altered for improved off road performance. Upshifts are
delayed and occur less frequently. This will provide the best possible
vehicle response and acceleration.
•Engine throttle calibration-The engine throttle calibration is
altered for improved off-road performance.
Note:Operating the vehicle in this mode does not guarantee that the
vehicle will not become stuck in sand, snow or mud, etc. It is the driver’s
responsibility to assess off-road situations and determine if the terrain is
passable.
Note:Tow/haul mode will be disabled when off-road mode is active. If
tow/haul mode is active, it will be disabled when off-road mode is active.
Enabling Off-Road Mode
WARNING:Off-road mode is specifically calibrated for off-road
driving conditions and should never be used on pavement.
To enter off-road mode the following conditions must be met:
•The vehicle must be traveling less than 5 mph (8 km/h)
•Your foot must be off of the accelerator pedal
Note:If any of the conditions are not met, the information display
screen will display the appropriate messages to guide the driver through
the proper operating procedures.
Driving
10
2013 F-150(f12)
Supplement, 1st Printing
USA(fus)

To activate off-road mode press the
button located on the center
console. A chime will sound and a
message will appear indicating that
it is activated.
Disabling off-road mode
To disable off-road mode once it is active press the off-road mode button
a second time. A chime will sound and a message will appear indicating
that it is deactivated.
AdvanceTracModes
During off-road mode the AdvanceTrac system provides the vehicle with
alternative AdvanceTraccalibrations, which improve off-road
performance.
Off road AdvanceTrac calibrations are enabled for2Hand4H. When the
AdvanceTrac button is pressed once AdvanceTrac Sport will engage. In
this mode he vehicle will have ABS, traction control and yaw control
settings specifically calibrated for off-road condition. When the
AdvanceTrac button is pressed and held AdvanceTrac will become
disabled. In this mode only off-road calibrated ABS remains active. Also,
when off-road mode is not engaged, the AdvanceTrac disabled mode will
not revert to AdvanceTrac Sport mode above the speed threshold in
place.
To switch between AdvanceTrac
modes with off-road mode active,
press the AdvanceTrac button
located on the instrument panel.
•AdvanceTrac Sport-Pressing the stability control off button once
places the vehicle in the off-road sport mode. In this mode Electronic
Stability Control (ESC), Traction Control Stability (TCS) and Anti-lock
Brake System (ABS) are altered for a unique off-road mode
calibration. TCS and ESC allow for more tire spin and vehicle slip. Roll
Stablility Control (RCS) is disabled in this mode.
Driving
11
2013 F-150(f12)
Supplement, 1st Printing
USA(fus)

AdvanceTrac with RSC features when using Off-road mode
Off
-road
modeButton functions“Sliding
car” iconInformation display
RSC ESC TCS ABS
AdvanceTrac Off-road mode
– Default at start-up Off Enabled Off On On On Street
Off Button pressed momentarily On Sport Off On Sport Sport Street
Off Button pressed and held for more
than 5 seconds while traveling
under 35 mph (56 km/h)Flashes, then
stays onDisabled Off Off Off Off* Street
Off Vehicle speed exceeds 35 mph
(56 km/h) while/after button is
pressed and held for more than
5 secondsOn Disabled Off On Sport On Street
On Button pressed momentarily
On Sport On Off Sport SportOff-
Road
On Button pressed and held for more
than 5 secondsFlashes, then
stays onDisabled On Off Off Off*Off-
Road
Note:When off-road mode is on, pressing the stability control off button will change the ABS to an
off-road specific calibration. The ABS off-road mode desensitizes the ABS. The ABS calibration in
off-road mode is optimized for performance on off-road surfaces. This helps on very rough
terrain/adverse driving conditions where the standard ABS calibration may become too active and
hinder the type of driving required in off-road conditions.
For more information on the AdvanceTracand its operation, refer to theAdvanceTracsection
in theStability Controlchapter of yourOwner’s Manual.
Driving
13
2013 F-150(f12)
Supplement, 1st Printing
USA(fus)

