2013 Citroen DS5 HYBRID4 ignition

21Familiarisation
Monitoring
On switching on, the dial needles go to the extent of their travel then return to 0.
A.With the ignition on, the bars indicate the
fuel remaining.

Instrument panel
1.
With the ignition on, the orange and redwarning lamps come on. 2.With the hybrid system active, these
warning lamps should go off.
If a warning lamp remains on, refer to thecorresponding section.


Warning lamps
59
B.
With the ignition on, the instrument panelscreen should indicate the oil level.
If the levels are not correct, top up the level which is low.
58

If this warning lamp comes on in
the instrument panel, automatic application / release is
deactivated. The parking brake must
be applied and released manually. y


Before leaving the vehicle, check that
the the brake warning lamp and the Pwarning lamp in the control lever Aare on fixed (not flashing).
126


If towing a trailer or caravan or if theslope might vary (transpor t by boat or lorry, recovery of the vehicle...) make a maximum application of the parking brake - by making a long pull on the
control lever A
- to immobilise thevehicle.

Driving safely
Electric parking brake
Manual Application/Release
Manual applicationof the parking brake is possible by pulling
the control lever A.With the ignition on, manual release
of the parking brake is possible by pressing the brake pedal
and pulling
then releasing
the control lever A
.


If an audible signal is heard on opening the driver's door with the hybrid system active, apply the parking brake
manually. Do not leave a child alone in the vehiclewith the ignition on; they might releasethe parking brake.


Automatic Application / Release

Press the accelerator pedal, the parking brake
is released automatically and progressively as you move off.
With the vehicle stationary, the parking brake
is applied automatically on switching off the
ignition (Readylamp off).

Switching off the Hybrid4
s
ystem
- Before switching off the Hybrid4 system,place the gear selector in position N.
- Make a shor t press on the START/STOPbutton.
- The s
ystem shuts down and the steeringcolumn locks.

When your vehicle vehicle moves off in electric mode, it makes no noise. Be ver y careful of pedestrians as they will not hear you coming.
For more information, see the section on "Underbonnet precautions/warnings".
When stationary, switch off the ignitionand check that the Ready
lamp is off before leaving the vehicle, other wisethe hybrid system will still be active.

33Hybrid system











Anti-theft protection
Electronic engine immobiliser
The keys contain an electronic chip which hasa secret code. When the ignition is switched
on, this code must be recognised in order for
starting to be possible. This electronic engine immobiliser locks the
engine management system a few minutes after the ignition is switched off and prevents
starting of the engine by anyone who does not have the key.
In the event of a malfunction, you are informed
by a message in the instrument panel screen.
In this case, your vehicle does not start; contacta CITROËN dealer as soon as possible.
Ignition on without starting
the engine
(accessory position)

With the electronic key in the reader or the
Keyless Entry and Star ting key inside the
vehicle, pressing the "START/STOP" button,
with no action on the pedals, allows the ignition
to be switched on and so activate the ancillary equipment.
)
Press the "START/STOP" button,
the instrument panel comes on but the engine does not star t.) Press the button again to switch
off the ignition and so allow the
vehicle to be locked.
If you use the accessory position for toolong, the system automatically goes intoeconomy mode to avoid the risk of a flatbattery.

ECO OFF switch
This function prevents the Diesel engine
being switched off and so ensures that a comfor table temperature can be maintained in
the passenger compar tment (air conditioningrunning continuously).On pressing the switch, the engine restar ts
immediately.
To return to normal operation, press the switch
again.
After switching off the ignition, the vehicle will return to normal operation (lamp in the switch off).

*

Except in ZEV mode, which favours electric
running over assuring a comfortable
temperature.
During electric running and when the engine is
stopped, the hybrid system manages restarting
automatically to assure comfor t levels in the
passenger compartment * .
However, variations in temperature may still be felt in very hot climates. To avoid anydiscomfor t in these conditions you can operate
the ECO OFF switch.

The high voltage battery must not in anycircumstances be charged from an external source and must only be handled by a
workshop technician.
There is the risk o
f serious burns, as well as electric arcs that could cause serious injury or
even death.
A used Ni-MH (Nickel Metal Hydride) type high voltage battery must be removed in an
appropriate manner by a repair workshop,so that its recycling presents no risk to the environment.
High voltage
The voltage used for the operation of theelectric motor is in the range 150 to 270 Volts.
Be sure to take account of the warning labels
fitted to the vehicle.
Ta k e great care regarding the high voltage andhigh temperatures of components carrying the current.

Emergency cut-off

In the event of an accident, a cut-off system blocks the high voltage current and cuts off
the fuel pump; your vehicle can no longer be started.
To restar t the hybrid system, contact a CITROËN dealer.
High voltage cables are routed under the
vehicle
(sills); take care not to damage them
when the vehicle is used for off-road activity (such as covering rough ground).
Be
fore doing any workon the vehicle, switch off the ignition (Readylamp off).



Battery precautions

Hi
gh voltage cables
Take care to position lifting equipment(jack, hoist, ...) at the locations provided to avoid damaging the cables.


Never touch, dismantle, remove or replace the high voltage par ts, orange cables or connectors, even in the eventof an accident.

53Hybrid system





Underbonnet precautions / warnings

The alternator-star ter motor of your hybrid
vehicle is also supplied at high voltage. If the
vehicle ignition has not been switched off, there
is a risk of the engine restar ting at any time.
Alwa
ys ensure that the
ignition is switched off (Readylamp off) before
opening the bonnet.
Also ensure that the ignition is switchedoff when refuelling to avoid the engine restarting.

Car washing machine or tunnel
the wash.
With the hybrid system active, Ready
lamp on, parking brakereleased: - Place the gear selector in position N.- Switch off the engine (press on STA R T/STOP). The parking brake is applied automatically and the Ready
lamp goes off inthe instrument panel.- Switch on the ignition again (press on START/STOP) without your foot on the brake pedal. The Ready
lamp remains off. - Release the parking brake using the manual control on thecentre console, while keeping your foot on the brake pedal. - Switch off the ignition (press on STA R T/STOP without your foot on the brake pedal) checking that the parking brake
remains released.



If the Diesel engine is not running, it restar ts.If the Diesel engine is running, it remains running without timelimit.

With the hybrid system active, Readylamp on, parking brakereleased: - Place the gear selector in position N(Auto or Sport mode). - Press the brake pedal then the ECO OFF button.
Car washing machines or tunnels in which theDiesel engine must be switched off.
Car washing machines or tunnels in which the Diesel engine must not be switched off.