2013 Citroen C4 PICASSO ESP

1
35
Monitoring
instrument panel, by choosing:
- a colour scheme,
- a display mode.
Choosing a colour scheme
It depends on the colour scheme chosen for
the touch screen tablet. To modify it with the
vehicle stationary: ) select the "Configuration
" menu of the
touch screen tablet,
) press the "Color schemes" button,)
choose a colour scheme, )
confirm.
The system restar ts to take account of the
m
odifications to the touch screen tablet
and the instrument panel. Each mode corresponds to the t
ype of
information displa
yed in the configurable area.
Personalisation of
the type 2 instrument panel
Displa
y zones
Whatever the display mode or colour scheme chosen, the instrument panel contains


- a fixed display zone A
with:
●
the speedometer,
●
the warning lamps,
●
the
fuel gauge,
●
the various repeated information and
alert messages.

- a configurable display zone B .



Choosing the display mode



- "DIALS": permanent display of the
trip computer, rev counter and coolant
temperature indicator.
Most of the warnin
g lamps do not have a fixedposition.
The warning and indicator lamps in the lefthand column are displayed from top to bottom
in order of importance.
For cer tain functions that have indicator lamps for both on and off, there is just one dedicated
location.

1
37
Monitoring

- "DRIVING": used for the display of the
inter-vehicle time and information related tothe active cruise control.
The recommended speed is displayed in
the central part.
The driver remains responsible fo
r
observing the driving regulations. To m o d i
fy the display mode of the instrument panel:) turn the wheel on the left of the steering
wheel to display and run through the
different modes in the right hand part of the
instrument panel,
) once the selected display mode appearsin the central window, press the wheel to confirm your choice. )
The new mode is applied immediately.

1
39
Monitoring

Operation indicator lamps

If one of the following indicator lamps comes on in the instrument panel, this confirms that the corresponding system has come into operation.

Warning / indicator lampStateCauseAction / Observations
Left-hand directionindicator
flashing with buzzer. The lighting stalk is pushed down.
Right-hand direction indicator
flashing with buzzer.The lighting stalk is pushed up.
Sidelamps

fixed. The lighting stalk is in the
"Sidelamps" position.
Dipped beamheadlamps fixed. The lighting stalk is in the "Dipped
beam headlamps" position.
Main beam headlamps
fixed. The lighting stalk is pulled towardsyou. Pull the stalk to return to dipped beam headlamps.

40
Monitoring
Automatic headlamp dipping
fixed.The lighting control stalk is in the
"AUTO" position, pulled towardsyou, and the function is activated (" Driving assistance" menu).
The system is in dipped beam modeas there is sufficient ambient lightand/or the traffic conditions do notallow illumination of main beam.The camera, located in the door mirror, mana
ges the
operation of main beam, depending on the ambient
lighting and driving conditions.
Pullin
g the lighting stalk again to deactivate.
For more information on this function, refer to the Visibility section.
fixed.The lighting control stalk is in the
"AUTO" position, pulled towardsyou, and the function is activated (" Driving assistance" menu).
The system is in main beam mode as the ambient lighting and trafficconditions allow it.
Warning / indicator lampStateCauseAction / Observations
Rear foglampsfixed.The rear foglamps are switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamps.
Front foglampsfixed.The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off
the front foglamps.

For more information on the lighting controls, refer to the corresponding section.

1
41
Monitoring
Warning / indicator lampStateCauseAction / Observations
Electric parking brake
fixed. The electric parking brake is applied. Release the electric parking brake to switch off the
warning lamp: with your foot on the brake pedal, brieflypush the electric parking brake control lever.
Obser ve the safety recommendations.
For more information on the electric parking brake,
refer to the corresponding section.
Diesel engine pre-heating
fixed. The "START/STOP" switch has been pressed (ignition on). Wait until the warning lamp goes off before star ting.
Once it goes off, star ting is immediate, on condition
that you maintain pressure on the brake pedal for anelectronic or automatic gearbox, or the clutch pedal is pressed fully down for a manual gearbox.
The period of illumination of the warning lamp is
determined by the ambient conditions (up to about
thirty seconds in extreme conditions).
If the engine does not star t, switch the ignition off and
then on, wait until the warning lamp goes off again,
then start the engine.
Blind spotsensors fixed. The blind spot monitoring function has been activated. For more information, refer to the correspondingsection.
Park Assist fixed. The Park Assist function has beenactivated. For more information, refer to the correspondingsection.

