Page 75 of 420
73
2
Access
Doors
Opening
From outside
)After unlocking the vehicle using theremote control or the Keyless Entry and Starting system, pull the door handle.
From inside
)
Pull the front or rear door lever to open thedoor.
I
f a door is not properly closed:- with the engine running
, this warning lamp and a message
appear in the instrument panel
(type 1) for a few seconds,-when driving(speed above 6 mph (10 km/h)), thiswarning lamp and a message,
accompanied by an audible
signal, appear in the instrument
panel
(type 1 and type 2) for a
few seconds.
Closing
Page 76 of 420
74
Access
Back-up control
Locking the driver's door
)Inser t the integral key in the door lock, then
turn it to the rear.
You can also apply the procedure described for
the passenger doors.
Unlocking the driver's door
)Inser t the integral key in the door lock, then
turn it to the front.
Locking the front and rear passenger doors
)
Open the doors. )
For the rear doors, check that the child lock is not on (see the "Manual child lock" section). )
Inser t the integral key in the latch located
on the edge of the door and turn it aneighth of a turn to the right for the right
hand door, and to the the left for the left
hand door.
Locking is effective when the slot is
horizontal. ) Close the doors and check that the vehicle
has locked correctly from the outside.
Unlocking the front and rear passenger doors
)Pull the interior door opening control.
System allowing the doors to be locked and
unlocked manually in the event of a malfunction
of the central locking system or battery failure.
To ensure complete locking of thevehicle, only disconnecting the batteryinhibits opening of the tailgate from the outside.
Page 77 of 420
75
2
Access
Boot
Opening the tailgate
With the electronic key /
remote control
With the tailgate opening control
) With the vehicle unlocked or with theelectronic key of the Keyless Entry and Star ting system in the zone covered, press
the tailgate control A . )
Raise the tailgate.
)
Make a long press on this button
to release the tailgate. If the
vehicle was locked, this action first unlocks the vehicle. ) Raise the tailgate.
When selective unlocking is activated,the electronic key must be close to the rear of the vehicle.
Closing the tailgate
)
Lower the tailgate using the interior grips. )
Release the grips and press down on the
outside of the tailgate to close it.
If the tail
gate is not properly closed:
The tailgate is not designed to take abicycle carrier.
-engine running
, this warning lamp and a message appear in
the instrument panel (type 1) for
a few seconds,
- vehicle running(speed above6 mph (10 km/h)), this warninglamp and a message appear
in the instrument panel (type 1
and type 2) for a few seconds,
accompanied by an audible
signal.
Page 78 of 420
76
Access
Motorised tailgate
Check that there is enough space to allow for
the movement of the tailgate.
Activation and deactivation of the motorised
tailgate function is done in the "Drivingassistance " menu, then " Vehicle settings
".
This function is deactivated by default.
Tailgate controls
A: Exterior control
B: Interior control
Never place a finger in the tailgatelocking system: risk of a seriousaccident!
The tailgate is not designed to suppor t a bicycle carrier.
When installing a bicycle carrier on atowbar, it is essential to deactivate theautomatic operation.
To avoid the risk of injury, ensure thatthere is no person close to the rear of the vehicle when opening and closing the motorised tailgate. Be careful of rear passengers.
The motorised tailgate has an obstacle detection system that automatically interrupts its operation if it contacts an obstacle (the movement is reversed bya few degrees to allow the tailgate tobe freed).
Page 79 of 420
77
2
Access
Motorised opening
Unlocking and opening the tailgate with the electronic key /
remote control
Unlocking and opening the tailgate with the Keyless Entryand Starting system
Openin
g the tailgate
)
Make a long press on this button.
)Press button Aon the tailgate, with theelectronic key in the area of coverage.
When selective locking is activated, the electronic key must be near the rear of the vehicle.
By default, the tailgate openscompletely or alternatively to the
memorised position.
)After complete unlocking of the vehicle, press control Aon the tailgate.
The instruction is confirmed by an audiblesignal.
Motorised closing
There are two possibilities: )
Press and release the exterior
control A.or
- by pressing one of thesetwo buttons,
The motorised tailgate has an anti-pinch system that interrupts closing if it encounters an obstacle.
Operation of the tailgate can be interrupted at any time:
After interruption of an operation,another press on one of the controlsresumes the movement, with the exception of a press on the remote control button, which only allows opening.
or
- by pressing the exterior control A.
