2013 Citroen C3 PICASSO wipers

.Familiarisation
13

Lighting

Ring A

Ring B
Raise or lower the lighting stalk passing thepoint of resistance; the corresponding directionindicators will flash for as long as the stalkremains in this position.
Direction indicators


Switching on "AUTO" mode
)Press the stalk down and release it.


Ring B: rear wiper
8188 Li
ghting off.
Automatic illumination of headlamps.
Sidelamps.
Dipped / main beam headlamps.
Rear
foglamp.

or
Front and rear
foglamps. P
ark.
Intermittent wipe.
Wash-wi
pe.

Control stalk A: windscreen wipers


Wipers


Switching off "AUTO" mode
)
Push the stalk up and return it to position "0".
114
"Motorway" function
Press the lighting stalk up or down once,without passing the point of resistance; thecorresponding direction indicators will flash
three times.
You can use this function at any speed, but it is particularly useful when changing lane on high-
speed roads.
Seeing clearly
87
89
80

5
Visibility
83
Linked with the Guide-me-home lighting
Association with the automatic illumination
of headlamps provides the guide-me-home lighting with the following additional options:
- automatic activation of guide-me-home lighting when automatic illumination of
headlamps is switched on (in the vehicle
parameters of the multifunction screen configuration menu),
- selection of the duration of maintaining of
the lighting for 15, 30 or 60 seconds in the
vehicle parameters of the multifunction
screen configuration menu (except for monochrome screen Awhere this is
preset).



Operating fault

In the event of a malfunction of
the sunshine sensor, the lamps
come on, this warning lamp is
displayed in the instrument panel and/or a
message appears in the multifunction screen,
accompanied by an audible signal.
Contact a CITROËN dealer or a qualified
workshop.
In fog or snow, the sunshine sensor maydetect sufficient light. Therefore, the lamps will not come on automatically.
Do not cover the sunshine sensor,linked with the rain sensor and located in the centre of the windscreen behindthe rear view mirror; the associatedfunctions would no longer be controlled.

Automatic illumination of
headlamps
The sidelamps and dipped beam headlamps are switched
on automatically, without any action on the par t of the
driver, when a low level of external light is detected or incer tain cases of activation of the windscreen wipers.
As soon as the brightness returns to a sufficient level or
after the windscreen wipers are switched off, the lamps
are switched o
ff automatically.
Activation
)Turn ring Ato the A"AUTO"
position. The automatic
illumination of headlamps is accompanied by a message in the multifunction screen.


Deactivation
)Turn ring A
to a position other
than "AU TO "
. Deactivation is accompanied
b
y a message in the multifunction screen.

5
Visibility
87








Wiper controls

Manual controls
The wiper commands are issued directly by the
driver by means of the stalk Aand the ring B.
Model with intermittent wiping
Model with AUTO wiping
Fast (heavy rain).
Normal
(moderate rain).
Intermittent
(proportional to the
speed of the vehicle).

Automatic, then single wipe
(see
the corresponding section).
Off.

Sin
gle wipe (press down and release).
Programming
Various automatic wiper control modes are also
available according to the following options:


- automatic rain sensitive windscreen wipers,

- rear wiping on engaging reverse gear.



Windscreen wipers
A.Wiping speed selection stalk.
or
S
ystem for selection and control of the various
front and rear wiping modes for the elimination
of rain and cleaning.
The vehicle's front and rear wipers are
designed to improve the driver's visibility progressively according to the climaticconditions.

Visibility
88
Windscreen wash
Pull the wiper stalk towards you. The
windscreen wash, then the windscreen wipers,
operate for a pre-determined time. B
. Rear wiper selection ring:
park,
intermittent wi
pe,
wash-wipe
(set duration).


Reverse gear

When reverse gear is engaged, the rear wiper
will operate if the windscreen wipers are
operatin
g.


Programming

The function is activated or deactivated via the
multifunction screen configuration menu.
This function is activated by default.
Rear wiper
Wiping zone

The cur ved shape of the rear screen results in
a smaller wiping zone.


If a significant accumulation of snow or ice is present, or when using a tailgate bicycle carrier, deactivate the automatic rear wiper via the multifunction screenconfiguration menu.