1
43
Monitoring
Deactivation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has been switched off intentionally.
This is may be accompanied by an audible signal and the display of a message.

Warning / indicator lampStateCauseAction / Observations
Passenger's airbag system
fixed. The control switch, located at the
right hand end of the dashboard is set
to the OFFposition.
The passen
ger's front airbag is deactivated.
Set the control to the "ON"position to activate the passenger's front airbag.
In this case, do not fit a child seat in the rear ward-
facing position.
Dynamic stability control(DSC/ASR)R

fixed. The button, located on the centre console, is pressed. Its indicator lamp is on.
The DSC/ASR is deactivated.
DSC: dynamic stability control.
ASR: anti-slip regulation. Press the button to activate the D
SC/ASR. Its indicator
lamp goes off.
The DSC/ASR system is activated automatically when
the vehicle is started.
If deactivated, the system is reactivated automaticallyfrom around 30 mph (50 km/h).
Stop & Start
fixed. The Stop & Star t has been
deactivated. R
eactivate the function via the " Driving assistance"
menu.

46
Monitoring
Warning / indicator lampStateCauseAction / Observations
Deactivation of the automatic functions of the electric parkingbrake
fixed. The "automatic application" (onswitching off the engine) and
"automatic release" functions aredeactivated or faulty.
In the event of a fault, illumination of
this warning lamp is accompanied bya message.To reactivate the automatic
functions, refer to the"Electric parking brake" section.
Contact a CITROËN dealer or a qualified workshop if
automatic application / release is not possible.
The parking brake can be released manually.
For more information on the electric parking brake,
refer to the corresponding section.
Electric parking brakeflashing.When driving: the electric parking
brake is not fully released.Fully release the parking brake by a quick press on thecontrol lever. If the warning persist, stop as soon as it
is safe to do so.
Contact a CITROËN dealer or a qualified workshop.
When stationary: parking brake applied, the system does guarantee
immobilisation of the vehicle (whenparking on a very steep slope, for example).
Secure the immobilisation of the vehicle by engaginga gear with a manual or electronic gearbox, by placing
the gear selector in positionPwith an automatic gearbox, or by fitting a chock to one of the wheels.
Electric parking brake faultfixed.The electric parking brake has a fault. Contact a CITROËN dealer or a qualified workshop
without delay.
The parking brake can be released manually.
For more information on the electric parking brake,
refer to the corresponding section.

83
2
Access
Reinitialisation of the
electric windows

Deactivating the rear controls for the rear windows

In the event of contact during operationof the windows, you must reverse themovement of the window. To do this,press the switch concerned.
When operating the passenger electricwindow switches, the driver mustensure that nothing is preventingcorrect closing of the windows.
The driver must ensure that the passengers use the electric windows correctly.
Be aware of children when operatingthe windows.
Be aware of passengers or other persons present when closing thewindows using the the electronic key or the "Keyless Entry and Starting" system.
Followin
g reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch function is not active
during these operations. For the safety of your children, pressswitch 5to prevent operation of the rear windows irrespective of their positions.
The warnin
g lamp in the button comes on,
accompanied by a message confirmingactivation. It remains on, as long as the childlock is deactivated.
Use of the rear electric windows from thedriver's controls remains possible.F
or each window:
- lower the window completely, then raise it,
it will rise in steps of a few centimetres with each action. Repeat the operation until the
window closes completely,
- continue to
pull the switch for at least one second after reaching this position, windowclosed.