Whether accelerating or decelerating, once the desired descent speed is
reached, remove your feet from the pedals and the chosen vehicle speed
will be maintained.
See theInformation Displayschapter of yourOwner’s Manualfor hill
descent mode messages.
Disabling hill decent control
To disable hill decent control press the button located on the center
console a second time. A light on the button will turn off and a message
will appear indicating this feature has been disabled.
UPFITTER CONTROLS
The auxiliary switchboard on the
center console makes aftermarket
customization easier, with four
prewired switches attached to the
power distribution box for electrical
accessories.
These switches are labeledAUX 1,AUX 2,AUX 3andAUX 4. They
will only operate while the ignition is in the on position, whether the
engine is running or not. It is, however, recommended that the engine
remain running to maintain a battery charge when using the switches for
an extended duration or higher current draws. When switched on by the
operator they provide 10 amps, 15 amps or 30 amps of electrical battery
power for a variety of uses.
The switches control relays and
fuses that are located under the
hood in the auxiliary switch pass
through circuits. See the
Engine/Transmissionchapter of
this supplement for the underhood
overview location of this component.
AUX 1
AUX 2
AUX 3
AUX 4
Driving
15
2013 F-150(f12)
Supplement, 1st Printing
USA(fus)

The front camera system is located
on the front grille.
If the front grille of the vehicle is hit or damaged, check with your
authorized dealer to have your front off-road video system checked for
proper coverage and operation.
Using the Front Off-Road Camera System
Note:At night time or in dark areas, the camera system relies on the
front headlamps lighting to produce an image.
Note:The vehicle must be traveling below 15 mph (25 km/h) for the
front off-road camera to operate. Traveling above 15 mph (25 km/h)
while the camera is active will cause the camera to shut off, it will not
turn back on until the vehicle goes below 13 mph (21 km/h).
Note:Adjusting the brightness and contrast of the screen may help the
image on the screen become more clear. These settings can be adjusted
in theSettingsmenu when the front camera is active.
Note:If the front off-road mode camera system image is not clear or
seems distorted, it may be covered with water droplets, snow, mud or
any other substance. If this occurs, clean the camera lens with the front
camera washer system, or with a soft, lint-free cloth and non-abrasive
cleaner.
Turning on the Front Off-Road Camera System
The following conditions must be met to turn on the system on:
•You must be in off-road mode with electronic locking differential
(ELD) activated or
•You must be in4L
Driving
18
2013 F-150(f12)
Supplement, 1st Printing
USA(fus)

exterior finishes as well as bent, cracked or broken body, frame and
chassis components may not be covered by warranty.
It is important that you take the time to become familiar with the
controls and dynamics of your vehicle before attempting higher speed
off-roading. Some points to consider:
•Build up speed slowly. Initially, drive at a pace which allows ample
time to fully assess the terrain around you and to understand how the
vehicle is responding to both the terrain and driver inputs. Increase
pace as comfort increases while always being mindful of how the
vehicle is responding to various events at different speeds.
•Find a wide open place to experiment with different functions on the
truck. Try a given maneuver with different vehicle settings (4H vs.
4L), (differential locked vs. unlocked), (AdvanceTrac in key-on vs.
single press vs. press and hold modes) and see how the truck
responds. Start slowly and build pace as comfort increases.
•Similarly, in a wide open space, experiment with different driving
techniques. For example, if the vehicle is tending to push straight
ahead when trying to negotiate a turn (understeering or plowing), a
light application of the brake while turning may help rotate the truck.
A wider entry to the corner or entering the corner more slowly may
help the truck turn and allow you to apply the throttle sooner after
negotiating the turn.
•Remember the phrase smooth is fast. This refers to your steering,
throttle, and brake movements. Smooth decisive movements will yield
improved results while helping to increase safety.
•As speed increases, it is wise to look farther ahead of the vehicle so
that there is time to react to oncoming obstacles. Remember that in
many off-road environments, obstacles will be hard to see until they
are relatively near. A good strategy is to alternate between looking far
ahead and up closer to the front of the vehicle as you’re driving.
•Also remember to drive what you can see. This refers to not driving
faster than you are able to negotiate unforeseen upcoming obstacles.
This could refer to obstacles over a brow, in a ravine, in brush, in
dusty conditions, and in the darkness among others.
•If you are driving in a dusty area. Be sure to leave ample distance
between you and any other vehicles to ensure adequate vision.
•Always remember that you may not be the only one in a particular
recreational area, always be cognizant of others in your area. This is
especially true of motorcycles and ATV’s which may be more difficult
to spot than a full-sized vehicle.
Driving
26
2013 F-150(f12)
Supplement, 1st Printing
USA(fus)