Memorising an opening
position
Where height is restricted (garage with a low
ceiling, ...) it is possible to limit and memorise
the opening angle of the tailgate.
Thi
s memorisation is done as follows:
- open the tailgate to the desired position,
- press button
B
or the exterior control A
for more than 3 seconds.
Memorisation of the maximum opening position of the tailgate is confirmed by an audible signal.
To cancel the memorised position:
- stop t
he tailgate in an intermediate position,
- press button B
or the exterior control A
for more than 3 seconds.
)
Press and then release button B.
Page 80 of 420
78
Access
When opening and closing a motorised tailgatemanually, there is no assistance from gas-filledstruts. Resistance to opening and closing is
therefore entirely normal.
Reinitialising the tailgate
Tailgate release
Unlocking
)Fold back the rear seats to gain access to
the lock from inside the boot. )Insert a small screwdriver into hole Aof thelock to unlock the tailgate. )Move the latch to the left.
Locking after closing
If the fault persists after closing again, the boot
will remain locked. The motorised tailgate can be opened and
closed manually, even if motorisation is
activated.
Precautions in use
In the event of an accumulation of snow on the tailgate, clear the snow before commanding an automatic opening of the tailgate.The formation of ice can block thetailgate and prevent its opening: waituntil the ice melts with the heating of the passenger compartment.When washing the vehicle in anautomatic car wash, don't forget tolock your vehicle to avoid the risk of unexpected opening. Repeated opening and closing of thetailgate can cause overheating of its electric motor, after which opening andclosing will not be possible. Allow 10 minutes for the motor to cool
down before operating the tailgate again.
This operation is necessary where there is no movement - after detection of an obstacle, after connecting or recharging the battery, ... )Open the tailgate by hand, if necessary. )Manually close the tailgate fully.
If the problem persists, contact a CITRO
Page 81 of 420
79
2
Access
For all work on the alarm system,contact a CITROËN dealer or a qualified workshop.
Alarm System which protects and provides a deterrent against theft and break-ins. It provides the following types of monitoring:
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot or the bonnet...
- Interior volumetric
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.
Self-protection function
The system checks for the
disconnection of any of its components. The alarm is triggered if the battery,the button or the wires of the siren aredisconnected or damaged.
Locking the vehicle with full
alarm system
Activation
If an opening (door, boot, bonnet...) is not closed fully, the vehicle is not locked but theexterior perimeter monitoring will be activated
after a delay of 45 seconds, at the same time
as the interior volumetric monitoring.
)Lock the vehicle using the remote control.
)Switch off the ignition and get out of the vehicle.
or )
Lock the vehicle using the "Keyless Entry
and Starting" system.
The monitorin
g system is active: the indicator
lamp in the button flashes once per second and
th
e the direction indicators come on for about
2 seconds.
After an instruction to lock the vehicle lockedusing the remote control or the Keyless Entry
and Starting system, the exterior perimeter
monitoring is activated after a delay of 5 seconds, the interior volumetric monitoring
after 45 seconds.
Page 82 of 420
80
OFF
Access
Locking the vehicle
with exterior
perimeter
monitoring only
Deactivate the interior volumetric monitoringto avoid unwanted triggering of the alarm incertain cases such as:
- leaving a window par tially open,
- washing your vehicle,
- changing a wheel,
Deactivation of the volumetric monitoring
)
Switch of the ignition and within
ten seconds press this button until its indicator lamp is on fixed.
)Get out of the vehicle. )Immediately lock the vehicle using theremote control or the "Keyless Entry and Starting" system.
Only the exterior perimeter protection system is
active: the indicator lamp in the button flashes
once per second.
To be e
ffective, this deactivation must be doneevery time the ignition is switched off.
In the case of automatic locking of the vehicle (which occurs after a period of 30 seconds if a door or the boot is notopened), the monitoring system is not reactivated automatically. To reactivate it, it is necessary to unlock the vehicleand lock it again, using the remote control or the "Keyless Entry and Starting" system.
Deactivation
)Press one of the unlocking buttons on theremote control:
short press
long press
or )Unlock the vehicle using the "Keyless Entryand Starting" system.
The monitoring system is deactivated: the
indicator lamp in the button is off and the
direction indicators flash for about 2 seconds.
