2013 Citroen C3 RHD start stop button

.Familiarisation
19

Stop & Start


Going into engine STOP mode
The "ECO"warning lamp comes
on in the instrument panel and the
engine goes into standby:
-with a manual gearbox; at speeds below
12 mph (20 km/h), when you put the gear
lever into neutral and you release the clutch pedal.

-
with a 5 or 6 speed electronic gearbox
: at speeds below 5 mph (8 km/h), when you press the brake pedal or when you put thegear lever into position N.

In certain circumstances, STOP may not be
available; the "ECO"
warning lamp flashes for
a few seconds, then goes off.
Going into engine START mode
The "ECO"
warning lamp goes off
and the engine restarts:
-with a manual gearbox : when youdepress the clutch pedal.
-with a 5 or 6 speed electronic gearbox:


●
gear lever in position A
or M, when you
release the brake pedal,

●
or gear lever in position N
and brake pedal
released, when you select position A or AM ,

●
or when you engage reverse.

In certain circumstances,
START mode may beinvoked automatically; the "ECO"
warning lamp
flashes for a few seconds, then goes off.

Deactivation / Reactivation
You can deactivate the system at any time bypressing the "ECO OFF"
button; the warninglamp in the button comes on.

Driving safely
127

128

128
, 129

The system is reactivated automatically every time the engine is star ted withwith the key.

Before refuelling or doing anything under the bonnet, you must switch off the ignition with the key.

1
Monitoring
31
Warning lampis onCauseAction / Observations
Anti-lockBraking System(ABS)

fixed. The anti-lock braking system has a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact aCITROËN dealer or a qualified workshop without delay.
Dynamic stability control(ESP/ASR)

flashing.The ESP/ASR regulation is active. The system optimises traction and improves the
directional stability of the vehicle.

fix
ed. Unless it has been deactivated (button pressed and its indicator lamp
on) the ESP/ASR system has a fault. Have it checked b
y a CITROËN dealer or a qualified
workshop.
Engine autodiagnosis system
flashing. The engine management system hasa fault. Risk of destruction of the catalytic conver ter.
Have it checked by a CITROËN dealer or a qualified
workshop.

fix
ed. The emission control system has a
fault. The warning lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or qualified workshop without delay.
Braking

fixed, associated with
the STOP warning
lamp. The braking system fluid level is too
low. You must stop as soon as it is safe to do so.
Top up with brake fluid recommended by CITROËN.
If the problem persists, have the system checked by a
CITROËN dealer or a qualified workshop.

+
fixed, associated with
the
STOP and ABS
warning lamp. Th
e electronic brake force distribution(EBFD) system has a fault. You must stop as soon as it is safe to do so.
Have it checked by a CITROËN dealer or a qualified
workshop.

1
Monitoring
41





Monochrome screen C
16/9 colour screen
(eMyWay)


Information displays
)Press the button, located at the end of
the wiper stalk
, to display the various tripcomputer tabs in succession:- th
e current information tabwith:
●
the ran
ge,
●
the current fuel consumption,
●
the distance remaining to
be travelled or the Stop &Start time counter,
- the trip "1"
t
ab with:
●
the distance travelled,
●
the avera
ge fuelconsumption,
●
the average speed,for the first trip.
- the tri
p "2"tab with:
●
the distance travelled,
●
the avera
ge fuelconsumption,
●
the average speed,
for the second trip.

)
Pressing the button again returns you to
the normal display.
Trip zero reset
)
When the trip required is displayed, press
the button on the end of the wiper stalk for more than two seconds.
Tr ips "1"
and "2"are independent but their use
is identical.
For example, trip "1"can be used for daily
figures, and trip "2"for monthly figures.

Driving
118





Parking brake
Applying
)Pull the parking brake lever fully up toimmobilise your vehicle.

Releasing
)Pull the parking brake lever gently, press
the release button then lower the lever fully.
When the vehicle is bein
g driven,
if this warning lamp and the STOPwarning lamp come on, accompanied by an audible signal and a message
on the multifunction screen, this indicates that the parking brake is still
on or has not been properly released.








6-speed manual
gearbox

Engaging 5th
or 6th
gear
)
Move the lever fully to the right to engage 5th or 6th gear.
)Raise the ring under the knob and move
the gear lever to the left then forwards.


Engaging reverse gear
Only engage reverse gear when the vehicle is stationary with the engine at idle.

As a safety precaution and to facilitate starting of the engine:


- always select neutral,

- press the clutch pedal.

When parking on a slope, direct your wheels against the pavement, apply the parking brake and engage a gear.

Failure to follow this advice may cause permanent damage to the gearbox (engagement of 3rdor 4thgear bymistake).

274
QUESTIONANSWERSOLUTION
The stored stations do not function (no sound,87.5 Mhz is displayed...).

An incorrect waveband is selected.
Press the BAND AST button to return to thewaveband (AM, FM1, FM2, FMAST) on which the stations are stored.

The traffi c announcement(TA) is displayed. I do not receive any traffi c information.
The radio station is not part of the regional traffi c information network.
Tune to a radio station which broadcasts traffi c information.

The quality of reception of the radio station listened to gradually deterioratesor the stored stations donot function (no sound,87.5 Mhz is displayed...).
The vehicle is too far from the transmitter used by the station listened to or there is no transmitter in the geographical area through which the vehicle is travelling.
Activate the RDS function to enable the system tocheck whether there is a more powerful transmitter in the geographical area.
The environment (hills, buildings, tunnels, basement car parks...) block reception, including in RDS mode. This phenomenon is normal and does not indicate a failure of the audio equipment.
The aerial is absent or has been damaged (for example when goingthrough a car wash or into an underground car park).
Have the aerial checked by a CITROËN dealer.
Sound cut-outs of 1 to 2 seconds in radio mode. During this brief sound cut-out, the RDS searches for any frequencypermitting better reception of the station.
Deactivate the RDS function if the phenomenon istoo frequent and always on the same route.

With the engine off, theaudio equipment switches off after a few minutesof use.
When the engine is switched off, the audio equipment operating time depends on the battery charge.
The switch-off is normal: the audio equipment switches to economy modeand switches off to prevent discharging of the vehicle's battery.
Start the vehicle's engine to increase the battery charge.
The message "the audio system is overheated" appears on the display.
In order to protect the installation if the surrounding temperature is too high,the audio equipment switches to an automatic thermal protection mode leading to a reduction of the volume or stopping of the playing of the CD.
Switch the audio system off for a few minutes to allow the system to cool.