•If driving in desert conditions, it is advised that you always drive with
your headlights on to help other drivers more easily see you.
•While driving in desert conditions, the midpoint of the day is the most
difficult time to see many of the small ridges and dips due to flat
shadows from the sun being at its highest point. Extreme care should
be taken at these times to not inadvertently run into these obstacles.
•It is highly encouraged that you switch to off-road mode and perform
an AdvanceTrac single press to ensure improved off-road braking
performance under these conditions. Be sure to disengage the off-road
mode and switch back to AdvanceTrac key-on mode before performing
any street driving. Please see the Off-road mode section of this
supplement for more details.
AFTER OFF-ROAD DRIVING
It is important to complete a full vehicle inspection after off-road driving.
Some items to check include:
•Ensure that tires are inflated to proper tire pressure as indicated on
the tire placard.
•Check the wheels and undercarriage for built up mud or debris which
can cause vehicle vibration.
•Ensure that the grille and radiator are clear of any obstructions that
may affect cooling.
•Ensure that the brakes are in proper working order and free of any
mud, stones etc., which can become trapped around the brake rotor,
backing plate and caliper.
•Check that the air filter is clean and dry.
•Inspect for torn or punctured boots on ball joints, half shafts, steering
gears.
•Inspect exhaust system for damage or looseness.
•Inspect undercarriage fasteners. If any are loose or damaged, tighten
or replace ensuring that the proper torque specification is used.
•Inspect the tires for any cuts in the tread or sidewall area. Also
inspect the sidewall for any bulge indicating damage to the tire.
•Inspect the wheels for dents, cracks, or other damage.
Driving
27
2013 F-150(f12)
Supplement, 1st Printing
USA(fus)

WARRANTY COVERAGE
The F-150 Raptor carries the same New Vehicle Limited Warranty as
other Ford F-150 models. This information is covered in its entirety in
your warranty information.
Warranty service for the F-150 Raptor or any SVT vehicle can be
obtained at any Ford dealer nationwide.
SVT does not recommend modifying or racing SVT vehicles, as they are
designed and built to be driven as delivered from the factory. The
warranty information discusses vehicle usage and the installation of
aftermarket parts and their effect on warranty coverage.
Ford SVT has engineered your F-150 Raptor for off-road use beyond
what is normal for a F-150. However, it can incur damage if driven
beyond its capabilities. Skid plates, shock guards and running boards
were designed to help limit damage to vital components and exterior
finishes, but cannot prevent all damage if driven in extreme off-road
conditions. Damage to skid plates, shock guards, running boards and
exterior finishes as well as bent, cracked or broken body, frame and
chassis components may not be covered by warranty.
Vehicle damage caused by driving through deep water at excessive
speeds may not be covered under warranty. (SeeDriving your F-150
SVT Raptor off-roadin theDrivingchapter of this supplement for
maximum allowable vehicle speeds when driving in deep water
conditions).
Please see the warranty information for complete information.
Perform Multi-Point Inspection and the inspections outlined in Scheduled
Maintenance information. Refer to the vehicle’sWorkshop Manualfor
removal and installation procedures. Replace with genuine Ford and
Motorcraftservice parts as needed.
These modifications may not necessarily protect your engine from
damage in competition conditions. Subjecting your vehicle to competition
conditions even with these proposed modifications may render repairs
non-reimbursable under the New Vehicle Limited Warranty.
Warranty Coverage
37
2013 F-150(f12)
Supplement, 1st Printing
USA(fus)