Page 37 of 364
35
Hybrid system
Hybrid4 mode selector
The selector allows the user to choose between 4 drive modes for the vehicle.
Turn the dial to the ri
ght or left; the mode selected is confirmed by illumination of the corresponding indicator.
ZEVmode, to force electric runnin
g.Spor
tmode, to make use of the maximum
performance of the vehicle.
4WDmode, to force the vehicle into 4x4 mode.
AUTOmode, for normal use and optimised fuelconsumption.
On star ting the vehicle: with the gear selector in position N, press the brake pedal and press
the STA R T/STOP button to activate the hybrid system.
This lamp comes on when the vehicle is ready
to move off ("Auto" mode is on by default) andso the driver can press the accelerator.
This lamp comes on more or less instantly but may take a few seconds in some cases (inparticular, the time needed for pre-heating the
Diesel engine in cold weather or, for example,
in energy economy mode, ...).
Ready lamp
With the vehicle stationary, press the STA R T/STOP button and check that the Readylamp is off when leaving thevehicle, other wise the hybrid system will still be active.
For more information, refer to the section on "Underbonnet precautions / warnings".
Page 56 of 364
Car washing machine or tunnel
the wash.
With the hybrid system active, Ready
lamp on, parking brakereleased: - Place the gear selector in position N.- Switch off the engine (press on STA R T/STOP). The parking brake is applied automatically and the Ready
lamp goes off inthe instrument panel.- Switch on the ignition again (press on START/STOP) without your foot on the brake pedal. The Ready
lamp remains off. - Release the parking brake using the manual control on thecentre console, while keeping your foot on the brake pedal. - Switch off the ignition (press on STA R T/STOP without your foot on the brake pedal) checking that the parking brake
remains released.
If the Diesel engine is not running, it restar ts.If the Diesel engine is running, it remains running without timelimit.
With the hybrid system active, Readylamp on, parking brakereleased: - Place the gear selector in position N(Auto or Sport mode). - Press the brake pedal then the ECO OFF button.
Car washing machines or tunnels in which theDiesel engine must be switched off.
Car washing machines or tunnels in which the Diesel engine must not be switched off.
Page 57 of 364
55
Hybrid system
Vehicle recovery
Before doing any work, with the ignition on, press the brake pedal and put the gear selector to
position N, then switch off the hybrid system.
If necessary because access to the vehicle is difficult, it can be moved a few dozen metres at a speed not exceeding 6 mph (10 km/h).
Use the towing eyes only to pull a vehicle out or
to pull it onto a flat-bed.
The front or rear wheels must not be on theground, use a flat-bed lorry or trailer to recover
t
he vehicle.
Page 63 of 364
61Monitoring
Rear foglamps
fixed. The rear foglamps are switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamps.
Warning / indicator lampStateCauseAction / Observations
Diesel engine pre-heating fixed. The STA R T/STOP
switch has been pressed (ignition on). Wait until the warning lamp goes off before star ting.
The period of illumination of the warning lamp is
determined by the ambient conditions (up to about
thirty seconds in extreme conditions).
If the engine does not star t, switch the ignition off and
then on, wait until the warning lamp goes off again,
then start the engine.
Electric parking brake
fixed. The electric parking brake is applied. Release the electric parking brake to switch off the
warning lamp: with your foot on the brake pedal, pull
the electric parking brake control lever.
Obser ve the safety recommendations.
For more information on the electric parking brake,
refer to the corresponding section.
Deactivation of the automatic functions of the electric parkingbrake
fixed. The "automatic application" (on switching off the engine) and
"automatic release" functions aredeactivated or faulty.
Activate the function (according to country) via the
vehicle configuration menu or contact a CITROËN
dealer or a qualified workshop if automatic
application / release is not possible.
The parking brake can be released manually using the emergency release procedure.
For more information on the electric parking brake,
refer to the corresponding section.
Page 64 of 364
Warning / indicator lampStateCauseAction / Observations
Automatic wipingfixed.The wiper control is pushed downwards. Automatic front wiping is activated.
To deactivate automatic wiping, operate the controlstalk downwards or put the stalk into another position.
Passenger's airbag systemfixed in the seat beltand passenger's front
airbag warning lamps
display.