5
Visibility
89
Vertical windscreen wiper
position Automatic rain sensitive
windscreen wipers
The windscreen wipers operate automatically,
without any action on the par t of the driver, if
rain is detected (sensor behind the rear view mirror), adapting their speed to the intensity of
the rainfall.
Activation

This is controlled manually by the driver bypushing the stalk downwards to the "AU TO "position.
It is accompanied by a message in the screen. This position allows the wiper blades to be lifted
for winter parking, cleaning or replacement
without damaging the bonnet.
In the minute following switching off of the
ignition, any action on the wiper stalk positions
the wipers ver tically.
To park the wipers after this has been done,
switch on the ignition and operate the wiper stalk.


Switching off
This is controlled manually by the driver bymoving the stalk upwards then returning it to position "0".
Operating fault
If an automatic wiping malfunction occurs, the wipers will operate in intermittent mode.
Have it checked by a CITROËN dealer or aqualified workshop.
It is accompanied by a message in the screen.The automatic rain sensitive wipers must be reactivated if the ignition has been off for more than one minute, by pushing the stalk downwards.
Do not cover the rain sensor, linked withthe sunshine sensor and located in thecentre of the windscreen behind the rear view mirror. Switch off the automatic rain sensitive wipers when using an automatic car wash. In winter, to avoid damaging the wiper
blades, it is advisable to wait until thewindscreen is completely clear of icebefore activating the automatic rain sensitive wipers.

To retain the effectiveness of the "flat-
blade" wiper blades, it is advisable to:


- handle them with care,

- clean them regularly using soapywater,

- not use them to hold a sheet of cardboard against the windscreen,

- replace them at the first signs of wear.

Practical information
178
Fuse N°RatingFunctions
F1230 A Windscreen wipers slow / fast speed.
F13
40 A Built-in systems inter face supply (ignition positive).
F14
30 A Valvetronic supply (petrol).
F1
510 A Right-hand main beam headlamp.
F1
610 A
Left-hand main beam headlamp.
F17 15 A
Left-hand dipped beam headlamp.
F18 15 A
Ri
ght-hand dipped beam headlamp.
F1
915 A Multifunction engine management supply (petrol engine),
air cooling electrovalves (Diesel).
F20 10 A Multi
function engine management supply (petrol engine),
Turbo pressure regulation electrovalve (Diesel), engine coolantlevel sensor (Diesel).
F2
15 A Fan assembly control supply, APC, ABS ESP relays.

Practical information
182








Energy economy mode

These functions are reactivated automaticallythe next time the vehicle is driven. )In order to resume the use of these
functions immediately, star t the engine and
let it run for a few minutes.
The time available to you will then be double
the period for which the engine is left running. However, this period will always be betweenfive and thir ty minutes.

Switching to economy mode
Once this period has elapsed, a message
appears on the multifunction screen indicating
that the vehicle has switched to economy mode
and the active functions are put on standby.
A flat battery prevents the engine from starting (refer to the corresponding paragraph).
If the telephone is being used at the same time on the eMyWay audionavigation system, it will be interrupted after 10 minutes. S
ystem which manages the period of use of certain functions to conserve a sufficient level
of charge in the battery.
After the engine has stopped, you can still use functions such as the audioequipment, windscreen wipers, dipped
beam headlamps, cour tesy lamps, etc. for a maximum combined period of thirty minutes.
This period may be greatly reduced if the
battery is not fully charged.

247
11
2
3
3
1
4
2
2
1
4
4
2
2
Night mode

Auto Day/Night

Ad
just luminosity


Set date and time


"SETUP" MENU
Displa
y configuration


Choose colour
Harmon
y
Cartography
Day mode

Voice synthesis


Guidance instructions volume

Select male voice / Select female voice
2

Select units
SCREEN MENU MAP
2
3
3
2

Lighting confi guration
Parkin
g assistance
En
gage rear wiper in REVERSE
Duration of guide-me home lighting
1
Define vehicle parameters *
2

Operation of wipers
3Directional headlamps
3Mood lighting
3Daytime running lamps
* The parameters var
y according to the vehicle.
2

Alert log
1
Trip computer
2

Status of functions