Page 219 of 420
217
5
Visibility
The windscreen wipers operate automatically,
without any action on the par t of the driver, if
rain is detected (sensor behind the rear view mirror), adapting their speed to the intensity of
the rainfall.
Switching on
Switching off
The automatic rain sensitive windscreenwipers must be reactivated by pushing the control stalk downwards, if theignition has been off for more than oneminute. Brie
fly push the control stalk downwards.
A wiping cycle confirms that the instruction has been accepted.
This warning lamp comes on in theinstrument panel and a message is displayed. Brie
fly push the control stalk
downwards again, or place the control stalk in another position (Int, 1 or 2).
Automatic rain sensitive
w
indscreen wipers
This warning lamp goes off in the instrumentpanel and a message is displayed.
Page 231 of 420

229
6
Safety
Dynamic stability control(DSC)
The DSC system offers exceptional safety in normal driving, but this should not encourage the driver to take extra risks or drive at high speed.
The correct operation of the system depends on obser vation of the manufacturer's recommendationsregarding the wheels (tyres and rims),the braking components, the electronic components and the assembly andrepair procedures used by CITROËNdealers.
After an impact, have the systemchecked by a CITROËN dealer or a qualified workshop.
Activation
This system is activated automatically each
time the vehicle is started.
It comes into operation in the event of a grip or
trajectory problem.
Deactivation
In exceptional conditions (starting a vehicle which is bogged down, stuck in snow, on softground...), it may be advisable to deactivate
the DSC system, so that the wheels can move
freely and regain grip.
This is indicated by
flashing of thiswarning lamp in the instrument panel.
Operating fault
But it is recommended that the system bereactivated as soon as possible.
)
Press the button.
This warnin
g lamp and the indicator lamp in the button come on: the
DSC system no longer acts on theoperation of the engine.
Reactivation
The system is reactivated automatically each
time the ignition is switched back on or from 30 mph (50 km/h).
) Press the button again to
reactivate it manuall
y.I
f this warning lamp comes on,accompanied by an audible signaland a message, this indicates a fault
with the system.
Contact a CITRO
Page 235 of 420

233
6
Safety
Seat belt not fastened and
unfastened alerts
Rear seat belts not fastened alert
The instrument panel includes a seat belt not-
fastened warning lamp A as well as an indicator of the location of the non-fastened belts B .
When the system detects a non-fastened or
unfastened seat belt, the warning lamp A comeon as well as the corresponding points in the indicator B.
On switching on the ignition, engine running
or the vehicle at a speed of up to 12 mph
(20 km/h), the warning lamp Aas well as the
corresponding points in the indicator B come
on for about thirty seconds, if one or more rear passengers have not fastened their seat belt.
Seat belts unfastened alert
Front seat belts not fastened
alert
On switching on the ignition, the warninglamp Acomes on, as well as the corresponding points in the indicator B, if the driver and/or
front passenger have not fastened their seat belt. At speeds above 12 mph
(20 km/h), these alerts flash, accompanied by an audible signal for two minutes. After this period, these aler ts remain on fixed, while the front seat belts arenot fastened.
On switching on the ignition, the warninglamp A
remains on, as well as the corresponding points in the indicator B
, if the
driver and/or one or more passengers have notfastened their seat belt.
At speeds above 12 mph (20 km/h), these
alerts flash, accompanied by a message and
an audible signal for two minutes. After this
period, these aler ts remain on fixed, while the seat belts are not fastened.
Page 238 of 420