The control switch, located in the glove
box, has been placed in the "ON"
position.
The passen
ger's front airbag is activated.
In this case, do not install a "rear facing"child seat.
Move the control switch to the "OFF"
position to
deactivate the passenger's front airbag.
In this case,
you can install a "rear facing" child seat.
Foot on the
brake pedalfix
ed. The brake pedal is not pressed. Press the brake pedal to star t the hybrid system (gear
selector in position N).
If you wish to release the parking brake withoutpressing the brake pedal, this warning lamp will
remain on.
flashing.If you hold the vehicle on a rising
incline using the accelerator for toolong, the clutch overheats. Use the brake pedal and
/or the electric parking brake.
Page 67 of 364
65
Monitoring
Warning / indicator lampStateCauseAction / Observations
Electric parking
brake
flashing.The electric parking brake is not
app
lied automatically.
The application/release is faulty. You must stop as soon as it is sa
fe to do so.
Park on
flat level ground, switch off the ignition and contact a CITROËN dealer or a qualified workshop.
Electric parking brake fault
fixed. The electric parking brake has a fault. Contact a CITROËN dealer or a qualified workshop
without delay.
The parking brake can be released manually using the emergency release procedure.
For more information on the electric parking brake,
refer to the corresponding section.
Deactivation of the automatic functions of the electric parkingbrake
fixed. The "automatic application" (on switching off the engine) and
"automatic release" functions aredeactivated or faulty.
Activate the function (according to country) via the
vehicle configuration menu or contact a CITROËN
dealer or a qualified workshop if automatic
application / release is not possible.
The parking brake can be released manually using the
emergency release procedure.
For more information on the electric parking brake,
refer to the corresponding section.
Page 68 of 364
Warning / indicator lampStateCauseAction / Observations
Dynamic stability control(DSC/ASR)
flashing.The DSC/ASR regulation is
operating. The system optimises traction and improves the
directional stability of the vehicle.
fix
ed. Unless it has been deactivated
(button pressed and its indicator lamp
on) the DSC/ASR system has a fault.Have it checked b
y a CITROËN or a qualified
workshop.
Engine autodiagnosis system
flashing.The engine management system hasa fault. Risk of destruction of the catalytic converter.
Have it checked by a CITROËN dealer or a qualified workshop.
fixed. The emission control system has afault. The warning lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or qualified
workshop without delay.
Anti-lockBraking System(ABS)
fixed. The anti-lock braking system has a
fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a CITROËN dealer or a qualified workshop without delay.
Brakingfixed. The braking system fluid level has
dropped significantly.You must stop as soon as it is safe to do so.
Top up with brake fluid listed by CITROËN.
If the problem persists, have the system checked by aCITROËN dealer or a qualified workshop.
+ fixed, associated
with the ABS warnin
glamp. Th
e electronic brake force distribution(EBFD) system has a fault.You must stop as soon as it is safe to do so.
Have it checked by a CITROËN dealer or a qualified
workshop.
Page 128 of 364
It is recommended that you do notapply the parking brake in very coldconditions (ice) and during towing (recovery...). To do this, release the parking brake manually, select position A
or R
, then press the STA R T/STOP switch to stopthe engine.
The electric parking brake combines
2 operating modes:- Automatic Application/ReleaseApplication is automatic when the engine
stops, release is automatic on use of the
accelerator (this mode is activated by
default), -Manual Application/ReleaseManual application of the parking brake is done by pulling control lever A.Manual release is done by pullingthenreleasing the control lever, while pressing
the brake pedal
When the driver's door is opened, there is an
audible signal and a message is displayed if the
brake is not applied.
Programming the automatic
mode
Depending on the country of sale of the vehicle,
the automatic application when the engine isswitched off and the automatic release when
you press the accelerator can be deactivated.
You can contact a CITROËN dealer or a qualified workshop to have it activated.
In this case, programming is done via
the configuration menu.
Electric parking brake
If deactivated, the parking brake must
be applied and released manually.
If this warning lamp comes on in
the instrument panel, the automaticmode is deactivated.
Never leave the vehicle without checking that the parking brake is on.
This warning lamp comes onfixed (not flashing).
Label on door panel
